Volume 83, Issue 10

Polyaniline (PANI), a conducting polymer, was prepared by the oxidation of aniline with ammonium peroxydisulfate in various aqueous media. When the polymerization was carried out in the solution of strong (sulfuric) acid, a granular morphology of PANI was obtained. In the solutions of weak (acetic or succinic) acids or in water, PANI nanotubes were produced. The oxidation of aniline under alkaline conditions yielded aniline oligomers. Fourier transform infrared (FTIR) spectra of the oxidation products differ. A group of participants from 11 institutions in different countries recorded the FTIR spectra of PANI bases prepared from the samples obtained in the solutions of strong and weak acids and in alkaline medium within the framework of an IUPAC project. The aim of the project was to identify the differences in molecular structure of PANI and aniline oligomers and to relate them to supramolecular morphology, viz. the nanotube formation. The assignment of FTIR bands of aniline oxidation products is reported.

Morphology development of polytetrafluoroethylene (PTFE) caused by applied flow history in molten isotactic polypropylene (PP) is investigated, employing a cone-and-plate rheometer and a capillary rheometer as mixing devices. Since the flow history is applied at 190 °C, PTFE is in the solid state whereas PP is in the molten state. It is found that primary PTFE particles tend to be agglomerated together by mechanical interlocking. Then they are fragmented into fibers by hydrodynamic force with reorganization process of crystalline phase. The diameter of the fragmented fibers is the same as that of the original ellipsoidal particles. Further, fine fibers whose diameter is in the range from 50 to 100 nm are also generated by yielding behavior of the particles. The prolonged shearing leads to a large number of fibers, although the diameter and length are hardly affected by the exposure time of shearing and shear stress. Moreover, the flow type (i.e., drag or pressure flow) does not affect the morphology to a great extent, although the drag flow is not efficient to reduce large agglomerated particles. The fibers form an interdigitated network structure, which is responsible for the marked melt elasticity.

Recommendations are given concerning the terminology relating to the structure and the morphology of crystalline polymers and the processes of polymer crystallization. They are applicable to cases where polymer crystals are a significant fraction of a system and primarily with crystal structures that are comprised of polymer chains with limited, static, or dynamic disorder. After some general definitions, terms pertaining to structural arrangements at subnanometric scales and to polymer crystal structures are defined. Terms relating to molecular conformation within polymer crystals, morphological aspects, and polymer crystallization are given in subsequent sections.

This IUPAC study aims at formulating recommendations concerning the metrological traceability of a measurement result in chemistry. It is intended to provide the chemical measurement community with a consistent view of the creation, meaning, and role of metrological traceability and its underpinning concepts. No distinction is made between measurement results obtained in “high metrology” and in the “field”. A description is given of the calibration hierarchies needed in different circumstances to arrive at metrological traceability along a metrological traceability chain. Flow charts of generic calibration hierarchies are presented as well as a variety of examples. The establishment, assessment, and reporting of metrological traceability are discussed, including the provision of metrological references by a metrological institutional framework and the role of interlaboratory comparisons.

ThermoML is an XML-based approach for storage and exchange of experimental, predicted, and critically evaluated thermophysical and thermochemical property data. Extensions to the ThermoML schema for the representation of speciation, complex equilibria, and properties of biomaterials are described. The texts of 14 data files illustrating the new extensions are provided as Supplementary Information together with the complete text of the updated ThermoML schema.