Band 2, Heft 4

Thermoluminescence (TL) of monomineralic separates have been widely used in various geosciences fields in order to trace the thermal history and aid in prospecting for gold deposits. Quartz is a ubiquitous mineral in the Shihu gold deposit, which is situated in the northern part of the Taihang orogenic belt in the North China craton (NCC). The deposit is hosted by ductile-brittle faults within an Archean metamorphic core complex of the Fuping Group. This deposit is characterized by gold-bearing quartz-polymetallic sulfides and quartz veins. New TL results have been obtained for quartz, in which four type-TL glow curves were identified. The gold-bearing quartz present type III glow curves that consist of two peak glow curves at the middle and high peak temperatures with the similar TL intensity. In addition, the cross-sections of peak temperatures and TL intensity highlight the valuable area where the Au-bearing quartz present weak TL intensity and low-middle peak temperatures. Our results significantly enhance the usefulness of quartz in metallogenic studies of the North China craton and as an indicator mineral in mineral exploration of the Taihang Mountain region.

To evaluate trace element soil contamination, geochemical baseline contents and reference values need to be established. Pedo-geochemical baseline levels of trace elements in 72 soil samples of 24 soil profiles from the Mediterranean, Castilla La Mancha, are assessed and soil quality reference values are calculated. Reference value contents (in mg kg−1) were: Sc 50.8; V 123.2; Cr 113.4; Co 20.8; Ni 42.6; Cu 27.0; Zn 86.5; Ga 26.7; Ge 1.3; As 16.7; Se 1.4; Br 20.1; Rb 234.7; Sr 1868.4; Y 38.3; Zr 413.1; Nb 18.7; Mo 2.0; Ag 7.8; Cd 4.4; Sn 8.7; Sb 5.7; I 25.4; Cs 14.2; Ba 1049.3; La 348.4; Ce 97.9; Nd 40.1; Sm 10.7; Yb 4.2; Hf 10.0; Ta 4.0; W 5.5; Tl 2.3; Pb 44.2; Bi 2.2; Th 21.6; U 10.3. The contents obtained for some elements are below or close to the detection limit: Co, Ge, Se, Mo, Ag, Cd, Sb, Yb, Hf, Ta, W, Tl and Bi. The element content ranges (the maximum value minus the minimum value) are: Sc 55.0, V 196.0, Cr 346.0, Co 64.4, Ni 188.7, Cu 49.5, Zn 102.3, Ga 28.7, Ge 1.5, As 26.4, Se 0.9, Br 33.0 Rb 432.7, Sr 3372.6, Y 39.8, Zr 523.2, Nb 59.7, Mo 3.9, Ag 10.1, Cd 1.8, Sn 75.2, Sb 9.9, I 68.0, Cs 17.6, Ba 1394.9, La 51.3, Ce 93.5, Nd 52.5, Sm 11.2, Yb 4.2, Hf 11.3, Ta 6.3, W 5.2, Tl 2.1, Pb 96.4, Bi 3.0, Th 24.4, U 16.4 (in mg kg−1). The spatial distribution of the elements was affected mainly by the nature of the bedrock and by pedological processes. The upper limit of expected background variation for each trace element in the soil is documented, as is its range as a criterion for evaluating which sites may require decontamination.

Fifteen earthquakes (Mw 4.1–6.4) occurring at ten major segments of the Sumatran Fault Zone (SFZ) were analyzed to identify their respective fault planes. The events were relocated in order to assess hypocenter uncertainty. Earthquake source parameters were determined from three-component local waveforms recorded by IRIS-DMC and GEOFON broadband lA networks. Epicentral distances of all stations were less than 10°. Moment tensor solutions of the events were calculated, along with simultaneous determination of centroid position. Joint analysis of hypocenter position, centroid position, and nodal planes produced clear outlines of the Sumatran fault planes. The preferable seismotectonic interpretation is that the events activated the SFZ at a depth of approximately 14–210 km, corresponding to the interplate Sumatran fault boundary. The identification of this seismic fault zone is significant to the investigation of seismic hazards in the region.

