Article
Licensed
Unlicensed Requires Authentication

Prediction of long-term leaching potential of preservative-treated wood by diffusion modeling

  • , and
Published/Copyright: September 1, 2005
Holzforschung
From the journal Volume 59 Issue 5

Abstract

An approach to modeling leaching and leaching impacts of preservative components from treated wood is presented based on three simple laboratory determinations: the amount of preservative component available for leaching (Le), equilibrium dissociation of preservative into free water in wood (Di) and diffusion coefficients for component leaching in different wood directions (D). In this study, the following inorganic wood preservative systems were investigated: chromated copper arsenate (CCA), the copper component of copper azole (CA) and alkaline copper quaternary (ACQ), and boron in disodium octaborate tetrahydrate (DOT). Aggressive leaching of finely ground wood showed that amounts of preservative compounds available for leaching were highest for borates, followed by copper in copper amine systems and arsenic in CCA, copper in CCA and chromium in CCA. The equilibrium dissociation or solubility of components in free water in the wood was much higher for borates and copper amine, followed by copper and arsenic in CCA and chromium in CCA. Use of the applicable diffusion coefficient (D) and Di or Le values in a diffusion model allows the prediction of total amount leached and emission or flux rate at different times of exposure for products with different dimensions and geometries. The approach was tested and generally validated through application of the model to results of laboratory water spray leaching of full-size lumber samples. The approach explains the rapid leaching of boron compounds (large diffusion coefficient and high initial dissociated concentration) compared to other preservative components and predicts that ACQ will have higher initial leaching rates compared to CCA and CA, but the latter preservatives will continue to leach copper at a measurable rate for a much longer time. The practical implications and limitations of the approach are discussed.

:

Corresponding author. Faculty of Forestry, University of Toronto, 33 Willcocks St., Toronto, Ontario, M5S 3B3, Canada

References

AWPA Standard (2003a) Use Category System. Book of Standards. American Wood-Preservers' Association, Selma, AL.Search in Google Scholar

AWPA Standard (2003b) A7-93. Standard for wet ashing procedures for preparing wood for chemical analysis. American Wood-Preservers' Association, Selma, AL.Search in Google Scholar

AWPA Standard (2003c) A12-96, Wood densities for preservative retention Calculations. Book of Standards. American Wood-Preservers' Association, Selma, AL.Search in Google Scholar

Brooks, K.M. (2002) Evaluating the environmental risks associated with the use of chromated copper arsenate-treated wood products in aquatic environments. Estuaries19:296–305.Search in Google Scholar

CEN (2005) Draft EN 335-2. Durability of wood and wood based products – Definition of use classes of biological attack. Part 2 Application to solid wood. European Committee for Standardization.Search in Google Scholar

Cockcroft, R., Laidlaw, R.A. (1978) Factors affecting leaching of preservatives in practice. Document No. IRG/WP 3113. International Research Group on Wood Protection.Search in Google Scholar

Crank, J. The Mathematics of Diffusion. Oxford University Press, London, New York, 1975.Search in Google Scholar

Haloui, A., Vergnaud J.M. (1995) Modeling the process of release of chemical from wood in finite volumes of water in succession. Wood. Sci. Technol.29:77–85.Search in Google Scholar

Haloui, A., Vergnaud J.M. (1997) Study of the release in water of chemicals used for wood preservation. Effect of wood dimensions. Wood. Sci. Technol.31:51–62.Search in Google Scholar

Hingston, J.A. (2002) Leaching of copper based preservatives in aquatic environments. Ph.D. Thesis. Faculty of Life Sciences, University of London, London, UK.Search in Google Scholar

Hingston, J.A., Collins, C.D., Murphy, R.J., Lester, J.N. (2001) Leaching of chromated copper arsenate wood preservatives: a review. Environ. Pollut.111:53–66.10.1016/S0269-7491(00)00030-0Search in Google Scholar

Homan, W.J., van Oosten, A.L. (1999) Statistically stable models for determination of PEC. Document No. IRG/WP 99-50135. International Research Group on Wood Protection.Search in Google Scholar

Jin, L., Preston, A.F. (1993) Depletion of preservative from treated wood: Results from laboratory, fungus cellar and field tests. Document No. IRG/WP 93-50001. International Research Group on Wood Protection.Search in Google Scholar

Klipp, H., Willeitner, H., Brandt, K., Muller-Grimm, A. (1991) Migration of active ingredients from treated timber into fresh water. Document No. IRG/WP/3669. International Research Group on Wood Protection.Search in Google Scholar

