Article
Licensed
Unlicensed
Requires Authentication
Catalytic Cracking of Plastic Pyrolysis Waxes with Vacuum Gasoil: Effect of HZSM-5 Zeolite in the FCC Catalyst
-
Iker Torre
Published/Copyright:
August 16, 2006
Catalytic cracking of waste plastics is an interesting option for selectively recovering raw materials or for obtaining fuels. In this paper, a new recycling strategy is proposed, which consists of upgrading the waxes obtained by flash pyrolysis of polyolefins in a FCC (Fluidized Catalytic Cracking) unit. The waxes have been obtained by flash pyrolysis of polypropylene at 500 ºC and they have been dissolved (20 wt% wax) in the vacuum gasoil (VGO) of a FCC unit. The runs have been carried out in a CREC-UWO Riser Simulator Reactor (atmospheric pressure; 500-550 ºC; C/O = 5.5; contact times, 3-12 s). A commercial catalyst and a hybrid one (containing HZSM-5 zeolite) have been used. The cracking of the mixture leads to higher yield of gasoline than in the cracking of VGO with a higher content of olefins. The results of the effect of the operating conditions (temperature and contact time) are qualitatively similar to those corresponding to standard feed. Consequently, no difficulties inherent to the presence of waxes in the feed are expected in the treatment of mixtures at industrial conditions. The presence of HZSM-5 zeolite in the catalyst causes a significant increase in the amount of LPG (especially C3-C4 olefins), at the expense of a decrease in the gasoline fraction, whose RON is 1-2 points higher than that corresponding to the commercial catalyst. The gasoline obtained also has a higher content of olefins (especially C5-C7) and benzene at the expense of a decrease in the amount of C6-C10 i-paraffins.
Published Online: 2006-8-16
©2011 Walter de Gruyter GmbH & Co. KG, Berlin/Boston
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Review
- Practical Implications of Bifurcation and Chaos in Chemical and Biological Reaction Engineering
- Article
- Optimization of Bacterial Oxidation Process Parameters for Selective Leaching of Nickel by Thiobacillus Ferrooxidans
- Direct Numerical Simulation of Mass Transfer from Spherical Bubbles: the Effect of Interface Contamination at Low Reynolds Numbers
- Plasma-Prepared Ni/Al2O3: Preparation, Characterization and Toluene Hydrogenation
- Flow Induced by Dual-Turbine of Different Diameters in a Gas-Liquid Agitation System: the Agitation and Turbulence Indices
- A Comprehensive Model for Catalytic Membrane Reactor
- A Structured Model for Interleukin-11 Production with Recombinant E.coli and Genetic Algorithm for Model Parameter Estimation
- Calorimetry for Inferential Conversion Monitoring in Emulsion Copolymerization Reactors
- Identification of the State of a Magneto-Fluidized Bed by Pressure Fluctuations
- Modeling a Silicon CVD Spouted Bed Pilot Plant Reactor
- Intercooled Double-Bed Reactor for LTWGS Reaction with Catalyst Poisoning by Chlorine: Inlet Temperatures for the Maximization of the Production
- Comprehensive Modeling of Gas Fluidized-Bed Reactors Allowing for Transients, Multiple Flow Regimes and Selective Removal of Species
- Isothermal PFR/PMR Networks
- Influence of Particles and Electrolyte on Gas Hold-Up and Mass Transfer in a Slurry Bubble Column
- Three Phase Catalytic Reactions: Role of Omega Aqueous Phase in Solid-Liquid Phase Transfer Catalyzed Etherification of 2'- Hydroxy Acetophenone
- Treatment of Cork Wastes in a Conical Spouted Bed Reactor
