Home Influence of Blending Protocol on the Thermal and Mechanical Properties of HDPE/LLDPE Blend-Based Nanocomposites
Article
Licensed
Unlicensed Requires Authentication

Influence of Blending Protocol on the Thermal and Mechanical Properties of HDPE/LLDPE Blend-Based Nanocomposites

  • F. R. Passador , A. C. Ruvolo-Filho and L. A. Pessan
Published/Copyright: July 21, 2016
Become an author with De Gruyter Brill

Abstract

Nanocomposites based on high density polyethylene (HDPE)/linear low density polyethylene (LLDPE) blend were prepared by melt compounding in a twin-screw extruder using an organoclay (montmorillonite) as nano-filler and maleic anhydride-grafted linear low density polyethylene (LLDPE-g-MA) as compatibilizer. The effects of two blending protocols were also investigated. In the first blending protocol LLDPE and LLDPE-g-MA were first reinforced with organoclay and then this nanocomposite was later blended with HDPE, and the second blending protocol LLDPE-g-MA was mixed with organoclay first and then this masterbatch was diluted with HDPE and LLDPE. The preparation of the masterbatch resulted in the degradation of polyethylene, with crosslinking formation which increase the viscosity of the polymer and facilitated the dispersion of the organoclay in the polymeric matrix. WAXD and TEM were used to determine the effect of blending protocol and organoclay content on the intercalation and mechanical properties. The introduction of a maleated polyethylene was required to improve the organoclay dispersion in the nanocomposites. Thermal and mechanical properties of the nanocomposites were affected by blending protocols and the content of organoclay. The degree of crystallinity of the materials prepared using the first blending protocol decreased upon the intercalation of clay platelets whereas for the materials obtained using the second blending protocol the degree of crystallinity decreased due the crosslinking which further restricted mobility and diffusion of polymer chains. The nanocomposites show higher values of tensile modulus, flexural modulus and HDT compared to the blend without the addition of organoclay. The OMMT content added to the polymer blend results in significant and well correlated improvements in tensile and flexural moduli.


*Correspondence address, Mail address: Fabio R. Passador, Federal University of São Paulo, Department of Science and Technology, Talim, 330, São José dos Campos, SP, Brazil, 12231-280. E-mail:

References

Alexandre, M., Dubois, P., “Polymer-Layered Silicate Nanocomposites: Preparation, Properties and Uses of a New Class of Materials”, Mat. Sci. Eng., 28, 163 (2000) 10.1016/S0927-796X(00)00012-7Search in Google Scholar

Choi, P., “Molecular Dynamics Studies of the Thermodynamics of HDPE/Butene-Based LLDPE Blends”, Polymer, 41, 87418747 (2000) 10.1016/S0032-3861(00)00279-2Search in Google Scholar

Dasari, A., Yu, Z. Z. and Mai, Y. W., “Effect of Blending Sequence on Microstructure of Ternary Nanocomposites”, Polymer, 46, 59865991 (2005) 10.1016/j.polymer.2005.05.145Search in Google Scholar

Durmus, A., Woo, M., Kasgoz, A., Macosko, C. W. and Tsapatsis, M., “Intercalated Linear Low Density Polyethylene (LLDPE)/Clay Nanocomposites Prepared with Oxidized Polyethylene as a New Type Compatibilizer: Structural, Mechanical and Barrier Properties”, Eur. Polym. J., 43, 37373749 (2007) 10.1016/j.eurpolymj.2007.06.019Search in Google Scholar

Durmus, A., Kasgoz, A. and Macosko, C. W., “Linear Low Density Polyethylene (LLDPE)/Clay Nanocomposite. Part I: Structural Characterization and Quantifying Clay Dispersion by Melt Rheology”, Polymer, 48, 44924502 (2007) 10.1016/j.polymer.2007.05.074Search in Google Scholar

Fornes, T. D., Yoon, P. J., Keskkula, H. and Paul, D. R., “Nylon 6 Nanocomposites: The Effect of Matrix Molecular Weight”, Polymer, 42, 99299940 (2001) 10.1016/S0032-3861(01)00552-3Search in Google Scholar

