Abstract
This research presents the numerical results of laminar forced convective heat transfer performance and the flow behaviour for Al2O3-water nanofluid in circular, 2:1 rectangular, 4:1 rectangular and square ducts. The nanoparticles concentration studied were 0.01%, 0.09%, 0.13%, 0.25%, 0.51%, 1.00% and 4.00%. Single phase constant and temperature-dependent properties were employed. For the case of constant properties, the thermal performance and pressure drop increase with the increase of nanofluid concentration and Reynolds number. For the temperature-dependent properties, the Nusselt number and pressure drop also increase when the Reynolds number increases. However, there is a slight decrement in the Nusselt number and no significant pressure drop increment when the nanofluid concentration is increased from 0.01% to 1.00%. When the concentration is further increased to 4.00%, the Nusselt number and pressure drop increase. For the temperature-dependent model, lower thermal performance and pressure drop are identified when compared to those of the constant properties. The maximum Nusselt number enhancement and pressure drop increment occur at the concentration of 4.00% and Reynolds number of 2000. They are 25.43% and 945.69% as well as 4.86% and 117.01% for constant and temperature-dependent properties, respectively. The thermal-hydraulic efficiency of nanofluid is found to be not as good as the pure water.
Funding statement: This work was supported by Ministry of Higher Education (MOHE) Malaysia under Exploratory Research Grant Scheme (ERGS), (Grant/Award Number: ‘ERGS/1/2012/TK05/CURTIN/02/1′)
References
[1] Choi SUS, Eastman JA. Enhancing thermal conductivity of fluids with nanoparticles. California: ASME Publications Federal, 1995.Search in Google Scholar
[2] Wen D, Ding Y. Experimental investigation into convective heat transfer of nanofluids at the entrance region under laminar flow conditions. Int J Heat Mass Transfer. 2004;47(24):5181–5188.10.1016/j.ijheatmasstransfer.2004.07.012Search in Google Scholar
[3] Nassan TH, Heris SZ, Noie SH. A comparison of experimental heat transfer characteristics for Al2O3/water and CuO/water nanofluids in square cross-section duct. Int Commun Heat Mass Transfer. 2010;37(7):924–928.10.1016/j.icheatmasstransfer.2010.04.009Search in Google Scholar
[4] Heris ZS, Nassan TH, Noie SH, Sardarabadi H, Sardarabadi M. Laminar convective heat transfer of Al2O3/water nanofluid through square cross-sectional duct. Int J Heat Fluid Flow. 2013;44:375–382.10.1016/j.ijheatfluidflow.2013.07.006Search in Google Scholar
[5] Bianco V, Chiacchio F, Manca O, Nardini S. Numerical investigation of nanofluids forced convection in circular tubes. Appl Therm Eng. 2009;29(17–18):3632–3642.10.1016/j.applthermaleng.2009.06.019Search in Google Scholar
[6] Mashaei PR, Seyed Mostafa H, Bahiraei M. Numerical investigation of nanofluid forced convection in channels with discrete heat sources. J Appl Math. 2012;2012:1–18.10.1155/2012/259284Search in Google Scholar
[7] Namburu PK, Kulkarni DP, Misra D, Das DK. Viscosity of copper oxide nanoparticles dispersed in ethylene glycol and water mixture. Exp Therm Fluid Sci. 2007;32(2):397–402.10.1016/j.expthermflusci.2007.05.001Search in Google Scholar
[8] Duangthongsuk W, Wongwises S. Measurement of temperature-dependent thermal conductivity and viscosity of TiO2-water nanofluids. Exp Therm Fluid Sci. 2009;33(4):706–714.10.1016/j.expthermflusci.2009.01.005Search in Google Scholar
[9] Rea U, McKrell T, Hu LW, Buongiorno J. Laminar convective heat transfer and viscous pressure loss of alumina–water and zirconia–water nanofluids. Int J Heat Mass Transfer. 2009;52(7–8):2042–2048.10.1016/j.ijheatmasstransfer.2008.10.025Search in Google Scholar
[10] Zhao N, Yang J, Li S, Wang Q. Numerical investigation of laminar thermal-hydraulic performance of Al2O3–water nanofluids in offset strip fins channel. Int Commun Heat Mass Transfer. 2016;75:42–51.10.1016/j.icheatmasstransfer.2016.03.024Search in Google Scholar
[11] Kumar P, Ganesan R. A CFD study of turbulent convective heat transfer enhancement in circular pipeflow. Int J Civil Environmental Eng. 2012;6:385–392.Search in Google Scholar
[12] Pak BC, Cho YI. Hydrodynamic and heat transfer study of dispersed fluids with submicron metallic oxide particles. Exp Heat Transfer. 1998;11(2):151–170.10.1080/08916159808946559Search in Google Scholar
[13] Meybodi MK, Daryasafar A, Koochi MM, Moghadasi J, Meybodi RB, Ghahfarokhi AK. A novel correlation approach for viscosity prediction of water based nanofluids of Al2O3, TiO2, SiO2 and CuO. J Taiwan Inst Chem Eng. 2016;58:19–27.10.1016/j.jtice.2015.05.032Search in Google Scholar
