DGM News

Articles in the same Issue

1. Contents
2. Contents
3. Editorial
4. Editorial
5. Basic
6. Relating viscoelastic nanoindentation creep and load relaxation experiments
7. Identification of viscoelastic model parameters by means of cyclic nanoindentation testing
8. Scaling relations for viscoelastic – cohesive conical indentation
9. Effect of the indentation depth on the evaluation of mechanical properties of thin films
10. Investigation of the relationship between work done during indentation and the hardness and Young's modulus obtained by indentation testing
11. Pop-in effect in Ge- and Si-coated single-crystalline Si
12. Multi-scale mechanical characterization of a freestanding polymer film using indentation
13. Applied
14. Energy-based hardness of soda-lime silicate glass
15. Mechanical properties of a-C, SiC and Ti-C: H films
16. Influence of the mathematical model on the evaluation of nanomechanical properties of ultrathin polymer layers studied by AFM
17. AFM testing of the nanomechanical behaviour of MEMS micromembranes
18. Mechanical and tribological behaviour of carbon nanotube brushes
19. Phase equilibria in the system “MnO” – CaO – SiO₂ – Al₂O₃ – K₂O relevant to manganese smelting slags
20. Influence of grain refinement and modification on dry sliding wear behavior of Al-12Si and Al-12Si-3Cu cast alloys
21. Measurement of the isothermal sections at 700 and 427 °C in the Al – Mg – Ni system
22. Notifications
23. DGM News