Contents

Artikel in diesem Heft

1. Inhalt/Contents
2. Contents
3. Fachbeiträge/Technical Contributions
4. Effects of pre- and post-weld heat treatment conditions on microstructures of cast nickel based superalloys GTD-111 in the laser welding process
5. Evaluation of the low-cycle fatigue strength of Sn3.0Ag0.5Cu solder at 313 and 353 K using a small specimen
6. The Harris hawks, grasshopper and multi-verse optimization algorithms for the selection of optimal machining parameters in manufacturing operations
7. A new hybrid Harris hawks-Nelder-Mead optimization algorithm for solving design and manufacturing problems
8. The Harris hawks optimization algorithm, salp swarm algorithm, grasshopper optimization algorithm and dragonfly algorithm for structural design optimization of vehicle components
9. Axial crushing behavior of circular aluminum tubes
10. Effect of substrate surface preparation on cold sprayed Al-Zn-Al²O³ composite coating properties
11. Top-down approach for the estimation of measurement uncertainty based on quality control data and grey system theory
12. Hoop tensile and compression behavior of glass-carbon intraply hybrid fiber reinforced filament wound composite pipes
13. Non-linear modeling of mechanical properties of plasma arc welded Inconel 617 plates
14. Wear testing of in situ cast AA8011-TiB₂ metal matrix composites
15. Microstructure, mechanical properties and ELM based wear loss prediction of plasma sprayed ZrO₂-MgO coatings on a magnesium alloy
16. Energy consumption model for the pipe threading process using 10 wt.-% Cu and 316L stainless steel powder-reinforced aluminum 6061 fittings
17. Effect of matrix material and orientation angle on tensile and tribological behavior of jute reinforced composites