- Biosorption of Combined Industrial Effluents using Phanerochaete Chrysosporium
- Kinetics of Liquid - Phase Hydrogenation of Straight Chain C10 to C13 Di-Olefins Over Ni/Al2O3 Catalyst
- Kinetics of H2S Sorption on Manganese Oxide and Mn-Fe-Cu Mixed Oxide Prepared by the Complexation Technique
- Design of a Fuel Cell Power System for Automotive Applications
- Simulation of a Two-Stage Micro Trickle-Bed Hydrotreating Reactor using Athabasca Bitumen-Derived Heavy Gas Oil over Commercial NiMo/Al2O3 Catalyst: Effect of H2S on Hydrodesulfurization and Hydrodenitrogenation
- Improved Rate Laws and Population Balance Simulation Methods; CRE Applications, Including the Combustion Synthesis of Valuable Nano-Particles
- VPO Transient Oxidation Kinetics
- Cluster-Based Modeling of Fluidized Catalytic Oxidation of n-Butane to Maleic Anhydride
- New Wet Flue Gas Desulfurization Process Using Granular Limestone and Organic Acid Additives
- Axial and Radial Investigation of Hydrodynamics in a Bubble Column; Influence of Fluids Flow Rates and Sparger Type
- A Numerical Algorithm for the Analysis of the Bubble Dynamics in Two-Dimensional Fluidized Beds Simulated by Means of CFD Multiphase-Flow Codes
- Computational Fluid Dynamics (CFD) Modeling of Fine Particle Spouting
- Effect of Silica Support on V-Mg-O Catalysts during ODH of Propane: Experimental and Modeling using Genetic Algorithms
- Well Dispersed Co0 by Reduction of LaCoO3 Perovskite
- Improvement of the Performances of a Gas-Inducing System for Application in Wastewater Treatment
- Catalytic Cracking of Plastic Pyrolysis Waxes with Vacuum Gasoil: Effect of HZSM-5 Zeolite in the FCC Catalyst
- Esterification of Palmitic Acid with Iso-Propanol in a Catalytic Distillation Column: Modeling and Simulation Studies
- Synthesis of SiO2 Nanoparticles in RF Plasma Reactors: Effect of Feed Rate and Quench Gas Injection
- Pd Supported on Ce/Zr Mixed Oxides in the Reduction of NO with Propylene in Oxidizing Conditions
- Effects of Design and Operating Parameters on Hydrodynamics of Circulating Bubble Columns with Open Channel Gas Separators
- Kinetics and Modelling of Bulk and Solution Diallyl Terephthalate Polymerization
- Reactor Model for the Underground Coal Gasification (UCG) Channel
- Study and Improvement of the Regeneration of Metallic Oxides Used as Oxygen Carriers for a New Combustion Process
- Short Communication or Note
- Dehydrogenation of Ethane and Hydrogenation of Carbon Dioxide in a Catalytic Membrane Reactor Using Copper-Plated LaNi5 as a Membrane Material
- Short Communication or Note
- Stabilization of a CSTR in an Oscillatory State by Varying the Thermal Characteristics of the Reactor Vessel
Articles in the same Issue
- Review
- Practical Implications of Bifurcation and Chaos in Chemical and Biological Reaction Engineering
- Article
- Optimization of Bacterial Oxidation Process Parameters for Selective Leaching of Nickel by Thiobacillus Ferrooxidans
- Direct Numerical Simulation of Mass Transfer from Spherical Bubbles: the Effect of Interface Contamination at Low Reynolds Numbers
- Plasma-Prepared Ni/Al2O3: Preparation, Characterization and Toluene Hydrogenation
- Flow Induced by Dual-Turbine of Different Diameters in a Gas-Liquid Agitation System: the Agitation and Turbulence Indices
- A Comprehensive Model for Catalytic Membrane Reactor
- A Structured Model for Interleukin-11 Production with Recombinant E.coli and Genetic Algorithm for Model Parameter Estimation
