PPS News

Artikel in diesem Heft

1. Contents
2. Contents
3. Invited Papers
4. Simha-Somcynsky Equation of State Modeling of the PVT Behavior of PP/Clay-Nanocomposite/CO₂ Mixtures
5. Regular Contributed Articles
6. Effect of Pre-Molding Process and Additive of Injection Molded Wood/PP Composites
7. Flame Retarded PE with MH/ATH/Microencapsulated Red Phosphorous and its Toughening by Polymeric Compatibilizers
8. The Porous Structure and Mechanical Properties of Injection Molded HA/PA66 Scaffolds
9. A Gas-Sensor-Based Measurement Setup for Inline Quality and Process Control in Polymer Extrusion
10. Extrusion and Characterization of Soy Protein Film Incorporated with Soy Cellulose Microfibers
11. Development of Composites of Highly Filled Phenol Formaldehyde Resin – Coconut (Cocos nucifera) Endocarp Particles
12. Structural Analysis Examining the Mold Deformation Behavior for the Detection of the Flash in the Injection Mold
13. Epoxidized Esters of Palm Kernel Oil as an Effective Plasticizer for PVC: A Study of Mechanical Properties and Effect of Processing Conditions
14. Injection Molding of Beverage Container Caps Made of a Composite Consisting of Wood Cellulose Fiber and an Ethylene-Acrylic Acid Copolymer
15. Study on Pumping Conveying Capacity Characteristics of Polymer Solids in Vane Extruder
16. Morphology Control and Stabilization in Immiscible Polypropylene and Polyamide 6 Blends with Organoclay
17. Optimization of Abrasive Water Jet Turning Parameters for Machining of Low Density Polyethylene Material Based on Experimental Design Method
18. PPS News
19. PPS News
20. Seikei Kakou Abstracts
21. Seikei Kakou Abstracts