Volume 6, Issue 1

In this review the kinetics and mechanism of oxidative dissolution of UO2(s), mainly under conditions of relevance for the safety assessment of a deep geological repository for spent nuclear fuel, are discussed. Rate constants for the elementary processes involved (oxidation of UO2 and dissolution of oxidized UO2) are used to calculate the rates of oxidative UO2(s) dissolution under various conditions (type of oxidant, oxidant concentration and HCO3−/CO32− concentration) for which experimental data are also available. The calculated rates are compared to the corresponding experimental values under the assumption that the experimental numbers reflect the steady-state conditions of the system. The agreement between the calculated rates and the corresponding experimental ones is very good, in particular for the higher rates. In general, the calculated rates are somewhat higher than the experimental numbers. This can be due partly to the use of initial concentrations rather than steady-state concentrations in the calculations. The kinetic data are also used to quantitatively discuss the dynamics of spent nuclear fuel dissolution under deep geological repository conditions.

We have theoretically analyzed mimics of Watson-Crick AT and GC base pairs in which N-H···O hydrogen bonds are replaced by N-H···S, using the generalized gradient approximation (GGA) of density functional theory at BP86/TZ2P level. The general effect of the above substitutions is an elongation and a slight weakening of the hydrogen bonds that hold together the base pairs. However, the precise effects depend on how many, and in particular, on which hydrogen bonds AT and GC are substituted.. Another purpose of this work is to clarify the relative importance of electrostatic attraction versus orbital interaction in the hydrogen bonds involved in the mimics, using a quantitative bond energy decomposition scheme. At variance with widespread believe, the orbital interaction component in these hydrogen bonds is found to contribute more than 40% of the attractive interactions and is thus of the same order of magnitude as the electrostatic component, which provides the remaining attraction.

A simple and convenient method for the preparation of needle-shape nanoparticles of β-Ni(OH)2 has been developed. Results show that a needle-shaped β-Ni(OH)2 can be easily obtained in the presence of ethylenediamine and sodium dodecylbenzene sulfonate within a size from 100 to 200 nm. The shape and structure of the product were characterized by XRD, TEM and FT-IR. It is noteworthy that the formation of needle-shape β-Ni(OH)2 benefits from the addition of sodium dodecylbenzene sulfonate. The optimum preparation conditions and the possible mechanism are also discussed.

Three thermal effects on heating/cooling of K2TaF7 in the temperature interval of 680–800°C were investigated by the DSC method. The values determined for the enthalpy change of the individual processes are: ΔtransIIHm(K2TaF7; 703°C) = 1.7(2) kJ mol−1, ΔtransIHm(K2TaF7; 746°C) = 19(1) kJ mol−1 and ΔtransIIIHm(K2TaF7; 771°C) = 13(1) kJ mol−1. The first thermal effect was attributed to a solid-solid phase transition; the second to the incongruent melting of K2TaF7 and the third to mixing of two liquids. These findings are supported by in situ neutron powder diffraction experiments performed in the temperature interval of 654–794°C.

Palladium-catalyzed amination reactions of quinoline triflate and the effect of a Pd catalyst, its ligands, solvents, bases, and temperature were studied. This method facilitated an easier pathway for the preparation of aminoquinoline derivatives as potential precursors of new serotoninerg agents.

Poly (acrylamide-acrylic acid-dimethylaminoethylmethacrylate), p(AM-AA-DMAEM) and Poly(acrylamide-acrylic acid)-ethylenediaminetetracetic acid disodium, p(AM-AA)-EDTANa2 were prepared by gamma radiation-induced template polymerization technique and used for the separation of Ga (III) from Cu (II), Ni (II), and Zn (II) in aqueous media. The effect of pH and contact time on the separation process was studied. The optimum pH value for the separation process is 3–3.5. The result shows that Ga (III) is first extracted while Cu (II), Ni (II) and Zn(II) are slightly extracted at this pH value. The recovery of metals using HCl, HNO3 and H2SO4 has been studied. The resins may be regenerated using 2M HCl solutions.

