PPS News

Artikel in diesem Heft

1. Contents
2. Rapid Communications
3. A Novel High Flow Rate Pin for Water-assisted Injection Molding of Plastic Parts with a More Uniform Residual Wall Thickness Distribution
4. Regular Contributed Articles
5. Structure Property Relationships in PA 6 and PP Copolymers Blended by Single and Twin Screw Extrusion
6. Stretchability and Properties of Biaxially Oriented Polypropylene Film
7. Dynamic Mold Surface Temperature Control Using Induction and Heater Heating Combined with Coolant Cooling
8. Visualization of Melt-Flow Behavior Inside the Runner in Ultra High Speed Injection Molding
9. Effects of Cavity Conditions on Transcription Molding of Microscale Prism Patterns Using Ultra-High-Speed Injection Molding
10. Effect of Melt and Mold Temperature on Fiber Orientation during Flow in Injection Molding of Reinforced Plastics
11. Invited Paper
12. Polymer/Layered Silicate Nano-composites
13. Regular Contributed Articles
14. Paste Extrusion of Polytetrafluoroethylene: Temperature, Blending and Processing Aid Effects
15. Influence of Viscosity-interface Modifier Interactions on Performance and Processability of Rice Hull PE Composites
16. Single and Multi Objective Optimization for Injection Molding Using Numerical Simulation with Surrogate Models and Genetic Algorithms
17. A Process Classification Number for the Solidification of Crystallizing Materials
18. Effect of Aerodynamics on Film Blowing Process
19. Analysis of Necking Deformation Behavior in High-Speed In-line Drawing Process of PET by On-line Diameter and Velocity Measurements
20. PPS News
21. PPS News
22. Seikei-Kakou Abstracts
23. Seikei-Kakou Abstracts