Article
Licensed
Unlicensed
Requires Authentication
A New Method to Determine the Filament Force Tension within the Fibre Formation Zone
Dedicated to Prof. Dr. habil. R. Beyreuther on the Occasion of his 65th Birthday
-
H. Brünig
Published/Copyright:
June 3, 2013
Abstract
A non-contact method to determine the force tension of the spinning line is proposed by a non-vertical arrangement of the melt spinning equipment. The curvature of the spinline caused by gravitation was determined experimentally by measuring the spinline location. This is the key for the calculation of the filament force only by geometric measurements.
Received: 2002-1-2
Accepted: 2002-11-14
Published Online: 2013-06-03
Published in Print: 2003-03-01
© 2003, Carl Hanser Verlag, Munich
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Contents
- Contents
- Editorial
- Polymorphic and Crystal Structures from Crystallization in Polymer Processing
- Compounding/Screw Extrusion
- Flow Properties and Morphology of PC/LCP Blends Affected by the Addition of Glass Fiber and Resulted Mutual Influences
- Modeling Filler Dispersion along a Twin-Screw Extruder
- Characterisation of Finite Length Composites
- Single Screw Extrusion of Natural Fibre Reinforced Thermoplastics (NFRTP)
- Fiber and Film
- A New Method to Determine the Filament Force Tension within the Fibre Formation Zone
- Diameter Profile Measurements for CO2 Laser Heated Drawing Process of PET Fiber
- Stress Induced Crystallization in Elongational Flow
- Improved Spinnability of Metallocene Polyethylenes by Using Processing Aids
- Melt Spinning of Reactive Extruded and/or Blended Polymer Fibers by Means of an Online Coupled Twin Screw Extruder
- Cast Film Problem: A Non Isothermal Investigation
- Rotational Molding
- Effect of Processing History on the Sintering of Ethylene Copolymers
- Injection Molding
- Five Geometric Principles for Injection Molding
- Modelling of Residual Stresses and Warpage in Sandwich Injection Moulding
Articles in the same Issue
- Contents
- Contents
- Editorial
- Polymorphic and Crystal Structures from Crystallization in Polymer Processing
- Compounding/Screw Extrusion
- Flow Properties and Morphology of PC/LCP Blends Affected by the Addition of Glass Fiber and Resulted Mutual Influences
- Modeling Filler Dispersion along a Twin-Screw Extruder
- Characterisation of Finite Length Composites
- Single Screw Extrusion of Natural Fibre Reinforced Thermoplastics (NFRTP)
- Fiber and Film
- A New Method to Determine the Filament Force Tension within the Fibre Formation Zone
- Diameter Profile Measurements for CO2 Laser Heated Drawing Process of PET Fiber
- Stress Induced Crystallization in Elongational Flow
- Improved Spinnability of Metallocene Polyethylenes by Using Processing Aids
- Melt Spinning of Reactive Extruded and/or Blended Polymer Fibers by Means of an Online Coupled Twin Screw Extruder
- Cast Film Problem: A Non Isothermal Investigation
- Rotational Molding
- Effect of Processing History on the Sintering of Ethylene Copolymers
- Injection Molding
- Five Geometric Principles for Injection Molding
- Modelling of Residual Stresses and Warpage in Sandwich Injection Moulding
