Axial and Radial Investigation of Hydrodynamics in a Bubble Column; Influence of Fluids Flow Rates and Sparger Type
-
Hélène Chaumat
, Anne-Marie Billet and Henri Delmas
A detailed investigation of local hydrodynamics in a pilot plant bubble column has been performed using various techniques, exploring both axial and radial variations of the gas hold-up, bubble average diameter and frequency, surface area. A wide range of operating conditions has been explored up to large gas and liquid flow rates, with two sparger types. Two main complementary techniques were used: a quasi local measurement of gas hold-up via series of differential pressure sensors to get the axial variation and a double optic probe giving radial variations of gad hold-up, bubble average size and frequency and surface area.According to axial evolutions, three zones, where radial evolutions have been detailed, have been separated: at the bottom the gas injection zone, the large central region or column bulk and the disengagement zone at the column top. It was found that significant axial and radial variations of the two phase flow characteristics do exist even in the so called homogeneous regime. The normalized profiles of bubble frequency appear sparger and gas velocity independent contrary to bubble diameter, gas hold-up and interfacial area normalized profiles. In any case bubbles are larger in the sparger zone than elsewhere.The main result of this work is the very strong effect of liquid flow on bubble column hydrodynamics at low gas flow rate. First the flow regime map observed in batch mode is dramatically modified with a drastic reduction of the homogeneous regime region, up to a complete heterogeneous regime in the working conditions (uG> 0.02 m/s). On the contrary, liquid flow has limited effects at very high gas flow rates.A large data bank is provided to be used for example in detailed comparison with CFD calculations.
©2011 Walter de Gruyter GmbH & Co. KG, Berlin/Boston
Articles in the same Issue
- Review
- Practical Implications of Bifurcation and Chaos in Chemical and Biological Reaction Engineering
- Article
- Optimization of Bacterial Oxidation Process Parameters for Selective Leaching of Nickel by Thiobacillus Ferrooxidans
- Direct Numerical Simulation of Mass Transfer from Spherical Bubbles: the Effect of Interface Contamination at Low Reynolds Numbers
- Plasma-Prepared Ni/Al2O3: Preparation, Characterization and Toluene Hydrogenation
- Flow Induced by Dual-Turbine of Different Diameters in a Gas-Liquid Agitation System: the Agitation and Turbulence Indices
- A Comprehensive Model for Catalytic Membrane Reactor
- A Structured Model for Interleukin-11 Production with Recombinant E.coli and Genetic Algorithm for Model Parameter Estimation
- Calorimetry for Inferential Conversion Monitoring in Emulsion Copolymerization Reactors
- Identification of the State of a Magneto-Fluidized Bed by Pressure Fluctuations
- Modeling a Silicon CVD Spouted Bed Pilot Plant Reactor
- Intercooled Double-Bed Reactor for LTWGS Reaction with Catalyst Poisoning by Chlorine: Inlet Temperatures for the Maximization of the Production
- Comprehensive Modeling of Gas Fluidized-Bed Reactors Allowing for Transients, Multiple Flow Regimes and Selective Removal of Species
- Isothermal PFR/PMR Networks
- Influence of Particles and Electrolyte on Gas Hold-Up and Mass Transfer in a Slurry Bubble Column
- Three Phase Catalytic Reactions: Role of Omega Aqueous Phase in Solid-Liquid Phase Transfer Catalyzed Etherification of 2'- Hydroxy Acetophenone
- Treatment of Cork Wastes in a Conical Spouted Bed Reactor
- Biosorption of Combined Industrial Effluents using Phanerochaete Chrysosporium
- Kinetics of Liquid - Phase Hydrogenation of Straight Chain C10 to C13 Di-Olefins Over Ni/Al2O3 Catalyst
- Kinetics of H2S Sorption on Manganese Oxide and Mn-Fe-Cu Mixed Oxide Prepared by the Complexation Technique
- Design of a Fuel Cell Power System for Automotive Applications
- Simulation of a Two-Stage Micro Trickle-Bed Hydrotreating Reactor using Athabasca Bitumen-Derived Heavy Gas Oil over Commercial NiMo/Al2O3 Catalyst: Effect of H2S on Hydrodesulfurization and Hydrodenitrogenation
- Improved Rate Laws and Population Balance Simulation Methods; CRE Applications, Including the Combustion Synthesis of Valuable Nano-Particles
- VPO Transient Oxidation Kinetics
- Cluster-Based Modeling of Fluidized Catalytic Oxidation of n-Butane to Maleic Anhydride
- New Wet Flue Gas Desulfurization Process Using Granular Limestone and Organic Acid Additives
- Axial and Radial Investigation of Hydrodynamics in a Bubble Column; Influence of Fluids Flow Rates and Sparger Type
- A Numerical Algorithm for the Analysis of the Bubble Dynamics in Two-Dimensional Fluidized Beds Simulated by Means of CFD Multiphase-Flow Codes
- Computational Fluid Dynamics (CFD) Modeling of Fine Particle Spouting
- Effect of Silica Support on V-Mg-O Catalysts during ODH of Propane: Experimental and Modeling using Genetic Algorithms
- Well Dispersed Co0 by Reduction of LaCoO3 Perovskite
- Improvement of the Performances of a Gas-Inducing System for Application in Wastewater Treatment
- Catalytic Cracking of Plastic Pyrolysis Waxes with Vacuum Gasoil: Effect of HZSM-5 Zeolite in the FCC Catalyst