Dynamic source parameters are estimated from P-wave displacement spectra for 18 local earthquakes (1.2 < ML < 3.7) that occurred in two seismically active regions of Hungary between 1995 and 2004. Although the geological setting of the two areas is quite different, their source parameters cannot be distinguished. The source dimensions range from 200 to 900 m, the seismic moment from 6.3x1011 to 3.48×1014 Nm, the stress drop from 0.13 to 6.86 bar, and the average displacement is less than 1 cm for all events. The scaling relationship between seismic moment and stress drop indicates a decrease in stress drop with decreasing seismic moment. A linear relationship of M w = 0.71 M L + 0.92 is obtained between local magnitude and moment magnitude.

Seismic stratigraphy based chronostratigraphic (SSBC) analysis of the Serbian Banat region allows the delineation of the spatial and stratigraphic relationships of the generally regressive and shallowing upward Neogene depositional fill of a tectonically unstable central portion of the Pannonian Basin. When geometrically restored in time and space, the sediment dispersal directions, sediment source directions, types of sedimentation breaks and the tectonic events influencing basin evolution can be delineated. For such an analysis the time-transgressive lithostratigraphic units used in the neighbouring Hungarian part of the Pannonian Basin are conveniently introduced based upon their characteristic seismic facies and constrained borehole log records as mappable seismic stratigraphic sequence units, termed “seismic operational sequences”. The respective Neogene stage and operational sequence equivalents (Hungarian lithostratigraphic units or formations) are the Middle Miocene (Badenian, Sarmatian), Upper Miocene-Lower Pliocene (Pannonian-Endrod and Szolnok Formations; Pontian- Algyo and Ujfalu Formations and Lower Pliocene- Zagyva Formation) and Upper Pliocene-Quaternary (Nagyalfold Formation). SSBC analysis greatly assists in the geological constraint or “geovalidation” of interpreted seismic stratigraphic relationships and provides potentially critical insight into stratigraphic and structural problems of non-unique interpretations. In the specific case, using such an approach on previously unpublished regional seismic lines, SSBC analysis reveals that the Banat region has undergone structural inversion. This may be related to changes in local stress directions along strike slip faults, which initiated in earliest Late Miocene (Endrod Formation), culminating in the reverse tilting and incipient shortening of the western graben. Therefore during the time interval that the Badenian through Endrod sediments were deposited in the graben, autocyclic progradation initiated from the Kikinda Szeged High in the East followed by Szolnok, Algyo, Ujfalu and younger units prograding from the West as the central high uplifted relative to the graben. Such tectonic inversion has substantial hydrocarbon potential implications for exploration in the region.

Accurate prediction of future sea level rise requires models that accurately reproduce and explain the recent observed dramatic ice sheet behaviours. This study presents a new multi-phase, multiple-rheology, scalable and extensible geofluid model of the Greenland ice sheet that shows the credential of successfully reproducing the mass loss rate derived from the Gravity Recovery and Climate Experiment (GRACE), and the microwave remote sensed surface melt area over the past decade. Model simulated early 21st century surface ice flow compares satisfactorily with InSAR measurements. Accurate simulation of the three metrics simultaneously cannot be explained by fortunate model tuning and give us confidence in using this modelling system for projection of the future fate of Greenland Ice Sheet (GrIS). Based on this fully adaptable three dimensional, thermo-mechanically coupled prognostic ice model, we examined the flow sensitivity to granular basal sliding, and further identified that this leads to a positive feedback contributing to enhanced mass loss in a future warming climate. The rheological properties of ice depend sensitively on its temperature, thus we further verified modelâŹs temperature solver against in situ observations. Driven by the NCEP/NCAR reanalysis atmospheric parameters, the ice model simulated GrIS mass loss rate compares favourably with that derived from the GRACE measurements, or about −147 km3/yr over the 2002–2008 period. Increase of the summer maximum melt area extent (SME) is indicative of expansion of the ablation zone. The modeled SME from year 1979 to 2006 compares well with the cross-polarized gradient ratio method (XPGR) observed melt area in terms of annual variabilities. A high correlation of 0.88 is found between the two time series. In the 30-year model simulation series, the surface melt exhibited large inter-annual and decadal variability, years 2002, 2005 and 2007 being three significant recent melt episodes.

