Home Magnetoplasticity
Article
Licensed
Unlicensed Requires Authentication

Magnetoplasticity

  • Gernot Kostorz and Peter Müllner
Published/Copyright: February 16, 2022
Become an author with De Gruyter Brill
Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 96 Issue 7

Abstract

Magnetocrystalline anisotropy and twinned microstructure are at the origin of the appreciable magnetic-field-induced strains found in some ferromagnetic thermoelastic martensites. The change of magnetization across the twinning plane leads to a force on the twinning dislocations when a magnetic field is applied. The sensitivity of this basic microscopic mechanism not only to crystallographic and magnetic properties of the material, but also to microstructural details, leads to a large variance in the macroscopically attainable magnetic-field-induced strains, while the maximum strain is fixed for any given martensite structure. The magnetic-field-induced deformation of Ni–Mn–Ga single crystals was studied in uniaxial (“static”) and rotating (“dynamic”) magnetic fields. The spatial and orientational distribution of martensite domains, twin thickness and mutual interactions between twinning dislocations all contribute to the macroscopic result.

Keywords: Magnetocrystalline anisotropy; Shape memory; Twinning; Magnetic shape memory; Magnetostrain
Prof. Gernot Kostorz ETH Zürich, Angewandte Physik CH-8093 Zürich, Switzerland Tel.: +41 1 633 3399 Fax: +41 1 633 1105

Dedicated to Professor Dr.-Ing. habil. Dr. h. c. Heinrich Oettel on the occasion of his 65th birthday

References

[1] R.C. O’Handley: Modern Magnetic Materials, John Wiley and Sons, Inc., New York (2000).Search in Google Scholar

[2] A.N. Lavrov, S. Komiya, Y. Ando: Nature 418 (2002) 385.10.1038/418385aSearch in Google Scholar

[3] P. Müllner, V.A. Chernenko, M. Wollgarten, G. Kostorz: J. Appl. Phys. 92 (2002) 6708.10.1063/1.1513875Search in Google Scholar

[4] P. Müllner, K. Ullakko: Phys. Stat. Sol. B 208 (1998) R1.10.1002/(SICI)1521-3951(199807)208:1<R1::AID-PSSB99991>3.0.CO;2-4Search in Google Scholar

[5] R. Tickle, R.D. James: J. Magn. Magn. Mater. 195 (1999) 627.10.1016/S0304-8853(99)00292-9Search in Google Scholar

[6] K. Ullakko, J.K. Huang, C. Kantner, R.C. O’Handley, V.V. Koko-rin: Appl. Phys. Lett. 69 (1996) 1966.10.1063/1.117637Search in Google Scholar

[7] R.D. James, M. Wuttig: Phil. Mag. A 77 (1998) 1273.10.1080/01418619808214252Search in Google Scholar

[8] R.D. James, R. Tickle, M. Wuttig: Mater. Sci. Eng. A 273 (1999) 320.10.1016/S0921-5093(99)00364-0Search in Google Scholar

[9] J. Pons, V.A. Chernenko, R. Santamarta, E. Cesari: Acta Mater. 48 (2000) 3027.10.1016/S1359-6454(00)00130-0Search in Google Scholar

[10] A. Sozinov, A.A. Likhachev, N. Lanska, K. Ullakko, V.K. Lindroos: J. Phys. IV France 112 (2003) 955.10.1051/jp4:20031039Search in Google Scholar

[11] O. Söderberg, M. Friman, A. Sozinov, N. Lanska, Y. Ge, M. Hä-mäläinen, V.K. Lindroos: Z. Metallkd. 95 (2004) 724.10.1515/ijmr-2004-0134Search in Google Scholar

[12] H.E. Karaca, I. Karaman, Y.I. Chumlyakov, D.C. Lagoudas, X. Zhang: Scripta Mater. 51 (2004) 261.10.1016/j.scriptamat.2004.04.002Search in Google Scholar

[13] J.J. Rhyne, A.E. Clark: J. Appl. Phys. 38 (1967) 1379.10.1063/1.1709631Search in Google Scholar

[14] J.J. Rhyne, S. Foner, E.J. McNiff, R. Doclo: J. Appl. Phys. 39 (1968) 892.10.1063/1.1656324Search in Google Scholar

[15] S. Chikazumi, S. Tanuma, L. Oguro, F. Ono, K. Tajima: IEEE Trans. Mag. 5 (1969) 265.10.1109/TMAG.1969.1066538Search in Google Scholar

[16] H.H. Liebermann, C.D. Graham, Jr., in: J.J. Becker, G.H. Lander, J.J. Rhyne (Eds.), Magnetism and Magnetic Materials 1975, AIP Conf. Proc. 29, AIP, New York (1976), p. 598.10.1063/1.30473Search in Google Scholar

[17] K. Otsuka, T. Ohba, M. Tokonami, C.M. Wayman: Scripta Metall. Mater. 29 (1993) 1359.10.1016/0956-716X(93)90139-JSearch in Google Scholar

[18] V.A. Chernenko, V.A. L’vov, P. Müllner, G. Kostorz, T. Takagi: Phys. Rev. B 69 (2004) 134410.10.1103/PhysRevB.69.134410Search in Google Scholar

[19] S.J. Murray, M. Marioni, S.M. Allen, R.C. O’Handley, T.A. Lograsso: Appl. Phys. Lett. 77 (2000) 886.10.1063/1.1306635Search in Google Scholar

[20] P. Müllner, V.A. Chernenko, G. Kostorz: J. Appl. Phys. 95 (2004) 1531.10.1063/1.1639144Search in Google Scholar

[21] P. Müllner, V.A. Chernenko, G. Kostorz: Scripta Mater. 49 (2003) 129.10.1016/S1359-6462(03)00219-7Search in Google Scholar

