An In-line Rheometer for Molten Plastics
-
T. O. Broadhead
Abstract
A novel in-line rheometer for use with molten plastics has been developed and evaluated. It is a process sensor designed to be installed in a melt flow stream, for example at the exit of an extruder. The entire process stream flows through the rheometer, so there is no output signal delay due to the flow of melt in a sampling line and gear pump. A small fraction of the melt entering the rheometer is drawn into a small gap between a rotating drum and an outer cylindrical wall. The shear stress acting on a small area of the outer wall is monitored by a shear stress transducer. A technique for taking into account the small pressure flow that is superposed on the drag flow in the shearing gap is described. The major problems that must be addressed in designing an in-line sensor arise from the fact that the temperature, pressure and flow rate of melt entering the rheometer are subject to the fluctuations and upsets that are ubiquitous in industrial processes. The new rheometer is able to operate in this environment and yield reliable viscosity values. However, the output signal of the shear stress transducer was found to be affected by the pressure and contained a low frequency noise component that limited its accuracy. An improved version of this transducer is currently under development.
© 1993, Carl Hanser Verlag, Munich
Artikel in diesem Heft
- Contents
- Contents
- Internal Mixers
- Estimation of Quality of Mixing
- Screw Extrusion and Continuous Mixing
- An In-line Rheometer for Molten Plastics
- Melting of Plastics in Kneading Blocks
- Development of Phase Morphology of a Polyethylene-Polyamide 6-Blend in a Modular Co-rotating Twin Screw Extruder
- Microstructure Formation in Extruded and Drawn Polyblends of PC with a Thermotropic LCP
- Die Extrusion
- A Slip Model for Linear Polymers Based on Adhesive Failure
- Film
- Effect of Biaxial Stretching on Mechanical Properties and Surface Roughness of PMMA Films
- Molding
- Dynamics and Control of Surface and Mold Temperatures in Injection Molding
- A Study on Flexural Properties of Sandwich Injection Moldings
- Detailed Investigations of Structural Layering Phenomena in Injection Molded Thermotropic LCP
- Computer Controlled Rotational Molding of Liquid Silicone Polymer
Artikel in diesem Heft
- Contents
- Contents
- Internal Mixers
- Estimation of Quality of Mixing
- Screw Extrusion and Continuous Mixing
- An In-line Rheometer for Molten Plastics
- Melting of Plastics in Kneading Blocks
- Development of Phase Morphology of a Polyethylene-Polyamide 6-Blend in a Modular Co-rotating Twin Screw Extruder
- Microstructure Formation in Extruded and Drawn Polyblends of PC with a Thermotropic LCP
- Die Extrusion
- A Slip Model for Linear Polymers Based on Adhesive Failure
- Film
- Effect of Biaxial Stretching on Mechanical Properties and Surface Roughness of PMMA Films
- Molding
- Dynamics and Control of Surface and Mold Temperatures in Injection Molding
- A Study on Flexural Properties of Sandwich Injection Moldings
- Detailed Investigations of Structural Layering Phenomena in Injection Molded Thermotropic LCP
- Computer Controlled Rotational Molding of Liquid Silicone Polymer
