Polyarylamide/Polypropylene Blends
-
A. Haddout
Abstract
This work deals with the experimental study of the rheological behaviour, the growth and evolution of the morphology of two components polyarylamide/polypropylene blends during injection molding. In the case of compatibilized blends, the viscosity shows two main results depending on shear rate. For low shear rates, up to 103 s−1, we notice a positive deviation in comparison with the additivity low, whereas a negative deviation is observed for high shear rates including injection molding conditions. The analysis of the morphology of the blend by scanning electronic microscopy shows a dispersed phase with nodules. The injection flow rate acts on the shape of the nodules and also on their repartition as obtained from a rectangular molded plate. The thermomechanical analysis of pure composition samples (100 % PA) and of a compatibilized mixture PA (70 %)/PP (30 %) has been studied.
© 1995, Carl Hanser Verlag, Munich
Artikel in diesem Heft
- Contents
- Contents
- Editorial
- Battenfeld: International Polymer Processing Machinery Manufacturer
- Screw Extrusion/Mixing
- On-line Measurement of Residence Time Distribution in a Twin-screw Extruder
- Bulk Density of Plastic Pellets in a Screw Channel
- Simulation of the Screw Bowing Effect in an Intermeshing Counter-Rotating Twin-screw Extruder
- Blending of SAN and SBS in Corotating Twin-screw Extruders
- Blends of PVC with Miscible Polymers
- Solids Transport in Extruders
- Reactive Processing
- Compounding and Morphology of Nylon/Ethylene-Propylene Rubber Reactive and Nonreactive Blends
- Die Extrusion
- Approximate Simulation Method on the Three-dimensional Polymer Melts Flow in a Die
- Molding
- On the Simulation of Thermoplastic Injection Moulding Process
- Simulation of Heat Transfer and Melting in Rotational Molding
- Polyarylamide/Polypropylene Blends
- Flexural Stiffness of Injection Molded Glass Fiber Reinforced Thermoplastics
- Control Volume Finite Element Method for Mold Filling Simulation
Artikel in diesem Heft
- Contents
- Contents
- Editorial
- Battenfeld: International Polymer Processing Machinery Manufacturer
- Screw Extrusion/Mixing
- On-line Measurement of Residence Time Distribution in a Twin-screw Extruder
- Bulk Density of Plastic Pellets in a Screw Channel
- Simulation of the Screw Bowing Effect in an Intermeshing Counter-Rotating Twin-screw Extruder
- Blending of SAN and SBS in Corotating Twin-screw Extruders
- Blends of PVC with Miscible Polymers
- Solids Transport in Extruders
- Reactive Processing
- Compounding and Morphology of Nylon/Ethylene-Propylene Rubber Reactive and Nonreactive Blends
- Die Extrusion
- Approximate Simulation Method on the Three-dimensional Polymer Melts Flow in a Die
- Molding
- On the Simulation of Thermoplastic Injection Moulding Process
- Simulation of Heat Transfer and Melting in Rotational Molding
- Polyarylamide/Polypropylene Blends
- Flexural Stiffness of Injection Molded Glass Fiber Reinforced Thermoplastics
- Control Volume Finite Element Method for Mold Filling Simulation
