Startseite Kinetics of H2S Sorption on Manganese Oxide and Mn-Fe-Cu Mixed Oxide Prepared by the Complexation Technique
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

Kinetics of H2S Sorption on Manganese Oxide and Mn-Fe-Cu Mixed Oxide Prepared by the Complexation Technique

  • Pinar Caglayan , Sena Yasyerli , Irfan Ar , Gulsen Dogu und Timur Dogu
Veröffentlicht/Copyright: 11. April 2006
Veröffentlichen auch Sie bei De Gruyter Brill

Hydrogen sulfide sorption activities of manganese oxide and Mn-Fe-Cu mixed oxide sorbents were examined in a fixed bed reactor. Sulfur retention capacity of Mn-O sorbent was found to be quite high at 600 °C both in the absence and presence of hydrogen gas (0.17 and 0.14 g S/g sorbent, respectively). This sorbent has a high porosity and a relatively high surface area. Best regeneration temperature of this sorbent was found as 700 °C, with a gas stream containing 6% oxygen in nitrogen. Mn-Fe-Cu mixed oxide sorbent had a lower sulfur retention capacity (0.07 g S/g sorbent). However, both of these sorbents gave quite high initial sorption rate constants, resulting very sharp breakthrough curves. Deactivation model was shown to give good agreement with the experimental H2S breakthrough curves.

Published Online: 2006-4-11

©2011 Walter de Gruyter GmbH & Co. KG, Berlin/Boston

Artikel in diesem Heft

  1. Review
  2. Practical Implications of Bifurcation and Chaos in Chemical and Biological Reaction Engineering
  3. Article
  4. Optimization of Bacterial Oxidation Process Parameters for Selective Leaching of Nickel by Thiobacillus Ferrooxidans
  5. Direct Numerical Simulation of Mass Transfer from Spherical Bubbles: the Effect of Interface Contamination at Low Reynolds Numbers
  6. Plasma-Prepared Ni/Al2O3: Preparation, Characterization and Toluene Hydrogenation
  7. Flow Induced by Dual-Turbine of Different Diameters in a Gas-Liquid Agitation System: the Agitation and Turbulence Indices
  8. A Comprehensive Model for Catalytic Membrane Reactor
  9. A Structured Model for Interleukin-11 Production with Recombinant E.coli and Genetic Algorithm for Model Parameter Estimation
  10. Calorimetry for Inferential Conversion Monitoring in Emulsion Copolymerization Reactors
  11. Identification of the State of a Magneto-Fluidized Bed by Pressure Fluctuations
  12. Modeling a Silicon CVD Spouted Bed Pilot Plant Reactor
  13. Intercooled Double-Bed Reactor for LTWGS Reaction with Catalyst Poisoning by Chlorine: Inlet Temperatures for the Maximization of the Production
  14. Comprehensive Modeling of Gas Fluidized-Bed Reactors Allowing for Transients, Multiple Flow Regimes and Selective Removal of Species
  15. Isothermal PFR/PMR Networks
  16. Influence of Particles and Electrolyte on Gas Hold-Up and Mass Transfer in a Slurry Bubble Column
  17. Three Phase Catalytic Reactions: Role of Omega Aqueous Phase in Solid-Liquid Phase Transfer Catalyzed Etherification of 2'- Hydroxy Acetophenone
  18. Treatment of Cork Wastes in a Conical Spouted Bed Reactor
  19. Biosorption of Combined Industrial Effluents using Phanerochaete Chrysosporium
  20. Kinetics of Liquid - Phase Hydrogenation of Straight Chain C10 to C13 Di-Olefins Over Ni/Al2O3 Catalyst
  21. Kinetics of H2S Sorption on Manganese Oxide and Mn-Fe-Cu Mixed Oxide Prepared by the Complexation Technique
  22. Design of a Fuel Cell Power System for Automotive Applications
  23. Simulation of a Two-Stage Micro Trickle-Bed Hydrotreating Reactor using Athabasca Bitumen-Derived Heavy Gas Oil over Commercial NiMo/Al2O3 Catalyst: Effect of H2S on Hydrodesulfurization and Hydrodenitrogenation
  24. Improved Rate Laws and Population Balance Simulation Methods; CRE Applications, Including the Combustion Synthesis of Valuable Nano-Particles
  25. VPO Transient Oxidation Kinetics
  26. Cluster-Based Modeling of Fluidized Catalytic Oxidation of n-Butane to Maleic Anhydride
  27. New Wet Flue Gas Desulfurization Process Using Granular Limestone and Organic Acid Additives
  28. Axial and Radial Investigation of Hydrodynamics in a Bubble Column; Influence of Fluids Flow Rates and Sparger Type
  29. A Numerical Algorithm for the Analysis of the Bubble Dynamics in Two-Dimensional Fluidized Beds Simulated by Means of CFD Multiphase-Flow Codes
  30. Computational Fluid Dynamics (CFD) Modeling of Fine Particle Spouting
  31. Effect of Silica Support on V-Mg-O Catalysts during ODH of Propane: Experimental and Modeling using Genetic Algorithms
  32. Well Dispersed Co0 by Reduction of LaCoO3 Perovskite
  33. Improvement of the Performances of a Gas-Inducing System for Application in Wastewater Treatment
  34. Catalytic Cracking of Plastic Pyrolysis Waxes with Vacuum Gasoil: Effect of HZSM-5 Zeolite in the FCC Catalyst
  35. Esterification of Palmitic Acid with Iso-Propanol in a Catalytic Distillation Column: Modeling and Simulation Studies
  36. Synthesis of SiO2 Nanoparticles in RF Plasma Reactors: Effect of Feed Rate and Quench Gas Injection
  37. Pd Supported on Ce/Zr Mixed Oxides in the Reduction of NO with Propylene in Oxidizing Conditions
  38. Effects of Design and Operating Parameters on Hydrodynamics of Circulating Bubble Columns with Open Channel Gas Separators
  39. Kinetics and Modelling of Bulk and Solution Diallyl Terephthalate Polymerization
  40. Reactor Model for the Underground Coal Gasification (UCG) Channel
  41. Study and Improvement of the Regeneration of Metallic Oxides Used as Oxygen Carriers for a New Combustion Process
  42. Short Communication or Note
  43. Dehydrogenation of Ethane and Hydrogenation of Carbon Dioxide in a Catalytic Membrane Reactor Using Copper-Plated LaNi5 as a Membrane Material
  44. Short Communication or Note
  45. Stabilization of a CSTR in an Oscillatory State by Varying the Thermal Characteristics of the Reactor Vessel
Heruntergeladen am 8.9.2025 von https://www.degruyterbrill.com/document/doi/10.2202/1542-6580.1312/html
Button zum nach oben scrollen