[22] P. Müllner, V.A. Chernenko, D. Mukherji, G. Kostorz, in Y. Furuya, E. Quandt, Q. Zhang, K. Inoue, M. Shahinpoor (Eds.), Materials and Devices for Smart Systems, Mater. Res. Soc. Symp. Proc. Vol. 785, MRS Warrendale, OH, USA (2004), p. 415.10.1557/PROC-785-D12.2Search in Google Scholar

[23] S.V. Kamat, J.P. Hirth, P. Müllner: Phil. Mag. A 73 (1996) 669.10.1080/01418619608242989Search in Google Scholar

[24] P. Müllner: Sol. State Phenom. 87 (2002) 227.10.4028/www.scientific.net/SSP.87.227Search in Google Scholar
Received: 2004-10-27
Accepted: 2005-01-26
Published Online: 2022-02-16

© 2005 Carl Hanser Verlag, München

Articles in the same Issue

  1. Frontmatter
  2. Editorial
  3. Heinrich Oettel – 65 Jahre
  4. Articles Basic
  5. Misorientations and geometrically necessary dislocations in deformed copper crystals: A microstructural analysis of X-ray rocking curves
  6. Microstructure and lattice defects in highly deformed metals by X-ray diffraction whole powder pattern modelling
  7. Magnetoplasticity
  8. Articles Applied
  9. Finite-element analysis of the hot-pressing consolidation of continuous Al2O3 fibers-reinforced NiAl composites
  10. Modelling the stress state of a thermal barrier coating system at high temperatures
  11. Impedance spectroscopy of thermal barrier coatings as non-destructive evaluation tool for failure detection
  12. Diffraction by image processing and its application in materials science
  13. On the preferred orientation in Ti1–xAlxN and Ti1–x–yAlxSiyN thin films
  14. Boron segregation and creep in ultra-fine grained tempered martensite ferritic steels
  15. Numeric simulation of the α/γ-phase ratio of ferritic-austenitic duplex steels
  16. Deformation behaviour and microscopic investigations of cyclically loaded railway wheels and tyres
  17. Similarity considerations on the simulation of turning processes of steels
  18. Crack-tip residual stresses and crack propagation in cyclically-loaded specimens under different loading modes
  19. On the effect of oxide scale stability on the internal nitridation process in high-temperature alloys
  20. Nitriding behaviour of the intermetallic alloy FeAl
  21. Material-related fundamentals of cutting techniques for GaAs wafer manufacturing
  22. Determination of RuAl phase boundaries in binary Ru–Al phase diagram at room temperature and 1200 °C
  23. On the Orowan stress in intermetallic ODS alloys and its superposition with grain size and solid solution hardening
  24. Effects of particle reinforcement on creep behaviour of AlSi1MgCu
  25. Effect of preaging on the precipitation behaviour of AlMgSi1
  26. Corrosion behaviour of hard coatings on Mg substrates
  27. Phase transformations in creep resistant MgYNdScMn alloy
  28. Notifications/Mitteilungen
  29. Personal/Personelles
  30. Press/Presse
  31. Conferences
https://doi.org/10.1515/ijmr-2005-0124
Keywords for this article
Magnetocrystalline anisotropy; Shape memory; Twinning; Magnetic shape memory; Magnetostrain

Articles in the same Issue

  1. Frontmatter
  2. Editorial
  3. Heinrich Oettel – 65 Jahre
  4. Articles Basic
  5. Misorientations and geometrically necessary dislocations in deformed copper crystals: A microstructural analysis of X-ray rocking curves
  6. Microstructure and lattice defects in highly deformed metals by X-ray diffraction whole powder pattern modelling
  7. Magnetoplasticity
  8. Articles Applied
  9. Finite-element analysis of the hot-pressing consolidation of continuous Al2O3 fibers-reinforced NiAl composites
  10. Modelling the stress state of a thermal barrier coating system at high temperatures
  11. Impedance spectroscopy of thermal barrier coatings as non-destructive evaluation tool for failure detection
  12. Diffraction by image processing and its application in materials science
  13. On the preferred orientation in Ti1–xAlxN and Ti1–x–yAlxSiyN thin films
  14. Boron segregation and creep in ultra-fine grained tempered martensite ferritic steels
  15. Numeric simulation of the α/γ-phase ratio of ferritic-austenitic duplex steels
  16. Deformation behaviour and microscopic investigations of cyclically loaded railway wheels and tyres
  17. Similarity considerations on the simulation of turning processes of steels
  18. Crack-tip residual stresses and crack propagation in cyclically-loaded specimens under different loading modes
  19. On the effect of oxide scale stability on the internal nitridation process in high-temperature alloys
  20. Nitriding behaviour of the intermetallic alloy FeAl
  21. Material-related fundamentals of cutting techniques for GaAs wafer manufacturing
  22. Determination of RuAl phase boundaries in binary Ru–Al phase diagram at room temperature and 1200 °C
  23. On the Orowan stress in intermetallic ODS alloys and its superposition with grain size and solid solution hardening
  24. Effects of particle reinforcement on creep behaviour of AlSi1MgCu
  25. Effect of preaging on the precipitation behaviour of AlMgSi1
  26. Corrosion behaviour of hard coatings on Mg substrates
  27. Phase transformations in creep resistant MgYNdScMn alloy
  28. Notifications/Mitteilungen
  29. Personal/Personelles
  30. Press/Presse
  31. Conferences
Sign up now to receive a 20% welcome discount
Institutional Access
How does access work?
Have an idea on how to improve our website?
Please write us.
© 2025 De Gruyter Brill
Downloaded on 29.10.2025 from https://www.degruyterbrill.com/document/doi/10.1515/ijmr-2005-0124/html?lang=en
Scroll to top button