Lebow, S. (1996) Leaching of wood preservative components and their mobility in the environment. Summary of pertinent literature. General Technical Report FPL-GTR-93. Forest Products Laboratory, USDA Forest Service, Madison WI.p. 36.Search in Google Scholar

Morsing, N. (2003) Leaching of active components from preservative treated timber. Status after approx. 4 months out-door exposure. Document No. IRG/WP 03-20276. International Research Group on Wood Protection.Search in Google Scholar

Morsing, N., Lindegaard, B. (2004) Leaching of active components from preservative treated timber. Stages 2 and 3: Laboratory testing and comparison with semi-field testing. Document No. IRG/WP 04-20303. International Research Group on Wood Protection.Search in Google Scholar

OECD (2003) OECD series on emission scenario documents, Number 2. Emission scenario document for wood preservatives, Part 3. Organization for Economic Co-operation and Development, Paris, France.Search in Google Scholar

Ra, J.B., Barnes, H.M., Conners, T.E. (2001) Determination of boron diffusion coefficients in wood. Wood Fiber Sci.33:90–103.Search in Google Scholar

Schoknecht, U., Wegner, R., Melcher, E. (2004) Experiences with the OECD guideline proposals for the estimation of emissions from preservative treated wood in the environment. Document No. IRG/WP/04-50209. International Research Group on Wood Protection.Search in Google Scholar

Stevanovic-Janesic, T., Cooper, P.A., Ung, Y.T. (2001) Chromated copper arsenate treatment of North American hardwoods. Part 2. CCA leaching performance. Holzforschung55:7–12.10.1515/HFSG.2001.7Search in Google Scholar

Taylor, J. (2001) Natural leaching of CCA from treated lumber. M.Sc. Thesis. Faculty of Forestry, University of Toronto, Canada.Search in Google Scholar

Van Eetvelde, G., Stevens M., Vander Mijnsbrugge, L. (1994) Comparative study on leaching of CCA from treated timber: Modeling of emission data. Document No. IRG/WP 04-50027. International Research Group on Wood Protection.Search in Google Scholar

Waldron, L. (2004) Diffusion modeling of the leaching of inorganic wood preservatives from pressure-treated wood. Ph.D. Thesis. Faculty of Forestry, University of Toronto, Canada.Search in Google Scholar

Willeitner, H., Peek, R.-D. (1998) How to determine what is a realistic emission from treated wood. Document No. IRG/WP/98-50105. International Research Group on Wood Protection.Search in Google Scholar

Published Online: 2005-09-01
Published in Print: 2005-09-01

©2005 by Walter de Gruyter Berlin New York

Articles in the same Issue

  1. The prediction of pulp yield using selected fiber properties
  2. Surface lignin and extractives on hardwood RDH kraft pulp chemically characterized by ToF-SIMS
  3. NMR studies on Fraser fir Abies fraseri (Pursh) Poir. lignins
  4. Acid hydrolysis kinetics and identification of erythro and threo α-ethyl ether derivatives of non-phenolic arylglycerol-β-syringyl ether lignin model compounds
  5. Stabilization of cellulose solutions in N-methylmorpholine-N-oxide (Lyocell dopes) by addition of an N-oxide as sacrificial substrate
  6. Mechanism of decomposition of peracetic acid by manganese ions and diethylenetriaminepentaacetic acid (DTPA)
  7. The effect of chlorophorin and its derivative on melanin biosynthesis
  8. Long-term development of VOC emissions from OSB after hot-pressing
  9. Assessment of continuous distribution of wood properties from a low number of samples: Application to the variability of modulus of elasticity between trees and within a tree
  10. Earlywood and latewood elastic properties in loblolly pine
  11. Combined shear and compression analysis using a modified Iosipescu shear test device. Experimental studies on dry wood
  12. An approach to viscoelastic behaviour analysis of wood-based panels by an inverse method of characterisation
  13. The mechanosorptive effect in Pinus radiata D. Don.
  14. Advances in understanding bioactivity of chitosan and chitosan oligomers against selected wood-inhabiting fungi
  15. Comparison of quantitative real-time PCR, chitin and ergosterol assays for monitoring colonization of Trametes versicolor in birch wood
  16. Rate and extent of adsorption of ACQ preservative components in wood
  17. Prediction of long-term leaching potential of preservative-treated wood by diffusion modeling
Downloaded on 12.4.2026 from https://www.degruyterbrill.com/document/doi/10.1515/HF.2005.095/html
Scroll to top button