Band 2, Heft 4

The goal of this paper is to study thermal stability of some ferrocenes with acidic functional groups. Some other kinetic characteristics such as critical temperature and the rate constant corresponding to maximal degradation speed have been also evaluated. The type of functional units adjacent to the ferrocenyl unit determines thermal stability of ferrocene compounds. Groups with a powerful withdrawing effect determine a decreasing of the temperatures at which the material starts to lose weight. If a very long alkyl chain is connected to the ferrocene unit, a shielding effect in respect to the other carboxylic groups was observed, with an increase of the thermal stability.

2-(Diethylaminomethyl)phenyl bromide and 1,3-bis(dimethylaminomethyl)-benzene, useful ligands for the synthesis of hypervalent organometallic compounds, were prepared and characterized by NMR (1H, 13C, 2D experiments) spectroscopy. Their synthesis was monitored by the HPLC method. The compounds were eluted on a Nucleosil 120 Si column (5 μm, 25×0.4 cm) with n-hexane at room temperature using a 1.0 ml/min flow-rate. The maximum values of absorbance for the studied compounds, excepting the diethylamine, were located in a narrow range around 212 nm, the wavelength used for their UV detection. The diethylamine was detected at 190 nm. The calibration curves are straight lines with correlation factors r>0.995. The HPLC data are in good agreement with those provided by NMR spectroscopy.

Some investigations concerning the decolorization of Acid Red G azo dye by photooxidation with hydrogen peroxide were performed. The influences of pH, oxidant concentration, and the presence of Fe2+ or other metal ions (Co2+, Cu2+, Ni2+, Mn2+) as potential catalysts, were investigated. The best results were obtained in the presence of ferrous ions in acid and neutral media. The other ions are not as effective as Fe2+ for dye decolorization. Co2+ and Cu2+ ions have a catalytic action, at low concentration, within a wide range of pH. Ni2+ and Mn2+ ions have no catalytic effect in photooxidation with hydrogen peroxide at acid Ni2+ and Mn2+ ions have no catalytic effect in photooxidation with hydrogen peroxide at acid pH values, but show a weak action in alkaline media.

The IR-spectra of 4-aminopyridine (4-AP) in solution and in the solid state have been analyzed, using the reducing-difference procedure. Defining a more precise band assignment of a part of the characteristic frequencies of 4-AP, the data obtained proved in particular a Fermi-resonance splitting of the symmetric NH2-stretch.

Applications of the CSB (Common-Sense Builder) system for the logic-oriented and knowledge-assisted simulation of chemical reaction courses are described. We present the possibility of using the CSB for two ways of reaction simulation, i.e., as a multi-step process or as single step procedure. Results of the first simulation type are given to predict the course, and to model reaction mechanism. The second one is capable of complex chemical transformations such as multi-component and cascade reactions to generate structurally diverse products for combinatorial chemistry. In several experiments performed, we analyze the capabilities and limitations of the CSB modules and controlling tools for the examination and selective generation of solutions.

The hypothesis that the degree of hydration of poly(oxyethylene) (POE) in aqueous solution depends on the mole ratio of water molecules to ether oxygen atoms in the molecule has been verified by studying the isotropic Raman spectra in the O−H stretching region for four short-chain POEs (C 1EnC 1 withn=1−4). Excellent coincidence of the O−H stretching Raman band for all four POEs studied in the range of mole ratio H2O/Oether from 25 to 0.6 was observed, thus confirming the assumption stated above. A conclusion that all ether oxygen atoms in the POE molecule participate in hydrogen bonding with water molecules has been made.

The effect of the main factors known to govern the kinetic regularities of enzyme adsorption, such as enzyme solution concentration, temperature, pH, specific surface of the adsorbent, etc., were studied. Two kinds of disperse carbonaceous materials-activated carbon NORIT and carbon black PM-100, were used as matrices for enzyme immobilization. For both immobilization matrices studied, the amount of the adsorbed enzyme was found to reach saturation at catalase (CAT) enzyme concentrations exceeding 20 mg·mL−1 (∼100 μM). The pH of the solution affected the adsorption capacities of the selected immobilization matrices; larger amounts of CAT adsorbed were estimated in neutral and alkaline solutions than under acidic conditions for enzyme immobilization. UV-spectrophotometry was employed as a basic analytical approach in this study.

