Home Technology Determination of Liquidus Temperature in Sn–Ti–Zr Alloys by Viscosity, Electrical Conductivity and XRD Measurements
Article
Licensed
Unlicensed Requires Authentication

Determination of Liquidus Temperature in Sn–Ti–Zr Alloys by Viscosity, Electrical Conductivity and XRD Measurements

  • Yuriy Plevachuk , Stepan Mudry , Vasyl Sklyarchuk , Andriy Yakymovych , Andriy Korolyshyn , Ihor Shtablavyy , Yuriy Kulyk , Ulrich E. Klotz , Chunlei Liu and Christian Leinenbach
Published/Copyright: June 11, 2013
Become an author with De Gruyter Brill
Submit Manuscript Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 100 Issue 5

Abstract

The Sn – Ti – Zr system is an important subsystem for Cu based active brazing filler metals. Experimental results on this system, however, are rather scarce. The diagram is rather uncertain regarding most of the liquidus, especially on the Sn rich side. In this work, the atomic structure and temperature dependence of structure-sensitive physical properties (dynamic viscosity and electrical conductivity) of liquid Sn – Ti – Zr alloys in the Sn-rich corner were investigated in a wide temperature range with special attention to the melting – solidification region. The results allowed the liquidus line position to be specified.

Keywords: Sn – Ti – Zr; Phase diagrams; Viscosity; Electrical conductivity; XRD
* Correspondence address, Dr. Y. Plevachuk Ivan Franko National University Department of Metal Physics 8, Kyrylo and Mephodiy Str., 79005 Lviv, Ukraine Tel.: +38 032 239 4270 Fax: +38 032 295 6908 E-mail:

References

[1] N.Dupin, I.Ansara, C.Servant, C.Toffolon, C.Lemaignan, J.C.Brachet: J. Nucl. Mater.275 (1999) 287.Search in Google Scholar

[2] N.Subasic: Calphad22 (1998) 157.10.1016/S0364-5916(98)00021-2Search in Google Scholar

[3] C.Liu, U.E.Klotz, P.J.Uggowitzer, J.F.Löffler: Monatsh. Chem.136 (2005) 1921.Search in Google Scholar

[4] F.Yin, J.C.Tedenac, F.Gascoin: Calphad31 (2007) 370.10.3139/146.110436Search in Google Scholar

[5] C.Liu: Characterisation and Modelling of Interface Reactions between Diamond and Active Brazing Alloys. Ph.D. Thesis No. 17469. ETH Zuerich, 2007.Search in Google Scholar

[6] Y.Plevachuk, S.Mudry, V.Sklyarchuk, A.Yakymovych, U.E.Klotz, M.Roth: J. Mater. Sci.42 (2007) 8618.Search in Google Scholar

[7] V.Sklyarchuk, Y.Plevachuk, S.Mudry, A.Yakymovych, U.E.Klotz, C.Liu: J. Phys.: Conf. Series 98 (2008) 062008.Search in Google Scholar

[8] S.Mudry, V.Sklyarchuk, A.Yakymovych: J. Phys. Studies.12 (2008) 1601.Search in Google Scholar

[9] Y.Plevachuk, V.Sklyarchuk: Meas. Sci. Technol.12 (2001) 23.Search in Google Scholar

[10] D.T.Cromer, J.T.Waber: Acta Cryst.18 (1965) 104.Search in Google Scholar

[11] J.Vollmann, D.Riedel: J. Phys.: Condens. Matter8 (1996) 6175.10.1088/0953-8984/8/34/007Search in Google Scholar

[12] T.E.Faber: An introduction to the theory of liquid metals, Cambridge Univ., London (1972).10.1063/1.3128232Search in Google Scholar

[13] S.Ohno, S.Harada: J. Phys. Soc. Jpn.49 (1980) 189.Search in Google Scholar

[14] S.Mudry, V.Sklyarchuk, Y.Plevachuk, I.Shtablavyi: Inorg. Mater.44 (2008) 129.Search in Google Scholar

