Artikel
Lizenziert
Nicht lizenziert
Erfordert eine Authentifizierung
Mechanical Properties of Thermoplastic Polyurethane Blends and Copolymers of Styrene and Acrylonitrile
-
B. Žerjal
Veröffentlicht/Copyright:
27. Mai 2013
Abstract
Mechanical data obtained on the blends described in a previous paper together with some new data have been correlated with the theory derived for the mechanical properties of polymer composites, to gain insight into the nature of domain interfaces. Thermoplastic polyurethanes are blended in the entire composition range, with styrene-acrylonitrile copolymers. Blending with thermoplastic polyurethanes improves the toughness. Improved toughness is indicated by the increase of elongation at break and by decrease of hardness.
Received: 1991-3
Accepted: 1991-8
Published Online: 2013-05-27
Published in Print: 1992-05-01
© 1992, Carl Hanser Verlag, Munich
Sie haben derzeit keinen Zugang zu diesem Inhalt.
Sie haben derzeit keinen Zugang zu diesem Inhalt.
Artikel in diesem Heft
- Contents
- Contents
- Continuous Mixing and Compounds
- Starve-fed Flow in Co-Rotating Twin Screw Extruders
- Process for Improvement in Toughness of Unsaturated Polyester with Elastomer
- Mechanical Properties of Thermoplastic Polyurethane Blends and Copolymers of Styrene and Acrylonitrile
- Extrusion
- Mixing on Melting in Single Screw Extrusion
- Numerical Study of Slip at the Walls in the Extruder
- Elimination of Sag in Plastic Pipe Extrusion
- Fibers and Film
- Issues Concerning the Rate of Heat Transfer from a Spinline
- Skew Stretched Polycarbonate Films
- Molding
- Molecular Orientation in Injection-Molded Polypropylene Copolymers with Ethylene
- Melt-recrystallization of Talc-filled Polypropylene Injection Moldings
- Processing Characteristics of Thermoplastic Sheet Composites
- Rapid Communication of Recent Advances
- The Face-relief Strategy for Design of Profile Dies
Artikel in diesem Heft
- Contents
- Contents
- Continuous Mixing and Compounds
- Starve-fed Flow in Co-Rotating Twin Screw Extruders
- Process for Improvement in Toughness of Unsaturated Polyester with Elastomer
- Mechanical Properties of Thermoplastic Polyurethane Blends and Copolymers of Styrene and Acrylonitrile
- Extrusion
- Mixing on Melting in Single Screw Extrusion
- Numerical Study of Slip at the Walls in the Extruder
- Elimination of Sag in Plastic Pipe Extrusion
- Fibers and Film
- Issues Concerning the Rate of Heat Transfer from a Spinline
- Skew Stretched Polycarbonate Films
- Molding
- Molecular Orientation in Injection-Molded Polypropylene Copolymers with Ethylene
- Melt-recrystallization of Talc-filled Polypropylene Injection Moldings
- Processing Characteristics of Thermoplastic Sheet Composites
- Rapid Communication of Recent Advances
- The Face-relief Strategy for Design of Profile Dies