Chitosan films obtained by dry phase inversion were prepared from an aqueous solution of chitosan in acetic acid. The films, of thickness less than 20 μm, were transparent, very flexible and had smooth surfaces. Increasing the film thickness induced an increase of the internal tensions and the consequent formation of a rough surface. Structural investigations by X-ray diffraction and Fourier transform IR analysis, showed that the chitosan films, as prepared, are amorphous. Further annealing to evaporate acetic acid and water traces, changed the amorphous phase into a more ordered phase, characterized by diffraction peaks at 2θ values of 9, 17, 20 and 23 degrees. Thermal investigations by TG, DTG, and DTA revealed that the decomposition of the chitosan films as prepared proceeds in two stages, starting from 180°C and 540°C.

The results of kinetic and equilibrium experiments with the set of reaction of proton abstraction from 4-nitrophenyl[bis(ethylsulphonyl)]methane in acetonitrile are reported. Two strong organic bases are used: 1,5,7-triazabicyclo[4.4.0]dec-5-ene (TBD) and 7-methyl-1,5,7-triazabicyclo[4.4.0]dec-5-ene (MTBD). The rates of proton transfer reaction have been measured by T-jump method in the presence of perchlorate of the appropriate base as a common cation BH+ and supporting electrolyte-tetrabutylammonium perchlorate (TBAP) in the temperature range between 20–40°C are: kH=1.32×107−2.00×107 and 2.82×107−4.84×107 dm 3mol−1s−1 for MTBD and TBD respectively. The enthalpies of activation ΔHMTBD≠=13.5 and ΔHTBD≠=18.1 kJmol−1. The entropies of activation are negative: ΔSMTBD≠=−62.3 and ΔSTBD≠=−40.3 Jmol−1K−1. The change of the absorbance of the anion of 4-nitrophenyl[bis9ethylsulphonyl)]methane at the temperature 25°C in the presence of common cation BH+ gives the equilibrium constants K=705 and 906 M−1 for MTBD and TBD respectively. Kinetic and equilibrium results are discussed. The possible mechanism of proton transfer reaction between 4-nitrophenyl[bis(ethylsulphonyl)]methane and cyclic organic bases: MTBD and TBD in acetonitrile is proposed.

Equimolar mixtures of 3,5-dimethylpyrazole (1) with four NH-imidazoles (2–5) have been studied by13C and 15N CPMAS NMR and by DSC. In three cases, the solid mixture behaves as the sum of the individual components [imidazole (2), 2-methylimidazole (3) and 2,4(5)-dimethylimidazole (5)]. In one case [4,5-dimethylimidazole (4)], the mixture corresponds to a new species in which the dynamic behavior of1 no longer exists.

An interesting observation was made when studying the SNAr reaction between several 4-aryloxy-7-nitrobenzofurazans (2) and several amino acids leading to the apparition of detectable fluorescence from the substitution products3. Acidic amino acids reacted very slowly=while basic amino acids react fastest with2 having an unsubstituted phenyl or a 4-formyl-phenyl Ar group. Amongst neutral amino acids, proline reacts fastest at room temperature after 100 min. With2 having a methoxy-subtituted Ar group.

A broad range of vicinal diamines based on styrene oxide are synthesisedvia mixtures of regioisomeric amino alcohols. The ring opening of the intermediate aziridinium ions by primary amines proceeds with high regioselectivity, leading to the target diamines as single regioisomers for all reaction series. The compounds are of potential biological interest as ligands for cisplatin analogues. Anticancer activity tests of both groups of compounds are in progress.

A quantitative structure activity relationship (QSAR) study of 2-substituted 2,3-dihydro-1H-naphtho[1,8,de]-1,3,2-diazaphosphorine 2-oxides and sulphides (DND), examines the extent of the contribution by various physicochemical parameters with respect to their antimicrobial activity. Simple bivariant regression analysis, based on the least squares method, is applied in order to predict models. The predicted models reveal that the steric factor, MR, is the major contributor influencing antimicrobial activity. Bulky groups at the C-19 (C=0 group) position positively influence the potency of the compounds