Processing of ABS Latex in a Single Screw Extruder

A. K. Ghosh; J. T. Lindt

doi:10.3139/217.900195

Article

Processing of ABS Latex in a Single Screw Extruder

A. K. Ghosh and J. T. Lindt

Published/Copyright: May 27, 2013

Published by

Become an author with De Gruyter Brill

Submit Manuscript Author Information

From the journal International Polymer Processing Volume 5 Issue 3

Abstract

The feasibility of the continuous and direct conversion from latex to wet crumb through the coagulation process in an extruder has been demonstrated through this work. The coagulation efficiency in the extruder has been largely governed by temperature. The maximum rate of increase of the first and the second moments of the particle size distribution of the coagulated latex occur in the neighborhood of the polymer glass transition temperature. The particle densities showed no longer a one-to-one relationship to the specific surface typical of the batch coagulation experiments, as the material coagulated in the extruder did not reach the same degree of equilibrium. Although the basic trends remained the same as in the batch coagulation experiments, the addition of residence time distribution, inherently associated with the extruder operation, introduced some significant changes into the coagulation process.

* Mail address: Prof. Dr. J. Thomas Lindt, Material Science & Engineering Dept., University of Pittsburgh, 848 Benedum Hall, Pittsburgh, PA 15261, U.S.A.

Published Online: 2013-05-27

Published in Print: 1990-09-01

You are currently not able to access this content.

Articles in the same Issue

https://doi.org/10.3139/217.900195