Article

Determining the Uncertainty in Measuring Length in Light and Scanning-Electron Microscopy

B. Meyer , G. Horn-Samodelkin and F. Pietschmann

Published/Copyright: May 23, 2013

Published by

Become an author with De Gruyter Brill

Submit Manuscript Author Information

Practical Metallography

From the journal Practical Metallography Volume 49 Issue 4

Received: 2010-5-27

Accepted: 2011-8-30

Published Online: 2013-05-23

Published in Print: 2012-04-01

© 2012, Carl Hanser Verlag, München

You are currently not able to access this content.

You are currently not able to access this content.

Articles in the same Issue

Contents/Inhalt
Contents
Editorial
Editorial
Technical Contributions/Fachbeiträge
Determining the Uncertainty in Measuring Length in Light and Scanning-Electron Microscopy
Examination of the Mg-Zn Phase Formation in Hot-Dip Galvanized Steel Sheet
An Investigation into Porosity in Medical Drills Caused by Broken Carbides
Practical Test on Brass Valves Using the 5% Ammonia Test to Elucidate the Reasons of Specific Failure Patterns of Stress Corrosion Cracking SCC
Meeting Diary/Veranstaltungskalender
Meeting Diary

https://doi.org/10.3139/147.110107

Articles in the same Issue

Contents/Inhalt
Contents
Editorial
Editorial
Technical Contributions/Fachbeiträge
Determining the Uncertainty in Measuring Length in Light and Scanning-Electron Microscopy
Examination of the Mg-Zn Phase Formation in Hot-Dip Galvanized Steel Sheet
An Investigation into Porosity in Medical Drills Caused by Broken Carbides
Practical Test on Brass Valves Using the 5% Ammonia Test to Elucidate the Reasons of Specific Failure Patterns of Stress Corrosion Cracking SCC
Meeting Diary/Veranstaltungskalender
Meeting Diary

Institutional Access

How does access work?

Downloaded on 12.2.2026 from https://www.degruyterbrill.com/document/doi/10.3139/147.110107/html