Article
Licensed
Unlicensed
Requires Authentication
Multilayer Injection Moulding
Part 2: Particle tracking in reactive moulding
-
G. W. M. Peters
Published/Copyright:
May 27, 2013
Abstract
The modelling of multilayer reactive injection moulding is studied. After presenting the equations describing the process, two important aspects are dealt with in more detail. These are particle tracking and the modelling of the flow front. First results demonstrate the possibilities of the modelling and show satisfactory agreement between predictions of numerical simulations and experimental results, concerning particle tracking in the whole flow domain and the break-through of layers in sequential two component moulding.
Received: 1993-2-11
Accepted: 1994-2-18
Published Online: 2013-05-27
Published in Print: 1994-09-01
© 1994, Carl Hanser Verlag, Munich
You are currently not able to access this content.
You are currently not able to access this content.
Articles in the same Issue
- Contents
- Contents
- Editorial
- Tenth in a Series: Fried. Krupp: Pioneer Integrated Steel and Processing Machinery Manufacturer. Part 1. Essen, Magdeburg and Harburg (1812–1960)
- Internal Mixers
- Finite Element Modelling of Non-isothermal Viscometric Flows in Rubber Mixing
- Screw Extrusion and Mixing
- The Optimisation of Masterbatch Formulations for Use in Single Screw Machines
- Morphological Changes of a Polymer Blend into a Twin-Screw Extruder
- An In-line Melt Rheometer for Molten Plastics
- Selecting Continuous Compounding Equipment Based on Process Considerations
- Reactive Processing
- Peroxide Induced and Thermal Degradation of Polypropylene
- Reactive Blending of Polyamide 6 and Polycarbonate
- Modification of Polypropylene by Maleic Anhydride
- Fibers and Films
- Melt Strength Behaviour of Polypropylenes
- Molding
- Multilayer Injection Moulding
- Miscibility and Mechanical Properties of Poly(ether imide)/Liquid Crystalline Poly(ester imide) Blends
- The Effects of Recycling and Degradation on Parison Extrusion
- Modeling and Simulation of High Reynolds' Number Flows During Reaction Injection Mold Filling
Articles in the same Issue
- Contents
- Contents
- Editorial
- Tenth in a Series: Fried. Krupp: Pioneer Integrated Steel and Processing Machinery Manufacturer. Part 1. Essen, Magdeburg and Harburg (1812–1960)
- Internal Mixers
- Finite Element Modelling of Non-isothermal Viscometric Flows in Rubber Mixing
- Screw Extrusion and Mixing
- The Optimisation of Masterbatch Formulations for Use in Single Screw Machines
- Morphological Changes of a Polymer Blend into a Twin-Screw Extruder
- An In-line Melt Rheometer for Molten Plastics
- Selecting Continuous Compounding Equipment Based on Process Considerations
- Reactive Processing
- Peroxide Induced and Thermal Degradation of Polypropylene
- Reactive Blending of Polyamide 6 and Polycarbonate
- Modification of Polypropylene by Maleic Anhydride
- Fibers and Films
- Melt Strength Behaviour of Polypropylenes
- Molding
- Multilayer Injection Moulding
- Miscibility and Mechanical Properties of Poly(ether imide)/Liquid Crystalline Poly(ester imide) Blends
- The Effects of Recycling and Degradation on Parison Extrusion
- Modeling and Simulation of High Reynolds' Number Flows During Reaction Injection Mold Filling
