Startseite The influence of FAC particle size on the damping capacity and dynamic Young's modulus of AZ91D/FAC composites at high temperature
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

The influence of FAC particle size on the damping capacity and dynamic Young's modulus of AZ91D/FAC composites at high temperature

  • Si-Rong Yu , Fan-Guo Li , Hong-Chao Chu und En-Yang Liu
Veröffentlicht/Copyright: 30. Mai 2018
Veröffentlichen auch Sie bei De Gruyter Brill
Informationen für Autor*innen
International Journal of Materials Research
Aus der Zeitschrift International Journal of Materials Research Band 109 Heft 6

Abstract

Composites of AZ91D magnesium alloy reinforced with fly-ash cenosphere (FAC) were prepared by a stirring method. The effects of the FAC particle size (83, 116, and 146 μm) and the test frequency (0.5, 1, and 5 Hz) on high-temperature damping capacity and dynamic Young's modulus of the composites were investigated. The results show that the FAC particles distributed homogeneously in the Mg-alloy matrix and some new phases formed. The composites with 146-μm FAC exhibited the highest damping capacity at all test frequencies at high temperatures, whereas the highest dynamic Young's modulus was exhibited by the composites with 83-μm FAC. Therefore, composites with good damping capacity and mechanical properties could be obtained through selection of reinforcement particles of an appropriate size.

Keywords: Magnesium alloy composites; Fly-ash cenosphere; Damping capacity; Dynamic Young's modulus
*Correspondence address, Si-Rong Yu, En-Yang Liu, College of Mechanical and Electronic Engineering, China University of Petroleum, Changjiang West Road, Huangdao distric, Qingdao 266580, P.R. China, Tel.: +86532869835008708, Fax: +8653286983300, E-mail: (S. Yu) (F. G. Li)

References

[1] D.S.Prasad, C.Shoba, B.S.Prasad: Mater. Sci. Eng. A591 (2014) 78. 10.1016/j.msea.2013.10.075Suche in Google Scholar

[2] D.S.Prasad, C.Shoba, K.R.Varma: Eng Sci Tech, an International Journal.18 (2015) 674. 10.1016/j.jestch.2015.05.001Suche in Google Scholar

[3] N.Srikanth, X.L.Zhong, M.Gupta: Mater. Lett.59 (2005) 3851. 10.1016/j.matlet.2005.07.029Suche in Google Scholar

[4] S.H.Chang, S.K.Wu, W.L.Tsai, J.Y.Wang: J. Alloys Compd.487 (2009) 142. 10.1016/j.jallcom.2009.08.006Suche in Google Scholar

[5] H.Watanabe, T.Mukai, M.Sugioka, K.Ishikawa: Scr. Mater.51 (2004) 291. 10.1016/j.scriptamat.2004.04.032Suche in Google Scholar

[6] Z.Zhang, X.Zeng, W.Ding: Mater. Sci. Eng. A392 (2005) 150. 10.1016/j.msea.2004.09.056Suche in Google Scholar

[7] S.Narasimalu, X LZhong, M.Gupta: Mater. Lett.59 (2005) 3851. 10.1016/j.matlet.2005.07.029Suche in Google Scholar

[8] Z.Q.Huang, S.R.Yu: J. Alloys Compd.509 (2011) 311. 10.1016/j.jallcom.2010.09.015Suche in Google Scholar

[9] H.Q.Tao, J.F.Yao, L.X.Zhang, N.P.Xu: Mater. Lett.63 (2009) 203. 10.1016/j.matlet.2008.09.034Suche in Google Scholar

[10] G.H.Wu, Z.Y.Dou, L.T.Jiang, J.H.Cao: Mater. Lett.60 (2006) 2945. 10.1016/j.matlet.2006.02.018Suche in Google Scholar

[11] K.Sudarshan, M.K.Surappa: Mater. Sci. Eng. A480 (2008) 117. 10.1016/j.msea.2007.06.068Suche in Google Scholar

[12] M.Yuan, S.R.Yu, F.G.Li: Acta Materiae Compositae Sinica33 (2016) 1742 (in Chinese). 10.13801/j.cnki.fhclxb.20151022.004Suche in Google Scholar

[13] S.Madeira, O.Carvalho, V.H.Carneiro, D.SoaresF.S.Silva. G.Miranda: Compos. Part B: Eng.90 (2016) 399. 10.1016/j.compositesb.2016.01.008Suche in Google Scholar

