Article
Licensed
Unlicensed
Requires Authentication
One-sided and Two-sided Critical Values for Dixon's Outlier Test for Sample Sizes up to n = 30
-
Armin Böhrer
Published/Copyright:
March 11, 2010
Abstract
Critical values for the significance levels α=0.0100, 0.0500, and 0.1000 and sample sizes from n = 3 to n = 30 for Dixon's outlier test have been calculated using Monte Carlo simulation. For the one-sided and two-sided case critical values are determined, which are accurate to within ±0.00001 to ±0.00007.
Published Online: 2010-03-11
Published in Print: 2008-April
© Heldermann Verlag
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- One-sided and Two-sided Critical Values for Dixon's Outlier Test for Sample Sizes up to n = 30
- Exact Distributions of Products of Certain Random Variables
- Two Old Statistical Methods in a New Stochastic Outfit
- Optimal Maintenance/Replacement-Policy for Deteriorating Systems under Two-Phase Maintenance Strategy
- Bounds for Quantile-Based Risk Measures of Functions of Dependent Random Variables
- The Distribution of the Profile of Aluminium Coil
- A Note on the Efficiency of Nonparametric Control Chart for Monitoring Process Variability
- Control Charts for Particles in the Semiconductor Manufacturing Process
- Statistical Sampling Strategies for Geometric Tolerance Inspection by CMM
- A Critical Note on the Guide to the Expression of Uncertainty in Measurement (GUM)
Articles in the same Issue
- One-sided and Two-sided Critical Values for Dixon's Outlier Test for Sample Sizes up to n = 30
- Exact Distributions of Products of Certain Random Variables
- Two Old Statistical Methods in a New Stochastic Outfit
- Optimal Maintenance/Replacement-Policy for Deteriorating Systems under Two-Phase Maintenance Strategy
- Bounds for Quantile-Based Risk Measures of Functions of Dependent Random Variables
- The Distribution of the Profile of Aluminium Coil
- A Note on the Efficiency of Nonparametric Control Chart for Monitoring Process Variability
- Control Charts for Particles in the Semiconductor Manufacturing Process
- Statistical Sampling Strategies for Geometric Tolerance Inspection by CMM
- A Critical Note on the Guide to the Expression of Uncertainty in Measurement (GUM)
