Article
Licensed
Unlicensed
Requires Authentication
Influence of the PET Material Grade on the Energy Efficiency of the Reheat Phase in the Two-stage Stretch Blow Moulding Process
-
E.h. W. Michaeli,
Published/Copyright:
November 1, 2010
Published Online: 2010-11
©2011 by Walter de Gruyter GmbH & Co.
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- CONTENTS
- Control of Polymer Gel Surface Pattern Formation and its Three Dimensional Measurement Method
- Cure Kinetics of Biphenyl Epoxydized Novolac Resin
- The Effect of Temperature and Gel Concentration on the Rheological Properties of Ultra High Molecular Weight Polyethylene (UHMWPE) in Decalin
- Stress-strain Behavior of CdS/PMMA Nano-composite
- Thermal and Mechanical Behavior of Polymer Nano-composite
- Influence of the PET Material Grade on the Energy Efficiency of the Reheat Phase in the Two-stage Stretch Blow Moulding Process
Articles in the same Issue
- CONTENTS
- Control of Polymer Gel Surface Pattern Formation and its Three Dimensional Measurement Method
- Cure Kinetics of Biphenyl Epoxydized Novolac Resin
- The Effect of Temperature and Gel Concentration on the Rheological Properties of Ultra High Molecular Weight Polyethylene (UHMWPE) in Decalin
- Stress-strain Behavior of CdS/PMMA Nano-composite
- Thermal and Mechanical Behavior of Polymer Nano-composite
- Influence of the PET Material Grade on the Energy Efficiency of the Reheat Phase in the Two-stage Stretch Blow Moulding Process