Southern Cyprus is situated within a mosaic terrane that has been fragmented between the northward drifting African and Arabian plates and the Eurasian plate. Enormous uplift of the earth mantle in the Tróodos Mountains is explained by two models. The subduction model explains subduction along the Cyprean arc to be the driving force for uplift whereas after the restraining bend model westward squeezing of Cyprus along strike-slip faulting is responsible for the enormous uplift at restraining bends. Since its emergence as an island in early Miocene times, landscape formation on Cyprus has been strongly controlled by this uplift. Until the Plio-Pleistocene, a strait belt separated the southern unroofed ophiolitic core region-the Tróodos Mountains-from the folded Kyrenia range to the north. This former sea basin, nowadays the Mesaoría Basin, is linked with the Tróodos Mountains by a dissected glacis with a thick cover of river deposits. The highest and oldest river deposits (Apalós Formation) were studied in the Vlokkariá hill southwest of Lefkosía. The 45.5 m thick Apalós Formation of Early Pleistocene age exhibits 24 sedimentary units (Fluviatile Series). Their magnetostratigraphical characters align with the Matuyama chron including the Olduvai and Jaramillo subchrons thus comprising about 1.15 Ma within the Early Pleistocene. This fluvial stack indicates a very flat and deeply lying river environment flowing from a slowly uplifting Tróodos hinterland. It happened during the end of Early Pleistocene when the enhanced Tróodos uplift started the dissection of the stacked river plain.

The method of overlying strata failure assessment of extracted seams is based upon the simultaneous assessment of surface subsidence and seismic activity, considering the spatiatemporal progress of mining, depending on the character of the rock mass. The rigid overlying strata failure assessment results in finding whether a failure of the firm overlying rocks occurred or whether a strutting arch was formed over the mined-out area. The practical importance of the overlying strata failure assessment consists in determining the size of the mined-out area at which the com-plete failure of the rigid overlying strata occurred and in the assessment of the current stress condition of the overlying strata failure. The assessment method is applicable in deep mine workings where thick coal seams are being mined by means of the method of longwall mining with controlled caving. The results of this method are used to amend contemporary known methods of rock-burst protection, namely (regarding the use of surface measurements for the evaluation) in overlying strata areas.

In the present study, the removal of dissolved and colloidal Cd, Co, Cu, Ni and Zn in Arvand River water during estuarine mixing with the Persian Gulf water is investigated. The flocculation process was investigated for a series of mixtures with salinities ranging from 0.48 to 30.3^. The flocculation rates were indicative of the non-conservative behavior of studied metals during estuarine mixing. Rapid flocculation in the low salinity regimes was observed. The order of the final flocculation rate of metals in the river water was as follows: Co (91.2%)> Cd (86.9%)> Zn (83%)> Cu (75.2%)> Ni (74.3%). Salinity, pH, EC and dissolved oxygen do not govern the flocculation of metals during estuarine mixing. The results of the present investigation show that estuarine processes can be considered as an effective mechanism in self purification of colloidal metals that are anthropogenically introduced into the fresh water ecosystem.

Some decades ago the concept of flood hazard in the Carpathian Basin was interpreted solely as riverine flood hazard, mostly restricted to the Tisza and Danube Rivers, and was closely associated with the impacts of river flow regulation in the second half of the 19th century. Recent assessments, however, allow us to outline a more diverse picture. Climate change is predicted to bring about both an increase in the frequency of droughts and excessive rainfall events, resulting in irregulaties in the water regimes of rivers in Hungary. Excess water hazard from raised groundwater levels is found to affect much larger areas than previously thought. Recent strongly localized cloudbursts, point to the increasing significance of flash floods.Riverine flooding and excess water hazard are more common in lowlands, whereas flash flood hazards are primarily, but not exclusively, affect the mountainous and hilly regions of the country. This paper intends to assess the relative importance of the three types of inundation hazard analyzed and to illustrate their overall spatial occurrences by microregions on a map series.