Masthead

Articles in the same Issue

1. Masthead
2. Effect of Some Lubricants on the Flow Characteristics of ‘EPDM’ Rubber Under Compressive Load
3. Friction Stir Welds of AA6351-T6 and AA2024-T6 Dissimiler Aluminium Alloys
4. Effect of Welding Parameters on Pitting Corrosion Rate in 3.5N NaCl of Pulsed Current Micro Plasma Arc Welded AISI 304L Sheets
5. An Investigation of Flank Wear Land Inclination in Orthogonal Machining
6. Modeling of Radial Over Cut in Electrochemical Machining of Al-B₄C MMC Using Response Surface Methodology
7. Fundamental Research on a Rational Steelmaking Slag Recycling System by Phosphorus Separation and Collection
8. KTH Steel Scrap Model – Iron and Steel Flow in the Swedish Society 1889–2010
9. Direct Electrochemical Reduction of Titanium-Bearing Compounds to Titanium-Silicon Alloys in Molten Calcium Chloride
10. In Situ Observation of the Evolution of Intragranular Acicular Ferrite at Mg-containing Inclusions in 16Mn Steel
11. The Physical Properties of Slags for Electro-slag Remelting in CaF₂-CaO-Al₂O₃-SiO₂ System
12. Freeze-lining Formation and Microstructure in a Direct-to-blister Flash Smelting Slag
13. The Mechanism of Dross Formation during Hot-dip Al-Zn Alloy Coating Process
14. Solidification Behaviour of Slags: The Single Hot Thermocouple Technique
15. Investigation of Continuous Casting Slag Films Sampled on Site and Comparison with Laboratory Results
16. Thermal Conductivity of R-Na₂O-SiO₂ (R = Al₂O₃, CaO) Melts
17. Investigation of Blowing High Silicon Hot Metal by Double Slag Process
18. An Investigation of Electro-deoxidation Process for Producing Titanium from Dense Titanium Dioxide Cathode
19. Interaction between Molten Steel, Alumina Lining Refractory and Slag Phase