Gopakumar, T. G., Lee, J. A., Kontopoulou, M. and Parent, J. S., “Influence of Clay Exfoliation on the Physical Properties of Montmorillonite/Polyethylene Composites”, Polymer, 43, 54835491 (2002) 10.1016/S0032-3861(02)00403-2Search in Google Scholar

Hasegawa, N., Okamoto, H., Kawasumi, M., Kato, M., Tsukigase, A. and Usuki, A., “Polyolefin-clay Hybrids Based on Modified Polyolefins and Organophilic Clay”, Macromol. Mater. Eng., 280, 7679 (2000) 10.1002/1439-2054(20000801)280:1<76::AID-MAME76>3.0.CO;2-#Search in Google Scholar

Hotta, S., Paul, D. R., “Nanocomposites Formed from Linear Low Density Polyethylene and Organoclays”, Polymer, 45, 76397654 (2004) 10.1016/j.polymer.2004.08.059Search in Google Scholar

Hussein, I. A., “Influence of Composition Distribution and Branch Content on the Miscibility of m-LLDPE and HDPE Blends: Rheological Investigation”, Macromolecules, 36, 20242031 (2003) 10.1021/ma0257245Search in Google Scholar

Ishida, H., Campbell, S. and Blackwell, J., “General Approach to Nanocomposite Preparation”, Chem. Mat., 12, 12601267 (2000) 10.1021/cm990479ySearch in Google Scholar

Kajiyama, T., Okada, T., Sakoda, A. and Takayanagi, M., “Analysis of the α-Relaxation Process of Bulk Crystallized Polyethylene Based on that of Single Crystal Mat”, J. Macromol. Sci., Part B: Phys., 7, 583608 (1973) 10.1080/00222347308207887Search in Google Scholar

Kyu, T., Yasuda, N., Suehiro, S., Nomura, S. and Kawai, H., “Dynamic Birefringence Behavior of Semicrystalline Polymers. II. The Crystalline Relaxation Mechanisms of Low- and Medium-Density Polyethylenes”, Polym. J., 8, 565584 (1976) 10.1295/polymj.8.565Search in Google Scholar

Liu, C., Wang, J. and He, J., “Rheological and Thermal Properties of m-LLDPE Blends with m-HDPE and LDPE”, Polymer, 43, 38113818 (2002) 10.1016/S0032-3861(02)00201-XSearch in Google Scholar

Martins, C. G., Larocca, N. M., Paul, D. R. and Pessan, L. A., “Nanocomposites Formed from Polypropylene/EVA Blends”, Polymer, 50, 17431754 (2009) 10.1016/j.polymer.2009.01.059Search in Google Scholar

Morawiec, J., Pawlak, A., Slouf, M., Galeski, A., Piorkowska, E. and Kraskikowa, N., “Preparation and Properties of Compatibilized LDPE/Organo-Modified Montmorillonite Nanocomposites”, Eur. Polym. J., 41, 11151122 (2005) 10.1016/j.eurpolymj.2004.11.011Search in Google Scholar

Nitta, K. H., Tanaka, A., “Dynamic Mechanical Properties of Metallocene Catalyzed Linear Polyethylenes”, Polymer, 42, 12191226 (2001) 10.1016/S0032-3861(00)00418-3Search in Google Scholar

Passador, F. R., Ruvolo-Filho, A. and Pessan, L. A., “Effect of Blending Protocol on the Rheological Properties and Morphology of HDPE/LLDPE Blend-Based Nanocomposites”, Int. Polym. Proc., 27, 378385 (2012) 10.3139/217.2567Search in Google Scholar

Passador, F. R., Ruvolo-Filho, A. and Pessan, L. A., “Effects of Different Compatibilizers on the Rheological, Thermomechanical and Morphological Properties of HDPE/LLDPE Blend-Based Nanocomposites”, J. Appl. Polym. Sci., 130, 17261735 (2013) 10.1002/app.39265Search in Google Scholar

