Article
Licensed
Unlicensed Requires Authentication

DGM News

Published/Copyright: June 11, 2013
Become an author with De Gruyter Brill
Submit Manuscript Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 102 Issue 3

Published Online: 2013-06-11
Published in Print: 2011-03-01

© 2011, Carl Hanser Verlag, München

Articles in the same Issue

  1. Contents
  2. Contents
  3. Original Contributions
  4. Experimental investigation and thermodynamic calculation of the Zn–Al–Sb system
  5. Determination of liquidus temperature in Ti-rich alloys of the Fe–Ni–Ti system obtained by DTA, electrical conductivity and XRD measurements
  6. Phase equilibria in the Sn–Zn–Ni system
  7. Phase equilibria studies in alumina-containing high zinc fayalite slags with CaO/SiO2 = 0.55 Part 2
  8. Mixing enthalpies in liquid alloys of manganese with the lanthanides
  9. Some thermophysical properties of the intermetallic Ti40Al60 alloy in the melting-solidification temperature range
  10. Thermodynamic modelling of the Ag–Cu–Ti ternary system
  11. Reaction synthesis and wear resistance of a TiCp/Ni3Al-Fe composite coating on steel
  12. A novel method for Al/SiC composite fabrication: Lost foam casting
  13. Three-dimensional braided fabrics-reinforced composites for load-bearing orthopedic applications Part I: mechanical performance
  14. A micromechanical analysis of local contact at die compaction of powder materials
  15. Numerical simulation for the determination of the limit drawing ratio of a cold rolled and solution treated Nimonic C-263 alloy sheet
  16. One-dimensional red photoluminescence of (Y,Gd)BO3 nanofibers doped with Eu3+
  17. Chloride penetration and corrosion resistance of ground fly ash blended cement mortar
  18. Optical and thermodynamic studies of silver nanoparticles stabilized by Daxad 19 surfactant
  19. DGM News
  20. DGM News
https://doi.org/10.3139/146.011034

Articles in the same Issue

  1. Contents
  2. Contents
  3. Original Contributions
  4. Experimental investigation and thermodynamic calculation of the Zn–Al–Sb system
  5. Determination of liquidus temperature in Ti-rich alloys of the Fe–Ni–Ti system obtained by DTA, electrical conductivity and XRD measurements
  6. Phase equilibria in the Sn–Zn–Ni system
  7. Phase equilibria studies in alumina-containing high zinc fayalite slags with CaO/SiO2 = 0.55 Part 2
  8. Mixing enthalpies in liquid alloys of manganese with the lanthanides
  9. Some thermophysical properties of the intermetallic Ti40Al60 alloy in the melting-solidification temperature range
  10. Thermodynamic modelling of the Ag–Cu–Ti ternary system
  11. Reaction synthesis and wear resistance of a TiCp/Ni3Al-Fe composite coating on steel
  12. A novel method for Al/SiC composite fabrication: Lost foam casting
  13. Three-dimensional braided fabrics-reinforced composites for load-bearing orthopedic applications Part I: mechanical performance
  14. A micromechanical analysis of local contact at die compaction of powder materials
  15. Numerical simulation for the determination of the limit drawing ratio of a cold rolled and solution treated Nimonic C-263 alloy sheet
  16. One-dimensional red photoluminescence of (Y,Gd)BO3 nanofibers doped with Eu3+
  17. Chloride penetration and corrosion resistance of ground fly ash blended cement mortar
  18. Optical and thermodynamic studies of silver nanoparticles stabilized by Daxad 19 surfactant
  19. DGM News
  20. DGM News
Downloaded on 14.4.2026 from https://www.degruyterbrill.com/document/doi/10.3139/146.011034/html
Scroll to top button