Contents

Articles in the same Issue

1. Contents
2. Contents
3. Original Contributions
4. Nanoindentation of carbon microspheres
5. Thermal and mechanical properties of single-walled and multi-walled carbon nanotube polycarbonate polyurethane composites with a focus on self-healing
6. Preparation and characterization of ZnO nanorod arrays produced using wet methods
7. Phase equilibria of the Al–Zn–Fe–V quaternary system at 620 °C
8. Effect of withdrawal rate and zinc content on pore structure and morphology of lotus-type porous Cu–Zn alloys fabricated using continuous casting
9. Investigation of tungsten surface changes after interaction with dense plasma streams compared with the results given by a simple 1D model
10. Investigation of Al₂O₃/TiC ceramic cutting tool materials with the addition of SiC-coated h-BN: preparation, mechanical properties, microstructure and wear resistance
11. Effect of the addition of different sintering aids on the densification behavior of zirconia-toughened alumina nanocomposite powder
12. Mixed mode notch-crack fatigue propagation in the welding zone of 06Cr19Ni10 austenitic stainless steel: Effect of strain strengthening
13. A study on mechanical and microstructural properties of dissimilar FSWed joints of AA5251–AA5083 plates
14. Short Communications
15. A methodology for in-situ micro-compression testing of fiber composites
16. The synthesis and electrochemical performance of Cu₆Sn₅ intermetallic nanoparticles as anode material in Li ion batteries
17. DGM News
18. DGM News