Article
Open Access
Dynamic fragmentation and spheroidization of α phase grains during hot deformation of Ti-6Al-4V alloy
Paper presented at the “XIII Scientific Conference on Titanium and Titanium Alloys 2017”, 24–27 September 2017, Janów Podlaski, Poland
-
Maciej Motyka
Published/Copyright:
July 27, 2018
Received: 2017-10-03
Accepted: 2018-03-02
Published Online: 2018-07-27
Published in Print: 2018-08-10
© 2018, Carl Hanser Verlag, München
Articles in the same Issue
- Contents
- Contents
- Original Contributions
- Dynamic fragmentation and spheroidization of α phase grains during hot deformation of Ti-6Al-4V alloy
- Formation and characterization of hot tearing in AZ series alloys
- The effect of quench-aging on the mechanical properties of Zn-27Al-1Cu alloy
- Microstructural and mechanical properties of novel β-type Ti–Nb–Ni alloys containing a second phase
- Microstructure evolution mechanisms of undercooled Ni80Cu20 alloys
- Microstructures and tensile properties of CuZrAlNb metallic glass composites under different cooling rates
- Influence of a rare-earth element on the solidification behaviour and mechanical properties of undercooled Al–Si alloys
- Microstructure of aluminide coatings on Ti6Al4V alloy produced by the slurry method with inorganic binder
- Ultrathin SnO2 nanorod/reduced graphene oxide nanosheet composites for electrochemical supercapacitor applications with excellent cyclic stability
- Combustion synthesis and formation mechanism of silver nanoparticles
- Phase relationship of the Ag–Zr–Cr system at 1000 and 750°C
- Thermal properties of carbonized composite materials based on carbon filled elastomeric matrices
- Short Communications
- Surface morphology and phase stability of titanium irradiated with 168 MeV 136Xe ions
- DGM News
- DGM News
Keywords for this article
Two-phase titanium alloys;
Hot deformation;
Microstructure;
Fragmentation and spheroidization of α phase grains;
Superplasticity
Creative Commons
BY 4.0
Articles in the same Issue
- Contents
- Contents
- Original Contributions
- Dynamic fragmentation and spheroidization of α phase grains during hot deformation of Ti-6Al-4V alloy
- Formation and characterization of hot tearing in AZ series alloys
- The effect of quench-aging on the mechanical properties of Zn-27Al-1Cu alloy
- Microstructural and mechanical properties of novel β-type Ti–Nb–Ni alloys containing a second phase
- Microstructure evolution mechanisms of undercooled Ni80Cu20 alloys
- Microstructures and tensile properties of CuZrAlNb metallic glass composites under different cooling rates
- Influence of a rare-earth element on the solidification behaviour and mechanical properties of undercooled Al–Si alloys
- Microstructure of aluminide coatings on Ti6Al4V alloy produced by the slurry method with inorganic binder
- Ultrathin SnO2 nanorod/reduced graphene oxide nanosheet composites for electrochemical supercapacitor applications with excellent cyclic stability
- Combustion synthesis and formation mechanism of silver nanoparticles
- Phase relationship of the Ag–Zr–Cr system at 1000 and 750°C
- Thermal properties of carbonized composite materials based on carbon filled elastomeric matrices
- Short Communications
- Surface morphology and phase stability of titanium irradiated with 168 MeV 136Xe ions
- DGM News
- DGM News
