Skip to main content
Article
Licensed
Unlicensed Requires Authentication

Modified Flow Analysis Network Method for Analysis of Extrusion and Molding

  • , and
Published/Copyright: May 27, 2013
Become an author with De Gruyter Brill
Submit Manuscript Author Information
International Polymer Processing
From the journal International Polymer Processing Volume 5 Issue 3

Abstract

An improved form of the numerical FAN method of Tadmor, Broyer, and Gutfinger for solving hydrodynamic lubrication theory problems in flow through molds and dies has been developed. The new procedure takes into consideration transverse shearing in two rather than only one direction. It is also applied to the class of problems considered by Szydlowski, Brzoskowski, and White which involved applying this technique to situations when one surface is stationary and the other moves, such as in screw sections of extruders.

* Mail address: Prof. Dr. J. L. White, Institute of Polymer Engineering, University of Akron, Akron, Ohio 44 325, U.S.A.
Published Online: 2013-05-27
Published in Print: 1990-09-01

© 1990, Carl Hanser Verlag, Munich

Articles in the same Issue

  1. Contents
  2. Contents
  3. Original Contributions
  4. Modelling Twin Rotor Mixers and Extruders
  5. Flow Analysis in an Internal Mixer
  6. Flow Analysis in an Internal Mixer
  7. Flow Field Characterization in a Banbury Mixer
  8. State of Dispersion – Mechanical Properties Correlation in Small Particle Filled Polymer Composites
  9. Modified Flow Analysis Network Method for Analysis of Extrusion and Molding
  10. Processing of ABS Latex in a Single Screw Extruder
  11. Modelling Flow in Tangential Counter-rotating Twin Screw Extruders
  12. Throughput characteristics of Tightly Intermeshing Co-rotating Twin Screw Extruders
https://doi.org/10.3139/217.900191

Articles in the same Issue

  1. Contents
  2. Contents
  3. Original Contributions
  4. Modelling Twin Rotor Mixers and Extruders
  5. Flow Analysis in an Internal Mixer
  6. Flow Analysis in an Internal Mixer
  7. Flow Field Characterization in a Banbury Mixer
  8. State of Dispersion – Mechanical Properties Correlation in Small Particle Filled Polymer Composites
  9. Modified Flow Analysis Network Method for Analysis of Extrusion and Molding
  10. Processing of ABS Latex in a Single Screw Extruder
  11. Modelling Flow in Tangential Counter-rotating Twin Screw Extruders
  12. Throughput characteristics of Tightly Intermeshing Co-rotating Twin Screw Extruders
Downloaded on 21.4.2026 from https://www.degruyterbrill.com/document/doi/10.3139/217.900191/html
Scroll to top button