Quental, A. C., Felisberti, M. I., “Phase Behavior of Blends of Linear Low Density Polyethylene and Poly(ethene-propene-1-butene)”, Eur. Polym. J., 41, 894902 (2005) 10.1016/j.eurpolymj.2004.11.033Search in Google Scholar

Ryu, S. H., Chang, Y. W., “Factors Affecting the Dispersion of Montmorillonite in LLDPE Nanocomposite”, Polym. Bull., 55, 385392 (2005) 10.1007/s00289-005-0437-7Search in Google Scholar

Scobbo, J. J., “Chapter 5 Thermo-Mechanical Performance of Polymer Blends”, in Polymer Blends, Paul, D. R., Bucknall, C. B. (Eds.), Academic Press, New York, p. 335 (2000)Search in Google Scholar

Spencer, M. W., Cui, L., Yoo, Y. and Paul, D. R., “Morphology and Properties of Nanocomposites Based on HDPE/HDPE-g-MA Blends”, Polymer, 51, 10561070 (2010) 10.1016/j.polymer.2009.12.047Search in Google Scholar

Wang, K. H., Choi, M. H., Koo, C. M., Choi, Y. S. and Chung, I. J., “Synthesis and Characterization of Maleated Polyethylene/Clay Nanocomposites”, Polymer, 42, 98199826 (2001) 10.1016/S0032-3861(01)00509-2Search in Google Scholar

Wang, K. I., Choi, M. H., Koo, C. M., Xu, M., Chung, I. J., Jang, M. C., Choi, S. W. and Song, H. H., “Morphology and Physical Properties of Polyethylene/Silicate Nanocomposite Prepared by Melt Intercalation”, J. Polym. Sci. Pat. B: Polym. Phys., 40, 14541463 (2002) 10.1002/polb.10201Search in Google Scholar

Wunderlich, B.: Macromolecular Physics, 3rd Edition, Academic Press, New York (1980)Search in Google Scholar

Received: 2016-01-07
Accepted: 2016-04-16
Published Online: 2016-07-21
Published in Print: 2016-08-12

© 2016, Carl Hanser Verlag, Munich

Articles in the same Issue

  1. Contents
  2. Contents
  3. Regular Contributed Articles
  4. Structural and Antibacterial Properties of PP/CuO Composite Filaments Having Different Cross Sectional Shapes
  5. Effects of Accelerated Weathering in Polylactide Biocomposites Reinforced with Microcrystalline Cellulose
  6. Using Forest Resources to Develop High Performance Plastic Compounds for the Automotive Industry
  7. Coagent Modified Polypropylene Prepared by Reactive Extrusion: A New Look into the Structure-Property Relations of Injection Molded Parts
  8. Numerical Simulation of the Injection Blow Molding Single Stage Process: Shaping of Two Different Geometries and Comparison with Experimental Thickness Measurements
  9. Effects of Montmorillonite Content and Maleic Anhydride Compatibilization on the Mechanical Behavior of Polylactide Nanocomposites
  10. Effect of Coupling Agent and Ground Tire Rubber Content on the Properties of Natural Fiber Polymer Composites
  11. Influence of Blending Protocol on the Thermal and Mechanical Properties of HDPE/LLDPE Blend-Based Nanocomposites
  12. Effect of Brominated Epoxy Resins on the Thermal Stability and Flame Retardancy of Long-Glass-Fiber Reinforced Polyamide 6
  13. Machining Optimization of HDPE Pipe Using the Taguchi Method and Grey Relational Analysis
  14. Evaluation and Optimization of Electrospun Polyvinyl Alcohol Fibers via Taguchi Methodology
  15. Matrix Degradation during High Speed Extrusion of Polypropylene/Clay Nanocomposites – Influence on Filler Dispersion
  16. Processing of Metallic Pigments in a Co-Rotating Twin-Screw Extruder Studied by Means of Dielectric Analysis and Terahertz Spectroscopy
  17. PPS News
  18. PPS News
  19. Seikei Kakou Abstracts
  20. Seikei-Kakou Abstracts
Downloaded on 22.11.2025 from https://www.degruyterbrill.com/document/doi/10.3139/217.3238/html
Scroll to top button