Application of FactSage thermodynamic modeling of recycled slags (Al2O3–CaO–FeO–Fe2O3–SiO2–PbO–ZnO) in the treatment of wastes from end-of-life-vehicles
-
E. Jak
Abstract
The FactSage thermochemical software and databases calculates complex, multi-component, multi-phase equilibria involving simultaneously slag, metal, ceramic, and gas phases, over wide ranges of temperature, oxygen potential and pressure. The databases are automatically accessed by the software and the outputs of the Gibbs free energy minimization calculations can be presented in ways that are convenient to engineering practice, and as functions of key process variables.
The new thermodynamic databases for slag and solid oxide phases in the Al2O3 – CaO – FeO – Fe2O3 – SiO2 – PbO – ZnO system have been developed by critical evaluation/optimization of all available phase equilibrium and thermodynamic data. By means of the optimization process, model parameters are found which reproduce all thermodynamic and phase equilibrium data within experimental error limits. Furthermore, the models permit extrapolation into regions of temperature and composition where data are not available.
Phase equilibrium calculations have been undertaken, that are of interest in the thermal treatment of Automobile Shredder Residue (ASR) in the Al2O3 – CaO – FeO – Fe2O3 – SiO2 – PbO – ZnO system. This 7-component system represents only the major components of ASR. There are at least a dozen other important components in ASR not to mention the organic matter. The operating conditions deviate from thermodynamic equilibrium and the oxygen potential during the treatment of wastes is not well established. Consequently, the calculated diagrams are intended only to give an idea to industrial engineers about the trends in the liquidus temperature, extent of crystallization and partial pressures of volatile components as functions of temperature, composition and oxygen potential. These diagrams may also help to identify the process variables that are most important for industrial practice significantly reducing the amount of experimental work that has to be done to optimize the operations.
References
[1] C.W.Bale, P.Chartrand, S.Decterov, G.Eriksson, K.Hack, R.B.Mahfoud, J.Melancon, A.D.Pelton, S.Petersen: Calphad26 (2002) 189; www.factsage.com.Search in Google Scholar
[2] G.Eriksson: Chem. Scr.8 (1975) 100.Search in Google Scholar
[3] G.Eriksson, K.Hack: Metall. Trans. B21 (1990) 1013.Search in Google Scholar
[4] A.D.Pelton, M.Blander: Metall. Trans. B17 (1986) 805.Search in Google Scholar
[5] P.Chartrand, A.D.Pelton: Metall. Mater. Trans. A32 (2001) 1397.Search in Google Scholar
[6] A.D.Pelton, S.A.Decterov, G.Eriksson, C.Robelin, Y.Dessureault: Metall. Mater. Trans. B31 (2000) 651.Search in Google Scholar
[7] A.D.Pelton, P.Chartrand: Metall. Mater. Trans. A32 (2001) 1355.Search in Google Scholar
[8] S.A.Decterov, I.-H.Jung, E.Jak, Y.-B.Kang, P.Hayes, A.D.Pelton: SAIMM Symposium Series S36 (VII Int. Conf. on Molten Slags, Fluxes & Salts), The South African Institute of Mining and Metallurgy, Johannesburg, Republic of South Africa (2004) 839.Search in Google Scholar
[9] E.Jak, S.A.Decterov, P.Wu, P.C.Hayes, A.D.Pelton: Metall. Mater. Trans. B28 (1997) 1011.Search in Google Scholar
[10] E.Jak, S.A.Decterov, P.C.Hayes, A.D.Pelton: Can. Metall. Q.37 (1998) 41.Search in Google Scholar
[11] E.Jak, S.A.Decterov, B.Zhao, A.D.Pelton, P.C.Hayes: Metall. Mater. Trans. B31 (2000) 621.Search in Google Scholar
[12] E.Jak, S.A.Decterov, P.C.Hayes, A.D.Pelton: Proc. 5th Int. Conf. on Molten Slags, Fluxes and Salts, Iron and Steel Soc., AIME, Sydney, Australia (1997) 621.Search in Google Scholar
[13] S.A.Decterov, E.Jak, P.C.Hayes, A.D.Pelton: Metall. Mater. Trans. B32 (2001) 643.Search in Google Scholar
[14] M.Kudo, E.Jak, P.Hayes, K.Yamaguchi, Y.Takeda: Metall. Mater. Trans. B31 (2000) 15.Search in Google Scholar
[15] E.Jak, S.Decterov, A.D.Pelton, P.C.Hayes: Metall. Mater. Trans. B32 (2001) 793.Search in Google Scholar
