Olefins and Ethanol from Polyolefins: Analysis of Potential Chemical Recycling of Poly(ethylene) Mexican Case
-
A. Vargas Santillán
Abstract
Plastic solid waste (PSW) presents challenges and opportunities to society regardless of their sustainability awareness and technological advances. A special emphasis is paid on waste generated from polyolefin sources, which makes up a great percentage of our daily commodities’ plastic products. In Mexico 7.6 millions of tons of plastic in 2012 were wasted, which low density polyethylene LDPE, and high density polyethylene HDPE were the most abundant. Increasing cost, and decreasing space of landfills are forcing considerations of alternative options for PSW disposal. Years of research, study and testing have resulted in a number of treatment, recycling and recovery methods for plastics that can be economically, and environmentally viable. The following work studies the possibilities of polyethylene recycling. Nowadays, non-catalytic thermal cracking (Pyrolysis) is receiving renewed attention, due to the fact of added value on a crude oil barrel and its very valuable yielded products, but a fact remains that advanced thermo-chemical recycling of polyolefin still lacks the proper design, and kinetic background to target certain desired products and/or chemicals. On the other hand some research have shown a good performance that can be used in a real plant. ASPEN Plus is used to simulate a non-catalytic thermal cracking process. The process behavior of simulation is similar to the experimental data from other authors. Using gibbs free energy to identify the chemical equilibrium in system, its global minimization allows identifying the amount of substances present in the process. The simulation results demonstrate that it could be produced 49 % and 34 % wt of ethylene and propylene respectively from gas yield at 850 °C. Then scale the plant to produce ethylene and propylene from the pyrolysis and ethanol from a direct hydration of ethylene. Aspen Process Economics Analyzer is used in order to find the feasibility of the pyrolysis and ethanol production. The total sales/total production cost ratio obtained for the integrated process approaches was 2.55.
References
1. Al-Salem, S.M., Lettieri, P., Baeyens, J., 2009. Recycling and recovery routes of plastic solid waste (PSW): A review. Waste Management 29, 2625–2643.10.1016/j.wasman.2009.06.004Suche in Google Scholar
2. Al-Salem, S.M., Lettieri, P., Baeyens, J., 2009. Thermal pyrolysis of high density polyethylene (HDPE). In: Proceedings of the Ninth European Gasification Conference: Clean Energy and Chemicals, Düsseldorf, Germany, 23–25 March.Suche in Google Scholar
3. Al-Salem, S.M., Lettieri, P., Baeyens, J., 2009a. Thermal pyrolysis of high density polyethylene (HDPE) In: Proceedings of the Ninth European Gasification Conference: Clean Energy and Chemicals, Düsseldorf, Germany, 23–25 March.Suche in Google Scholar
4. Bilgesu, A.Y., Cetin Kocak, M., Karaduman, J., Kaminsky, W., 2006. A. Waste plastics pyrolysis in free-fall reactors, in: Scheirs (Ed.), Feedstock Recycling and Pyrolysis of Waste Plastics. John Wiley and Sons, Ltd., Hoboken, NJ.10.1002/0470021543.ch23Suche in Google Scholar
5. Conde Ortiz, M.P., 2013. Presente Futuro de la Industria del Plástico en México. Pemex Petroquímica, Ambiente Plástico Revista con Visión Global.Suche in Google Scholar
6. Fernelius, C.W., Wittcoff, H., Varnerin, R.E., 1979. Ethylene: The organic chemical industry’s most important building block. Journal of Chemical Education 56, 385.10.1021/ed056p385Suche in Google Scholar
7. Ghodke, P., Ganesh, A., Mahajani, S., 2015. Stabilization of fast pyrolysis oil derived fromwood through esterification. International Journal of Chemical Reactor Engineering 13, 323–334.10.1515/ijcre-2014-0102Suche in Google Scholar
8. Kaminsky, W., Predel, M., Sadiki, A., 2004. Feedstock recycling of polymers by pyrolysis in a fluidized bed. Polymer Degradation and Stability 85, 1045–1050.10.1016/j.polymdegradstab.2003.05.002Suche in Google Scholar