By the reaction of 2-methyl-furan-3-carboxylic acid hydrazide with isothiocyanates, 1-[(2-methyl-furan-3-yl)carbonyl]-4-substituted thiosemicarbazides 1 were obtained. Further cyclization with 2% NaOH led to the formation of 3-(2-methyl-furan-3-yl)-4-substituted-Δ2-1,2,4-triazoline-5-thiones 2. The pharmacological effects of 2 on the central nervous system in mice were investigated. Strong antinociceptive properties of the investigated derivatives were observed in a wide range of doses.

trans-[Co(py)4Cl2]Cl·6H2O, mer-[Co(py)3Cl3] and mer-[Co(py)3(CO3)Cl] were studied by UV-Vis, far-IR and 1H, 13C, 15N NMR. The formation of Co-N bonds lead to variable in sign and magnitude changes of 1H NMR chemical shifts, heavily dependent on proton position, coordination sphere geometry and character of auxiliary ligands. 13C nuclei were deshielded upon Co(III) coordination, while 15N NMR studies exhibited ca. 85–110 ppm shielding effects (ca. 15–25 ppm more expressed for nitrogens trans to N than trans to Cl or O). 13C and 15N CPMAS spectra revealed a slight inequivalency of formally identical Co-py bonds in trans-[Co(py)4Cl2]Cl·6H2O and mer-[Co(py)3Cl3], suggesting for the latter complex an existence of distortion isomers. In chloroform, a spontaneous trans-[Co(py)4Cl2]Cl → mer-[Co(py)3Cl3] + py reaction was monitored by 1H NMR and UV-Vis. This process of py → Cl substitution allowed the design of a more convenient and efficient method of mer-[Co(py)3Cl3] preparation.

Lutetium has been determined by differential pulse anodic stripping voltammetry in an acidic solution containing Zn-EDTA. Lutetium (III) ions liberated zinc (II), which was preconcentrated on a hanging mercury drop electrode and stripped anodically, resulting in peak current linearly dependent on lutetium (III) concentration. Less than 0.4 ng mL−1 lutetium could be detected after a 2 min deposition.

In the soil solutions obtained in situ with suction cups from soils (Cambisol and Fluvisol) of pot experiment with Salix smithiana Smith, Lolium perenne L. and Thlaspi caerulescens J. & C. Presl heavy metals species (Cd, Pb and Cu) were assayed by differential pulse anodic stripping voltammetry and diffusive gradient in thin films. Prediction of accumulation performed best at free metal ion concentrations in unchanged pH (in 10−3 mol L−1 NaClO4 base electrolyte). The speciation provided by differential pulse anodic stripping voltammetry according to pH can provide a detailed description of the soil solution matrix. The concentration of free metals in unchanged pH represents a small part of the total content and varied from 0.04 to 0.75% with two exceptions found for accumulating plants (the content of Cd2+ in the soil solution from T. caerulescens was about 6% and the content of Cu2+ in the soil solution from S. smithiana was about 30%). The available concentration as determined by diffusive gradient in thin films was not in correlation with the heavy metals concentration in plant biomass.

In this study, a series of new 5-phenylazo-6-aminouracil dyes were prepared by linking m-,p-nitroaniline, m-,p-chloroaniline, m-,p-anisidine, m-,p-toluidine, m-,p-cyanoaniline, p-ethoxyaniline, p-phenoxyaniline, p-ethylaniline, p-acetamidoaniline, p-acetylaniline, p-carboxyaniline and aniline to 6-aminouracil. The prepared dyes were characterized by UV-vis, FT-IR, 1H NMR spectroscopic techniques and elemental analysis. The effect of acid and base upon the UV-vis spectra of these dyes were investigated. In addition, the solvatochromic behaviors and substituent effects in various solvents were evaluated.

The kinetics of the reaction between malachite green (MG) and sodium hydroxide (MG fading) was studied using a spectrophotometric method in the presence of two cationic surfactants, cetyl-benzyl-dimethyl-ammonium chloride (CBDAC) and hexadecyl-trimethylammonium bromide (HTAB) and one anionic surfactant, sodium dodecyl sulphate (SDS) at concentrations below and above critical micellar concentrations. The cationic surfactants have a catalytic effect, while the anionic surfactant has an inhibitory effect on the reaction. A kinetic model describing the influence of surfactant on reaction rate was developed. The results are discussed on the basis of electrostatic and hydrophobic interactions between the kinetic micelles and malachite green.

A palladium complex with an aminophosphine ligand has been prepared and investigated as a catalyst precursor in Suzuki coupling reactions in toluene. Nanoparticles composed of elemental palladium have been isolated from the reaction media and analyzed using transmission electroscopic microscope (TEM), which shows the essential catalysts palladium nanoparticles to have a size of ca. 3.0 nm.

