Analysis of the Local Volume Flow Rate of Polymers During Injection Molding
-
M. F. Lacrampe
Abstract
Amorphous and crystalline polymers were injected into different molds of disks, with different applied injection rates. The pressures and local volume flow rates were measured for different injection molding conditions. These measures show a difference between the average volume flow rate measured during the total filling time and the nominal applied volume flow rate. Moreover the local volume flow rate at the polymer front increases between the mold entrance and the end of the cavity. Effects of different parameters of the process (polymer, geometry of the part, injection molding conditions) on the evolution of these volume flow rates were examined. Interpretation of the observed phenomena neads to take into account the effect of two characteristics of the polymers which are generally neglected: the compressibility and the associated bulk viscosity.
© 1996, Carl Hanser Verlag, Munich
Artikel in diesem Heft
- Contents
- Contents
- Editorial
- Seventeenth in a Series: Reifenhäuser – From Blacksmiths to Master Integrated Screw Extrusion System Manufacturers
- Invited Paper
- 35 Years of Studies of Mixing of Rubber and Viscoelasticity
- Mixing
- Melt Strength and Elastic Behaviour of LLDPE/LDPE Blends
- Screw Extrusion
- Melting and Blending in a Modular Co-Rotating/Counter-Rotating Twin Screw Extruder
- A Physico-Mathematical Model for Solids Conveying in Co-Rotating Twin Screw Extruders
- Fibers and Films
- High-speed Melt Spinning of PET
- Die Extrusion
- Evaluation of the FAN Technique for Profile Die Design
- Molding
- Analysis of the Mold Filling Process with Phase Change Considering the Non-steady Effect
- Analysis of the Local Volume Flow Rate of Polymers During Injection Molding
- Surface Defect Formation in the Injection Molding of Acrylonitrile-Styrene-Acrylate Polymers
- Injection Molding of Microcomposites Based on Polypropylene and Thermotropic Liquid Crystalline Polymers
Artikel in diesem Heft
- Contents
- Contents
- Editorial
- Seventeenth in a Series: Reifenhäuser – From Blacksmiths to Master Integrated Screw Extrusion System Manufacturers
- Invited Paper
- 35 Years of Studies of Mixing of Rubber and Viscoelasticity
- Mixing
- Melt Strength and Elastic Behaviour of LLDPE/LDPE Blends
- Screw Extrusion
- Melting and Blending in a Modular Co-Rotating/Counter-Rotating Twin Screw Extruder
- A Physico-Mathematical Model for Solids Conveying in Co-Rotating Twin Screw Extruders
- Fibers and Films
- High-speed Melt Spinning of PET
- Die Extrusion
- Evaluation of the FAN Technique for Profile Die Design
- Molding
- Analysis of the Mold Filling Process with Phase Change Considering the Non-steady Effect
- Analysis of the Local Volume Flow Rate of Polymers During Injection Molding
- Surface Defect Formation in the Injection Molding of Acrylonitrile-Styrene-Acrylate Polymers
- Injection Molding of Microcomposites Based on Polypropylene and Thermotropic Liquid Crystalline Polymers
