Charles Crussard's contribution to sheet metal forming and participation in IDDRG
-
Alain Col
Abstract
This paper describes the contribution of Charles Crussard to sheet metal forming science. After recalling the state of this technique in the 1940s, when Crussard started his studies, we explain how the International Deep Drawing Research Group was launched, how he became the second president of this organisation and how much he influenced it.
Some examples of his contributions to research are given, and finally a brief review of later progress in this domain will point out the development of some of his ideas.
References
[1] W.T.Lankford, S.C.Snyder, J.A.Bauscher: Trans. ASM42 (1950) 1197–1225.Search in Google Scholar
[2] C.Crussard, G.Pomey, D.Lajeunesse, M.Angeli: Mém. Scient. Rev. Métall. LVIII3 (1961) 183–202.Search in Google Scholar
[3] M.Angeli, B.Jaoul, C.Crussard: C. R. des séances de l'Académie des Sciences253 (1961) 451–453.Search in Google Scholar
[4] M.Angeli, C.Crussard, B.Jaoul, G.Pomey: Mém. Scient. Rev. Métall. LIX6 (1962) 441–453.Search in Google Scholar
[5] C.Crussard, B.Jaoul: Rev. Métall. XLVII8 (1950) 589–600.10.1051/metal/195047080589Search in Google Scholar
[6] C.Crussard: Métaux-Corrosion-Industrie371–372 (1956) 295–304.Search in Google Scholar
[7] C.Crussard: Mém. Scient. Rev. Métall.4 (1964) 231–242.Search in Google Scholar
[8] C.Crussard: Mécanique Industrielle, 33 (1957) 42–48.Search in Google Scholar
[9] G.Pomey, M.Grumbach, D.Lajeunesse, C.Crussard: Mém. Scient. Rev. Métall.11 (1961) 809–834.Search in Google Scholar
[10] L.Kessler, J.Gerlach, M.S.Aydin: IDDRG Conference (2008) 441–452.Search in Google Scholar
© 2009, Carl Hanser Verlag, München
Articles in the same Issue
- Contents
- Contents
- Introduction
- Introduction
- G. Petzow: Laudation for Peter Paul Schepp
- Dr. Schepp's retirement after 20 years of service was celebrated
- Preface to Feature Articles
- “SURFACE and INTERFACE ENGINEERING”
- Feature
- Thermodynamics of reactions and phase transformations at interfaces and surfaces
- Oxidation of palladium: from single crystal surfaces towards nanoparticles
- On the high-temperature oxidation of MCrAlY coatings
- Conducting polymers for corrosion protection: a review
- Fundamental and applied aspects of laser surface engineering
- Low-temperature gaseous surface hardening of stainless steel: the current status
- Foreword
- Foreword
- Editorial
- The scientific work of Charles Crussard (1916–2008)
- Review
- Charles Crussard's early contributions: Recrystallization in situ and a Grain Boundary study with J. Friedel and B. Cullity
- Magnetohydrodynamics applied to materials processing
- Charles Crussard's contribution to sheet metal forming and participation in IDDRG
- Glide of dislocations in non-octahedral planes of fcc metals: a review
- The deformation stage II of face-centered cubic crystals: Fifty years of investigations
- Nucleation and growth during primary recrystallization of certain metals and alloys with a face-centered cubic structure: Formation of the cube texture
- Basic
- Andrade creep revisited
- Application of cluster dynamics modeling to the precipitation in aluminum alloys
- On the effect of pre-recovery on subsequent recrystallization
- The interplay between grain boundaries and disclinations in condensed matter physics
- Plasticity of nanocrystalline materials: a critical viewpoint
- Thermoelectric power applied to metallurgy: principle and recent applications
- Notifications
- People
Articles in the same Issue
- Contents
- Contents
- Introduction
- Introduction
- G. Petzow: Laudation for Peter Paul Schepp
- Dr. Schepp's retirement after 20 years of service was celebrated
- Preface to Feature Articles
- “SURFACE and INTERFACE ENGINEERING”
- Feature
- Thermodynamics of reactions and phase transformations at interfaces and surfaces
- Oxidation of palladium: from single crystal surfaces towards nanoparticles
- On the high-temperature oxidation of MCrAlY coatings
- Conducting polymers for corrosion protection: a review
- Fundamental and applied aspects of laser surface engineering
- Low-temperature gaseous surface hardening of stainless steel: the current status
- Foreword
- Foreword
- Editorial
- The scientific work of Charles Crussard (1916–2008)
- Review
- Charles Crussard's early contributions: Recrystallization in situ and a Grain Boundary study with J. Friedel and B. Cullity
- Magnetohydrodynamics applied to materials processing
- Charles Crussard's contribution to sheet metal forming and participation in IDDRG
- Glide of dislocations in non-octahedral planes of fcc metals: a review
- The deformation stage II of face-centered cubic crystals: Fifty years of investigations
- Nucleation and growth during primary recrystallization of certain metals and alloys with a face-centered cubic structure: Formation of the cube texture
- Basic
- Andrade creep revisited
- Application of cluster dynamics modeling to the precipitation in aluminum alloys
- On the effect of pre-recovery on subsequent recrystallization
- The interplay between grain boundaries and disclinations in condensed matter physics
- Plasticity of nanocrystalline materials: a critical viewpoint
- Thermoelectric power applied to metallurgy: principle and recent applications
- Notifications
- People