- Calorimetry for Inferential Conversion Monitoring in Emulsion Copolymerization Reactors
- Identification of the State of a Magneto-Fluidized Bed by Pressure Fluctuations
- Modeling a Silicon CVD Spouted Bed Pilot Plant Reactor
- Intercooled Double-Bed Reactor for LTWGS Reaction with Catalyst Poisoning by Chlorine: Inlet Temperatures for the Maximization of the Production
- Comprehensive Modeling of Gas Fluidized-Bed Reactors Allowing for Transients, Multiple Flow Regimes and Selective Removal of Species
- Isothermal PFR/PMR Networks
- Influence of Particles and Electrolyte on Gas Hold-Up and Mass Transfer in a Slurry Bubble Column
- Three Phase Catalytic Reactions: Role of Omega Aqueous Phase in Solid-Liquid Phase Transfer Catalyzed Etherification of 2'- Hydroxy Acetophenone
- Treatment of Cork Wastes in a Conical Spouted Bed Reactor
- Biosorption of Combined Industrial Effluents using Phanerochaete Chrysosporium
- Kinetics of Liquid - Phase Hydrogenation of Straight Chain C10 to C13 Di-Olefins Over Ni/Al2O3 Catalyst
- Kinetics of H2S Sorption on Manganese Oxide and Mn-Fe-Cu Mixed Oxide Prepared by the Complexation Technique
- Design of a Fuel Cell Power System for Automotive Applications
- Simulation of a Two-Stage Micro Trickle-Bed Hydrotreating Reactor using Athabasca Bitumen-Derived Heavy Gas Oil over Commercial NiMo/Al2O3 Catalyst: Effect of H2S on Hydrodesulfurization and Hydrodenitrogenation
- Improved Rate Laws and Population Balance Simulation Methods; CRE Applications, Including the Combustion Synthesis of Valuable Nano-Particles
- VPO Transient Oxidation Kinetics
- Cluster-Based Modeling of Fluidized Catalytic Oxidation of n-Butane to Maleic Anhydride
- New Wet Flue Gas Desulfurization Process Using Granular Limestone and Organic Acid Additives
- Axial and Radial Investigation of Hydrodynamics in a Bubble Column; Influence of Fluids Flow Rates and Sparger Type
- A Numerical Algorithm for the Analysis of the Bubble Dynamics in Two-Dimensional Fluidized Beds Simulated by Means of CFD Multiphase-Flow Codes
- Computational Fluid Dynamics (CFD) Modeling of Fine Particle Spouting
- Effect of Silica Support on V-Mg-O Catalysts during ODH of Propane: Experimental and Modeling using Genetic Algorithms
- Well Dispersed Co0 by Reduction of LaCoO3 Perovskite
- Improvement of the Performances of a Gas-Inducing System for Application in Wastewater Treatment
- Catalytic Cracking of Plastic Pyrolysis Waxes with Vacuum Gasoil: Effect of HZSM-5 Zeolite in the FCC Catalyst
- Esterification of Palmitic Acid with Iso-Propanol in a Catalytic Distillation Column: Modeling and Simulation Studies
- Synthesis of SiO2 Nanoparticles in RF Plasma Reactors: Effect of Feed Rate and Quench Gas Injection
- Pd Supported on Ce/Zr Mixed Oxides in the Reduction of NO with Propylene in Oxidizing Conditions
- Effects of Design and Operating Parameters on Hydrodynamics of Circulating Bubble Columns with Open Channel Gas Separators
- Kinetics and Modelling of Bulk and Solution Diallyl Terephthalate Polymerization
- Reactor Model for the Underground Coal Gasification (UCG) Channel
- Study and Improvement of the Regeneration of Metallic Oxides Used as Oxygen Carriers for a New Combustion Process
- Short Communication or Note
- Dehydrogenation of Ethane and Hydrogenation of Carbon Dioxide in a Catalytic Membrane Reactor Using Copper-Plated LaNi5 as a Membrane Material
- Short Communication or Note
- Stabilization of a CSTR in an Oscillatory State by Varying the Thermal Characteristics of the Reactor Vessel