9. Kaminsky, W., Schlesselmann, B., Simon, C., 1995. Olefins from polyolefins and mixed plastics by pyrolysis. Journal of Analytical and Applied Pyrolysis 32, 19–27.10.1016/0165-2370(94)00830-TSuche in Google Scholar
10. Kannan, P., Shoaibi, A.A., Srinivasakannan, C., 2011. Optimization of Waste Plastics Gasification Process Using Aspen-Plus Chapter 11 INTECH.10.5772/48754Suche in Google Scholar
11. Kannan, P., Shoaibi, A.A., Srinivasakannan, C., 2014. Temperature effects on the yield of gaseous olefins from waste polyethylene via flash pyrolysis. Energy Fuels 28, 3363–3366.10.1021/ef500516nSuche in Google Scholar
12. Kelleher, J.C., MacCormack, J.J., 2004. Internal rate of return: A cautionary tale. Issue of McKinsey on Finan.Suche in Google Scholar
13. Kumar, S., Singh, N., Prasad, R., 2010. Anhydrous ethanol: A renewable source of energy. Renewable and Sustainable Energy Reviews 14, 1830–1844.10.1016/j.rser.2010.03.015Suche in Google Scholar
14. Mastellone, M.L., 1999. Thermal treatments of plastic wastes by means of fluidized bed reactors. Ph.D. Thesis, Department of Chemical Engineering, Second University of Naples, Italy.Suche in Google Scholar
15. Mastral, M., Murillo, R., Callen, M.S., Garcia, T., 1999. Application of coal conversion technology to tire processing. Fuel Process Technology 60, 231–242.10.1016/S0378-3820(99)00048-XSuche in Google Scholar
16. Milne, B.J., Behie, A.L., Berruti, F., 1999. Recycling of waste plastics by ultrapyrolysis using an internally circulated fluidized bed reactor. Journal of Analytical and Applied Pyrolysis 51, 157–166.10.1016/S0165-2370(99)00014-5Suche in Google Scholar
17. Mitta, N.R., Ferrer-Nadal, S., Lazovic, A.M., Parales, J.F., Velo, E., Puigjaner, L., 2006. Modelling and simulation of a tyre gasification plant for synthesis gas production. Computer Aided Chemical Engineering 21, 1771. –1776.10.1016/S1570-7946(06)80304-4Suche in Google Scholar
18. Moncada, J., El-Halwagi, M.M., Cardona, C.A., 2013. Techno-economic analysis for a sugarcane biorefinery: Colombian case. Bioresource Technology 135, 533–543.10.1016/j.biortech.2012.08.137Suche in Google Scholar
19. Paviet, F., Chazarenc, F., Tazerout, M., 2009. Thermo chemical equilibrium modelling of a biomass gasifying process using ASPEN PLUS. International Journal of Chemical Reactor Engineering 7, 18.10.2202/1542-6580.2089Suche in Google Scholar
20. Plasticseurope, 2013. An analysis of European latest plastics production, demand and waste data. Plastics – the Facts, Association of plastics manufacturing. http://www.plasticseurope.org Last view December 2014.Suche in Google Scholar
21. Posada, J.A., Rincón, L.E., Cardona, C.A., 2012. Design and analysis of biorefineries based on raw glycerol: Addressing the glycerol problem. Bioresource Technology 111, 282–293.10.1016/j.biortech.2012.01.151Suche in Google Scholar
22. Ravagnani, M.A.S.S., Reis, M.H.M., Maciel Filho, R., Wolf-Maciel, M.R., 2010. Anhydrous ethanol production by extractive distillation: A solvent case study. Process Safety and Environmental Protection 88, 67–73.10.1016/j.psep.2009.11.005Suche in Google Scholar
23. Rodrigo, A.F., Alvarenga, J.D., 2013. Plastic vs. fuel: Which use of the Brazilian ethanol can bring more environmental gains? Renewable Energy 59, 49–52.10.1016/j.renene.2013.03.029Suche in Google Scholar
24. Sanz Tejedor, A., 2008. Alcoholes de interés industrial. Química Orgánica Industrial, Escuela de Ingenierías Industriales– Uva.Suche in Google Scholar
25. Short, W., Packey, D.J., Holt, T., 1995. A Manual for the Economic Evaluation and Energy Efficiency and Renewable Energy Technologies. Report No. TP-462-5173, National Renewable Energy Laboratory, Golden, CO.10.2172/35391Suche in Google Scholar
26. Sodero, S.F., Berruti, F., Behie, A.L., 1996. Ultrapyrolytic cracking of polyethylene a high yield recycling method. Chemical Engineering Science 51, 2805–2810.10.1016/0009-2509(96)00156-XSuche in Google Scholar
27. Troitsch, J., 1990. International Plastics Flammability Handbook, Hanser Publishers, Munich.Suche in Google Scholar