[14] Shah RK, London AL. Report number: 75 1971. Laminar flow forced convection heat transfer and flow friction in straight and curved ducts- a summary of analytical solutions. Department of Mechanical Engineering Stanford University.Search in Google Scholar
[15] Incropera FP, Dewitt DP, Bergman TL, Lavine AS. Fundamentals of heat and mass transfer. USA: John Wiley & Sons, 2011.Search in Google Scholar
[16] Sonawane SS, Khedkar RS, Wasewar KL. Study on concentric tube heat exchanger heat transfer performance using Al2O3 – water based nanofluids. Int Commun Heat Mass Transfer. 2013;49:60–68.10.1016/j.icheatmasstransfer.2013.10.001Search in Google Scholar
[17] Heris ZS, Nassan THN, Noie S. CuO/Water nanofluid convective heat transfer through square duct under uniform heat flux. Int J Nanosci Nanotechnol. 2011;7(3):111–120.Search in Google Scholar
[18] Yang Y, Zhang ZG, Grulke EA, Anderson WB, Wu G. Heat transfer properties of nanoparticle-in-fluid dispersions (nanofluids) in laminar flow. Int J Heat Mass Transfer. 2005;48(6):1107–1116.10.1016/j.ijheatmasstransfer.2004.09.038Search in Google Scholar
[19] Shah RK, Sekulic DP. Fundamentals of heat exchanger design. USA: John Wiley and Sons, 2003.10.1002/9780470172605Search in Google Scholar
[20] Şahin AZ. Irreversibilities in various duct geometries with constant wall heat flux and laminar flow. Energy. 1998;23(6):465–473.10.1016/S0360-5442(98)00010-3Search in Google Scholar
[21] Seb M, Palm SJ, Nguyen CT, Roy G, Galanis N. Heat transfer enhancement by using nanofluids in forced convection flows. Int J Heat Fluid Flow. 2005;26(4):530–546.10.1016/j.ijheatfluidflow.2005.02.004Search in Google Scholar
[22] Anoop KB, Sundararajan T, Das SK. Effect of particle size on the convective heat transfer in nanofluid in the developing region. Int J Heat Mass Transfer. 2009;52(9–10):2189–2195.10.1016/j.ijheatmasstransfer.2007.11.063Search in Google Scholar
[23] Eastman JA, Choi US, Li S, Thompson LJ, Lee S. Enhanced thermal conductivity through the development of nanofluids. USA: Materials Research Society Symposia Proceedings, 1996.10.1557/PROC-457-3Search in Google Scholar
© 2017 Walter de Gruyter GmbH, Berlin/Boston
Articles in the same Issue
- Editorial
- Editorial: Special Issue of 29th Symposium of Malaysian Chemical Engineers (SOMChE) 2016 – Process System Engineering
- Research Articles
- Effect of Inventory Change in a Liquid – Solid Circulating Fluidized Bed (LSCFB)
- Simulation and Optimization of the Utilization of Triethylene Glycol in a Natural Gas Dehydration Process
- Development of Adaptive Soft Sensor Using Locally Weighted Kernel Partial Least Square Model
- Comparison of Turbulence Models for Single Sphere Simulation Study Under Supercritical Fluid Condition
- Integrated Palm Biomass Supply Chain toward Sustainable Management
- Multi-Scale Control of Bunsen Section in Iodine-Sulphur Thermochemical Cycle Process
- Optimisation of Design and Operation Parameters for Multicomponent Separation via Improved Lewis-Matheson Method
- The Effect of Various Components of Triglycerides and Conversion Factor on Energy Consumption in Biodiesel Production
- CFD Simulation on the Hydrodynamics in Gas-Liquid Airlift Reactor
- Analysis of the Steady-State Multiplicity Behavior for Polystyrene Production in the CSTR
- Numerical Studies on the Laminar Thermal-Hydraulic Efficiency of Water-Based Al2O3 Nanofluid in Circular and Non-Circular Ducts
- Simultaneous Carbon Capture and Reuse Using Catalytic Membrane Reactor in Water-Gas Shift Reaction
Articles in the same Issue
- Editorial
- Editorial: Special Issue of 29th Symposium of Malaysian Chemical Engineers (SOMChE) 2016 – Process System Engineering
- Research Articles
- Effect of Inventory Change in a Liquid – Solid Circulating Fluidized Bed (LSCFB)
- Simulation and Optimization of the Utilization of Triethylene Glycol in a Natural Gas Dehydration Process
- Development of Adaptive Soft Sensor Using Locally Weighted Kernel Partial Least Square Model
- Comparison of Turbulence Models for Single Sphere Simulation Study Under Supercritical Fluid Condition
- Integrated Palm Biomass Supply Chain toward Sustainable Management
- Multi-Scale Control of Bunsen Section in Iodine-Sulphur Thermochemical Cycle Process
- Optimisation of Design and Operation Parameters for Multicomponent Separation via Improved Lewis-Matheson Method
- The Effect of Various Components of Triglycerides and Conversion Factor on Energy Consumption in Biodiesel Production
- CFD Simulation on the Hydrodynamics in Gas-Liquid Airlift Reactor
- Analysis of the Steady-State Multiplicity Behavior for Polystyrene Production in the CSTR
- Numerical Studies on the Laminar Thermal-Hydraulic Efficiency of Water-Based Al2O3 Nanofluid in Circular and Non-Circular Ducts
- Simultaneous Carbon Capture and Reuse Using Catalytic Membrane Reactor in Water-Gas Shift Reaction