Increasing environmental pollution caused by toxic dyes is a matter of great concern due to their hazardous nature. So it is crucial to develop processes which can destroy these dyes effectively. It has been generally agreed that reactive orange 5 (KGN) can be effectively degraded in aerated phosphotungstic acid (HPA) in a homogeneous reaction system using near-UV irradiation. In this paper, photocatalytic degradation of reactive orange 5 solutions with phosphotungstic acid was investigated, especially more attention was paid to the kinetic model and the anion degradation products. The results revealed that the photocatalytic degradation reaction of KGN with HPA in a homogenous solution can be described by Langmuir-Hinshelwood equation and Langmuir-Hinshewood kinetic model described it well. The reaction manifested the first order with lower concentration(⩽30 mg L−1) with the limiting rate constant and the adsorption constant in this case being 0.8098 mg L−1 min−1 and 4.359 10−2 L mg−1, respectively. The degradation mechanism of KGN with HPA is different from that with TiO2, the anion products of the two reaction systems are the same. The difference in degradation mechanism of KGN with HPA from that with TiO2 is caused by the nature of the photocatalyst.

Hydrogels composed of N-isopropylacrylamide (NIPAAm) and acrylic acid (AAc) were prepared by redox polymerization with degradable chitosan cross-linkers. Chitosan degradable cross-linkers were synthesized by the acrylation of the amine groups of glucosamine units within chitosan and characterized with 1H NMR. With the chitosan cross-linkers, loosely cross-linked poly(N-isopropylacryamideco-acrylic acid) [P(NIPAAm-co-AAc)] hydrogels were prepared, and their phase transition behavior, lower critical solution temperature (LCST), water content and degradation properties were investigated. The chitosan cross-linked P(NIPAAm-co-AAc) hydrogels were pliable and transparent at room temperature. The LCST could be adjusted at 32∼39°C by alternating the feed ratio. Swelling was influenced by NIPAAm/AAc monomer ratio, cross-linking density, swelling media, and temperature. All hydrogels with different feeding ratios contained more than 95% water at 25°C in the ultra pure water and phosphate-buffered saline (PBS, pH = 7.4 ± 0.1), and had a prospective swelling in the simulated gastric fluids (SGF, pH = 1.2) > 72.54%. In degradation studies, breakdown of the chitosan cross-linked P(NIPAAm-co-AAc) hydrogels was dependent on the cross-linking density. The chitosan cross-linked P(NIPAAm-co-AAc) hydrogels which can be tailored to create environmentally-responsive artificial extracellular materials have great potential for future use.

The precursors with a low manganese content ≤ 0.07% Mn were synthesized by spontaneous crystallization from Zn2+, Mn2+ and C2O42−-containing solutions. The initial ratio Zn2+:C2O42− = 1:1 and 1:2 influences the morphology and prevailing orientations of the crystallites in the oxalate samples. The presence of such small Mn content in the samples does not change the morphology or size of the crystals. The ZnO and Mn/ZnO oxides with manganese content from 0.51×10−2 to 15.1×10−2 Wt % are obtained after thermal decomposition of the oxalates. The oxides preserved the morphology of the precursors. The catalytic tests show that the pure ZnO has a poor activity for CO oxidation reaction. Its doping with Mn promotes the catalytic activity (up from twice to five times) in spite of the very low contents of the dopants. The observed increase of the activity depends on both dopant concentration and Zn2+:C2O42− ratio, probably due to the different mechanism of the manganese inclusion and different morphology of the oxides. The catalysts of the 1:2 series are more active in CO oxidation reaction.

A series of Ni-doped cobalt ferrites NixCo1−xFe2O4 (x = 0.0, 0.4, 0.6, 0.8, and 1.0) were prepared using microwave-induced combustion. Nickel, cobalt, and ferric nitrates were used as starting materials and glycine as fuel. The influence of Ni content on the lattice parameter, stretching vibrations, and magnetization was studied. XRD, FTIR, and SEM were used for structure, composition, and morphology investigation. A porous network structure was observed with average particle size 60–67 nm. All samples had a cubic spinel structure. The unit cell parameter “a” decreases linearly with nickel concentration due to the smaller ionic radius of nickel. Magnetization measurements showed that coercivity decreased as Ni content increased; it increased with decreasing temperature.