- Esterification of Palmitic Acid with Iso-Propanol in a Catalytic Distillation Column: Modeling and Simulation Studies
- Synthesis of SiO2 Nanoparticles in RF Plasma Reactors: Effect of Feed Rate and Quench Gas Injection
- Pd Supported on Ce/Zr Mixed Oxides in the Reduction of NO with Propylene in Oxidizing Conditions
- Effects of Design and Operating Parameters on Hydrodynamics of Circulating Bubble Columns with Open Channel Gas Separators
- Kinetics and Modelling of Bulk and Solution Diallyl Terephthalate Polymerization
- Reactor Model for the Underground Coal Gasification (UCG) Channel
- Study and Improvement of the Regeneration of Metallic Oxides Used as Oxygen Carriers for a New Combustion Process
- Short Communication or Note
- Dehydrogenation of Ethane and Hydrogenation of Carbon Dioxide in a Catalytic Membrane Reactor Using Copper-Plated LaNi5 as a Membrane Material
- Short Communication or Note
- Stabilization of a CSTR in an Oscillatory State by Varying the Thermal Characteristics of the Reactor Vessel
Articles in the same Issue
- Review
- Practical Implications of Bifurcation and Chaos in Chemical and Biological Reaction Engineering
- Article
- Optimization of Bacterial Oxidation Process Parameters for Selective Leaching of Nickel by Thiobacillus Ferrooxidans
- Direct Numerical Simulation of Mass Transfer from Spherical Bubbles: the Effect of Interface Contamination at Low Reynolds Numbers
- Plasma-Prepared Ni/Al2O3: Preparation, Characterization and Toluene Hydrogenation
- Flow Induced by Dual-Turbine of Different Diameters in a Gas-Liquid Agitation System: the Agitation and Turbulence Indices
- A Comprehensive Model for Catalytic Membrane Reactor
- A Structured Model for Interleukin-11 Production with Recombinant E.coli and Genetic Algorithm for Model Parameter Estimation
- Calorimetry for Inferential Conversion Monitoring in Emulsion Copolymerization Reactors
- Identification of the State of a Magneto-Fluidized Bed by Pressure Fluctuations
- Modeling a Silicon CVD Spouted Bed Pilot Plant Reactor
- Intercooled Double-Bed Reactor for LTWGS Reaction with Catalyst Poisoning by Chlorine: Inlet Temperatures for the Maximization of the Production
- Comprehensive Modeling of Gas Fluidized-Bed Reactors Allowing for Transients, Multiple Flow Regimes and Selective Removal of Species
- Isothermal PFR/PMR Networks
- Influence of Particles and Electrolyte on Gas Hold-Up and Mass Transfer in a Slurry Bubble Column
- Three Phase Catalytic Reactions: Role of Omega Aqueous Phase in Solid-Liquid Phase Transfer Catalyzed Etherification of 2'- Hydroxy Acetophenone
- Treatment of Cork Wastes in a Conical Spouted Bed Reactor
- Biosorption of Combined Industrial Effluents using Phanerochaete Chrysosporium
- Kinetics of Liquid - Phase Hydrogenation of Straight Chain C10 to C13 Di-Olefins Over Ni/Al2O3 Catalyst
- Kinetics of H2S Sorption on Manganese Oxide and Mn-Fe-Cu Mixed Oxide Prepared by the Complexation Technique
- Design of a Fuel Cell Power System for Automotive Applications
- Simulation of a Two-Stage Micro Trickle-Bed Hydrotreating Reactor using Athabasca Bitumen-Derived Heavy Gas Oil over Commercial NiMo/Al2O3 Catalyst: Effect of H2S on Hydrodesulfurization and Hydrodenitrogenation
- Improved Rate Laws and Population Balance Simulation Methods; CRE Applications, Including the Combustion Synthesis of Valuable Nano-Particles
- VPO Transient Oxidation Kinetics
- Cluster-Based Modeling of Fluidized Catalytic Oxidation of n-Butane to Maleic Anhydride
- New Wet Flue Gas Desulfurization Process Using Granular Limestone and Organic Acid Additives
- Axial and Radial Investigation of Hydrodynamics in a Bubble Column; Influence of Fluids Flow Rates and Sparger Type
- A Numerical Algorithm for the Analysis of the Bubble Dynamics in Two-Dimensional Fluidized Beds Simulated by Means of CFD Multiphase-Flow Codes
- Computational Fluid Dynamics (CFD) Modeling of Fine Particle Spouting
- Effect of Silica Support on V-Mg-O Catalysts during ODH of Propane: Experimental and Modeling using Genetic Algorithms
- Well Dispersed Co0 by Reduction of LaCoO3 Perovskite
- Improvement of the Performances of a Gas-Inducing System for Application in Wastewater Treatment
- Catalytic Cracking of Plastic Pyrolysis Waxes with Vacuum Gasoil: Effect of HZSM-5 Zeolite in the FCC Catalyst
- Esterification of Palmitic Acid with Iso-Propanol in a Catalytic Distillation Column: Modeling and Simulation Studies
- Synthesis of SiO2 Nanoparticles in RF Plasma Reactors: Effect of Feed Rate and Quench Gas Injection
- Pd Supported on Ce/Zr Mixed Oxides in the Reduction of NO with Propylene in Oxidizing Conditions
- Effects of Design and Operating Parameters on Hydrodynamics of Circulating Bubble Columns with Open Channel Gas Separators
- Kinetics and Modelling of Bulk and Solution Diallyl Terephthalate Polymerization
- Reactor Model for the Underground Coal Gasification (UCG) Channel
- Study and Improvement of the Regeneration of Metallic Oxides Used as Oxygen Carriers for a New Combustion Process
- Short Communication or Note
- Dehydrogenation of Ethane and Hydrogenation of Carbon Dioxide in a Catalytic Membrane Reactor Using Copper-Plated LaNi5 as a Membrane Material
- Short Communication or Note
- Stabilization of a CSTR in an Oscillatory State by Varying the Thermal Characteristics of the Reactor Vessel