Article
Licensed
Unlicensed
Requires Authentication
Generalized Flow of Ellis Fluid in the Screw Channel
Part I: Parallel Plates Model
-
R. T. Steller
Published/Copyright:
June 5, 2013
Abstract
Analytical expressions for the isothermal, two-dimensional flow of an Ellis fluid in rectangular channel have been derived. The obtained solution describes also the flow of Newtonian and power law fluids as the specific cases. This solution was further adapted for the theoretical analysis of the temperature and pressure effects during the non-isothermal flow of Ellis fluid. The results obtained both for isothermal and non-isothermal flow conditions have been verified numerically.
Received: 2001-2-26
Accepted: 2001-6-15
Published Online: 2013-06-05
Published in Print: 2001-09-01
© 2001, Carl Hanser Verlag, Munich
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Editorial
- Tenth of a Series: Pioneer of The Polymer Thermoset Industry – Leo-Hendrik Baekeiand
- Screw Extrusion
- Effects of Process Conditions on the Dissolution of Carbon Dioxide in PS in Foaming Extruders
- The Design of Extrusion Screws: An Optimization Approach
- Generalized Flow of Ellis Fluid in the Screw Channel
- Generalized Flow of Ellis Fluid in the Screw Channel
- Experimental Study of Melting in an Intermeshing Counter-Rotating Twin Screw Extruder
- Reactive Extrusion
- A Dynamic Model for Multiple Steady States in Reactive Extrusion
- Fiber and Film
- PA612 Double Bubble Tubular Film Process – Processability and Structure Development
- Injection Molding
- Injection Molding Technology for High Speed Optical Disk
- Three-dimensional Filling and Post-filling Simulation of Polymer Injection Molding
- Cold Rolling
- Microstructure and Prediction of Stress-strain Behaviour of Cold-rolled PP Sheets
Articles in the same Issue
- Editorial
- Tenth of a Series: Pioneer of The Polymer Thermoset Industry – Leo-Hendrik Baekeiand
- Screw Extrusion
- Effects of Process Conditions on the Dissolution of Carbon Dioxide in PS in Foaming Extruders
- The Design of Extrusion Screws: An Optimization Approach
- Generalized Flow of Ellis Fluid in the Screw Channel
- Generalized Flow of Ellis Fluid in the Screw Channel
- Experimental Study of Melting in an Intermeshing Counter-Rotating Twin Screw Extruder
- Reactive Extrusion
- A Dynamic Model for Multiple Steady States in Reactive Extrusion
- Fiber and Film
- PA612 Double Bubble Tubular Film Process – Processability and Structure Development
- Injection Molding
- Injection Molding Technology for High Speed Optical Disk
- Three-dimensional Filling and Post-filling Simulation of Polymer Injection Molding
- Cold Rolling
- Microstructure and Prediction of Stress-strain Behaviour of Cold-rolled PP Sheets