28. Tukker, A., De Groot, H., Simons, L., Wiegersma, S., 1999. Chemical recycling of plastic waste: PVC and other resins. European Commission, DG III, Final Report, STB-99-55 Final. Delft, the Netherlands.Suche in Google Scholar
29. Van Krevelen, D.W., 2009. Properties of polymers: their correlation with chemical structure: their numerical estimation and prediction from additive group contributions. Elsevier Radarweg 29, PO Box 211, 1000 AE Amsterdam, the Netherlands Linacre House, Jordan Hill, Oxford OX2 8DP, UK.Suche in Google Scholar
30. Williams, P.T., Williams, E.A., 1999. Interaction of plastics in mixed plastics pyrolysis. Energy Fuels 13, 188–196.10.1021/ef980163xSuche in Google Scholar
©2016 by De Gruyter
Artikel in diesem Heft
- Frontmatter
- Preface to the Special Issue dedicated to the First International Energy Conference, IEC 2015
- Derivation of an Upscaled Model for Mass Transfer and Reaction for Non-Food Starch Conversion to Bioethanol
- Elucidating Kinetic, Adsorption and Partitioning Phenomena from a Single Well Tracer Method: Laboratory and Bench Scale Studies
- Thermodynamic Analysis of Ethanol Synthesis from Glycerol by Two-Step Reactor Sequence
- Modeling the Transient VOC (toluene) Oxidation in a Packed-Bed Catalytic Reactor
- Substrate Feeding Strategy Integrated with a Biomass Bayesian Estimator for a Biotechnological Process
- Comparison Tools for Parametric Identification of Kinetic Model for Ethanol Production using Evolutionary Optimization Approach
- Hydrodeoxygenation of Phenol Over Sulfided CoMo Catalysts Supported on a Mixed Al2O3-TiO2 Oxide
- Experimental and Computational Analysis of Single Phase Flow Coiled Flow Inverter Focusing on Number of Transfer Units and Effectiveness
- Dynamic Effectiveness Factor for Catalytic Particles with Anomalous Diffusion
- Experimental and Artificial Neural Network Modeling of a Upflow Anaerobic Contactor (UAC) for Biogas Production from Vinasse
- Novel Feedback Control to Improve Biohydrogen Production by Desulfovibrio alaskensis
- Influence of an Alkaline Zeolite on the Carbon Flow in Anaerobiosis of Three Strains of Saccharomyces cerevisiae
- CCS, A Needed Technology for the Mexican Electrical Sector: Sustainability and Local Industry Participation
- Olefins and Ethanol from Polyolefins: Analysis of Potential Chemical Recycling of Poly(ethylene) Mexican Case
- CFD Simulations of Copper-Ceria Based Microreactor for COPROX
Artikel in diesem Heft
- Frontmatter
- Preface to the Special Issue dedicated to the First International Energy Conference, IEC 2015
- Derivation of an Upscaled Model for Mass Transfer and Reaction for Non-Food Starch Conversion to Bioethanol
- Elucidating Kinetic, Adsorption and Partitioning Phenomena from a Single Well Tracer Method: Laboratory and Bench Scale Studies
- Thermodynamic Analysis of Ethanol Synthesis from Glycerol by Two-Step Reactor Sequence
- Modeling the Transient VOC (toluene) Oxidation in a Packed-Bed Catalytic Reactor
- Substrate Feeding Strategy Integrated with a Biomass Bayesian Estimator for a Biotechnological Process
- Comparison Tools for Parametric Identification of Kinetic Model for Ethanol Production using Evolutionary Optimization Approach
- Hydrodeoxygenation of Phenol Over Sulfided CoMo Catalysts Supported on a Mixed Al2O3-TiO2 Oxide
- Experimental and Computational Analysis of Single Phase Flow Coiled Flow Inverter Focusing on Number of Transfer Units and Effectiveness
- Dynamic Effectiveness Factor for Catalytic Particles with Anomalous Diffusion
- Experimental and Artificial Neural Network Modeling of a Upflow Anaerobic Contactor (UAC) for Biogas Production from Vinasse
- Novel Feedback Control to Improve Biohydrogen Production by Desulfovibrio alaskensis
- Influence of an Alkaline Zeolite on the Carbon Flow in Anaerobiosis of Three Strains of Saccharomyces cerevisiae
- CCS, A Needed Technology for the Mexican Electrical Sector: Sustainability and Local Industry Participation
- Olefins and Ethanol from Polyolefins: Analysis of Potential Chemical Recycling of Poly(ethylene) Mexican Case
- CFD Simulations of Copper-Ceria Based Microreactor for COPROX