[16] E.Jak, S.A.Decterov, A.D.Pelton, J.Happ, P.C.Hayes: Impact of Mineral Impurities in Solid Fuel Combustion, Kluwer Academic/Plenum Publ., NY (1999) 723.Search in Google Scholar
[17] E.Jak, S.A.Decterov, P.C.Hayes, A.D.Pelton: Fuel77 (1998) 77.Search in Google Scholar
[18] EU ELV Directive 2000/53, http://europa.eu.int/eur-lex/pri/en/oj/dat/2000/l_269/l_26920001021en00340042.pdfSearch in Google Scholar
[19] A.Stuecheli: Process Technology for ASR Treatment, ACEA Car Recycling Workshop Munich, Sept. (2002).Search in Google Scholar
[20] A.Kondratiev, E.Jak: Metall. Mater. Trans. B32 (2001) 1027.Search in Google Scholar
[21] A.Kondratiev, E.Jak: Metall. Trans. B36 (2005) 623.Search in Google Scholar
[22] A.N.Grundy, H.-C.Liu, S.A.Decterov, A.D.Pelton: (A Model to Calculate the Viscosity of Silicate Melts Part I: Viscosity of binary SiO2–MeOx systems (Me = Na, K, Ca, Mg, Al)), Int. J. Mat. Res., to be submitted.Search in Google Scholar
[23] A.N.Grundy, H.-C.Liu, S.A.Decterov, A.D.Pelton: (A Model to Calculate the Viscosity of Silicate Melts Part II: Viscosity of the multicomponent NaO0.5–MgO–CaO–AlO1.5–SiO2 system), Int. J. Mat. Res., to be submitted.Search in Google Scholar
© 2007, Carl Hanser Verlag, München
Articles in the same Issue
- Contents
- Contents
- Editorial
- Computational Thermochemistry
- Gunnar Eriksson 65 years
- Basic
- Vegard's law: a fundamental relation or an approximation?
- Is it a compound or cluster energy formalism?
- Post-optimization elimination of inverted miscibility gaps
- Thermodynamic evaluation of the Au–Sn system
- Applications of thermodynamic calculations to Mg alloy design: Mg–Sn based alloy development
- Thermodynamic modeling of the CoO–SiO2 and CoO–FeO–Fe2O3–SiO2 systems
- Scheil–Gulliver simulation with partial redistribution of fast diffusers and simultaneous solid–solid phase transformations
- Analysis of X-ray extinction due to homogeneously distributed dislocations – Bragg case
- Applied
- Thermodynamic modelling in the ZrO2–La2O3–Y2O3–Al2O3 system
- Thermodynamic optimisation of the FeO–Fe2O3–SiO2 (Fe–O–Si) system with FactSage
- Reassessment of the Al–Mn system and a thermodynamic description of the Al–Mg–Mn system
- Application of FactSage thermodynamic modeling of recycled slags (Al2O3–CaO–FeO–Fe2O3–SiO2–PbO–ZnO) in the treatment of wastes from end-of-life-vehicles
- Bio-inspired syntheses of ZnO-protein composites
- Preparation and characterization of cobalt–bismuth nano- and micro-particles
- Strain rate dependency on deformation texture for pure polycrystalline tantalum
- Notifications
- DGM News
Articles in the same Issue
- Contents
- Contents
- Editorial
- Computational Thermochemistry
- Gunnar Eriksson 65 years
- Basic
- Vegard's law: a fundamental relation or an approximation?
- Is it a compound or cluster energy formalism?
- Post-optimization elimination of inverted miscibility gaps
- Thermodynamic evaluation of the Au–Sn system
- Applications of thermodynamic calculations to Mg alloy design: Mg–Sn based alloy development
- Thermodynamic modeling of the CoO–SiO2 and CoO–FeO–Fe2O3–SiO2 systems
- Scheil–Gulliver simulation with partial redistribution of fast diffusers and simultaneous solid–solid phase transformations
- Analysis of X-ray extinction due to homogeneously distributed dislocations – Bragg case
- Applied
- Thermodynamic modelling in the ZrO2–La2O3–Y2O3–Al2O3 system
- Thermodynamic optimisation of the FeO–Fe2O3–SiO2 (Fe–O–Si) system with FactSage
- Reassessment of the Al–Mn system and a thermodynamic description of the Al–Mg–Mn system
- Application of FactSage thermodynamic modeling of recycled slags (Al2O3–CaO–FeO–Fe2O3–SiO2–PbO–ZnO) in the treatment of wastes from end-of-life-vehicles
- Bio-inspired syntheses of ZnO-protein composites
- Preparation and characterization of cobalt–bismuth nano- and micro-particles
- Strain rate dependency on deformation texture for pure polycrystalline tantalum
- Notifications
- DGM News