Received: 2008-5-13
Accepted: 2008-10-25
Published Online: 2013-06-11
Published in Print: 2009-05-01

© 2009, Carl Hanser Verlag, München

Articles in the same Issue

  1. Contents
  2. Contents
  3. Feature
  4. Nd–Fe–B permanent magnets a quarter century later: implications for patentability
  5. Micromagnetism of advanced hard magnetic materials
  6. Magnetism of nanostructured materials for advanced magnetic recording
  7. Basic
  8. A Study of the Al–Mg–B Ternary Phase Diagram
  9. Effects of Lanthanum on Magnetic Behavior and Hardness of Electroless Ni–Fe–P Deposits
  10. Interfacial Reactions between Lead-Free Solders and the Multilayer Au/Ni/SUS304 Substrate
  11. Melting Behavior of Sn–Bi Alloy Powder Compacts Observed Using Optical Dilatometry
  12. High-Strength Mg-Based Bulk Metallic Glass Composites with Remarkable Plasticity
  13. Determination of Liquidus Temperature in Sn–Ti–Zr Alloys by Viscosity, Electrical Conductivity and XRD Measurements
  14. The coupled FEM analysis of super-high angular speed polishing of diamond films
  15. Applied
  16. Comparison of Depth-Sensing Indentation at Ultramicroscopic Contacts by Single- and Multiple-Partial-Unload Cycles
  17. Sintering Behavior of ZnO: Mn Ceramics Fabricated from Sol-Gel Derived Nanocrystalline powders
  18. Suitability of Maraging Steel Weld Cladding for Repair of Die-Casting Tooling
  19. Enhanced properties of functionally graded Cu–Cr powder compacts
  20. Influence of Cr on the microstructure and mechanical properties of Ti–Si Eutectic Alloys
  21. Notifications
  22. DGM News
https://doi.org/10.3139/146.110086
Keywords for this article
Sn – Ti – Zr; Phase diagrams; Viscosity; Electrical conductivity; XRD

Articles in the same Issue

  1. Contents
  2. Contents
  3. Feature
  4. Nd–Fe–B permanent magnets a quarter century later: implications for patentability
  5. Micromagnetism of advanced hard magnetic materials
  6. Magnetism of nanostructured materials for advanced magnetic recording
  7. Basic
  8. A Study of the Al–Mg–B Ternary Phase Diagram
  9. Effects of Lanthanum on Magnetic Behavior and Hardness of Electroless Ni–Fe–P Deposits
  10. Interfacial Reactions between Lead-Free Solders and the Multilayer Au/Ni/SUS304 Substrate
  11. Melting Behavior of Sn–Bi Alloy Powder Compacts Observed Using Optical Dilatometry
  12. High-Strength Mg-Based Bulk Metallic Glass Composites with Remarkable Plasticity
  13. Determination of Liquidus Temperature in Sn–Ti–Zr Alloys by Viscosity, Electrical Conductivity and XRD Measurements
  14. The coupled FEM analysis of super-high angular speed polishing of diamond films
  15. Applied
  16. Comparison of Depth-Sensing Indentation at Ultramicroscopic Contacts by Single- and Multiple-Partial-Unload Cycles
  17. Sintering Behavior of ZnO: Mn Ceramics Fabricated from Sol-Gel Derived Nanocrystalline powders
  18. Suitability of Maraging Steel Weld Cladding for Repair of Die-Casting Tooling
  19. Enhanced properties of functionally graded Cu–Cr powder compacts
  20. Influence of Cr on the microstructure and mechanical properties of Ti–Si Eutectic Alloys
  21. Notifications
  22. DGM News
Sign up now to receive a 20% welcome discount
Institutional Access
How does access work?
Have an idea on how to improve our website?
Please write us.
© 2025 De Gruyter Brill
Downloaded on 31.12.2025 from https://www.degruyterbrill.com/document/doi/10.3139/146.110086/pdf
Scroll to top button