[14] C.J.Wang, K.K.Deng, W.Liang: Mater. Sci. Eng. A668 (2016) 55. 10.1016/j.msea.2016.05.055Suche in Google Scholar

[15] O.Carvalho, G.Miranda, M.Buciumeanu, M.Gasikc, F.S.Silva, S.Madeira: Compos Struct.141 (2016) 155. 10.1016/j.compstruct.2016.01.046Suche in Google Scholar

[16] C.S.Kang, K.Maeda, K.J.Wang, K.Wakashima: Acta Mater.46 (1998) 1209. 10.1016/S1359-6454(97)00293-0Suche in Google Scholar

Received: 2017-11-15
Accepted: 2018-01-25
Published Online: 2018-05-30
Published in Print: 2018-06-12

© 2018, Carl Hanser Verlag, München

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Original Contributions
  4. Microstructural characterization of dynamic recrystallization in hot deformed LDX2101
  5. Influence of the carbon content on the microstructure and properties of heat-resistant cast steels
  6. Study of the effects produced by ultrasonic vibration on AISI 1045 steel surface: surface residual stress and surface 3D morphology
  7. Effects of Co content on microwave absorbing properties of Dy–Ni powder
  8. Modelling, simulation and optimisation of pulse-reverse regime of copper, silver and gold electrodeposition
  9. Effect of various ratios of nitric acid – chloride on electronic properties of passive films on AISI 304L stainless steel
  10. Effects of Fe-doping on structural, magnetic and magnetocaloric properties of the intermetallic compound Gd7Pd3-xFex
  11. The influence of FAC particle size on the damping capacity and dynamic Young's modulus of AZ91D/FAC composites at high temperature
  12. Characterization of A356 aluminum matrix composite affected by SiC particle size and extrusion parameters
  13. Hydrothermal synthesis of superparamagnetic zinc–nickel ferrite nanoparticles
  14. Inflorescence type morphology and mirror–mist–hackle pattern in tensile fractograph of MWCNT/PBT nano-composites
  15. Short Communications
  16. Binary diffusion behaviour in Ti–X (X = Al, Mo, V, Cr, Fe) alloys
  17. Regulation of the microstructural and optical properties of bismuth ferrite nanowires by mineralizer concentration
  18. People
  19. Manfred Rühle on the occasion of his 80th birthday
  20. DGM News
  21. DGM News
https://doi.org/10.3139/146.111637
Schlagwörter für diesen Artikel
Magnesium alloy composites; Fly-ash cenosphere; Damping capacity; Dynamic Young's modulus

Artikel in diesem Heft

  1. Contents
  2. Contents
  3. Original Contributions
  4. Microstructural characterization of dynamic recrystallization in hot deformed LDX2101
  5. Influence of the carbon content on the microstructure and properties of heat-resistant cast steels
  6. Study of the effects produced by ultrasonic vibration on AISI 1045 steel surface: surface residual stress and surface 3D morphology
  7. Effects of Co content on microwave absorbing properties of Dy–Ni powder
  8. Modelling, simulation and optimisation of pulse-reverse regime of copper, silver and gold electrodeposition
  9. Effect of various ratios of nitric acid – chloride on electronic properties of passive films on AISI 304L stainless steel
  10. Effects of Fe-doping on structural, magnetic and magnetocaloric properties of the intermetallic compound Gd7Pd3-xFex
  11. The influence of FAC particle size on the damping capacity and dynamic Young's modulus of AZ91D/FAC composites at high temperature
  12. Characterization of A356 aluminum matrix composite affected by SiC particle size and extrusion parameters
  13. Hydrothermal synthesis of superparamagnetic zinc–nickel ferrite nanoparticles
  14. Inflorescence type morphology and mirror–mist–hackle pattern in tensile fractograph of MWCNT/PBT nano-composites
  15. Short Communications
  16. Binary diffusion behaviour in Ti–X (X = Al, Mo, V, Cr, Fe) alloys
  17. Regulation of the microstructural and optical properties of bismuth ferrite nanowires by mineralizer concentration
  18. People
  19. Manfred Rühle on the occasion of his 80th birthday
  20. DGM News
  21. DGM News
Jetzt anmelden und 20% sparen
Institutioneller Zugang
Wie funktioniert Authentifizierung?
Haben Sie eine Idee, wie wir unsere Website verbessern können?
Bitte schreiben Sie uns.
© 2025 De Gruyter Brill
Heruntergeladen am 7.9.2025 von https://www.degruyterbrill.com/document/doi/10.3139/146.111637/html
Button zum nach oben scrollen