Contents

Articles in the same Issue

1. Contents
2. Contents
3. Regular Contributed Articles
4. Applicability of the Impact Response Analysis Method for Reinforced Concrete Beams Mixed with Polyvinyl Alcohol Short Fibers
5. Epoxy-Montmorillonite Nanocomposites Applied to Powder Coatings
6. Direct Imprinting Using Magnetic Nickel Mold and Electromagnetism Assisted Pressure for Replication of Microstructures
7. Automated Mold Heating System Using High Frequency Induction with Feedback Temperature Control
8. The Prediction of Bowing Distortion of Film after Transverse Stretching with Consideration of Heated Air Flow in a Tenter
9. The Influence of Injection Molding and Injection Compression Molding on Ultra-high Molecular Weight Polyethylene Polymer Microfabrication
10. A Design-of-Experiment Study on the Microcellular Extrusion of Sub-critical CO₂ Saturated PLA Pellets
11. Optimization of Injection Molding Process for SGF and PTFE Reinforced PC Composites Using Response Surface Methodology and Simulated Annealing Approach
12. Flow Visualisation in Co-rotating Twin Screw Extruders: Positron Emission Particle Tracking and Numerical Particle Trajectories
13. The Influence of Melt and Process Parameters on the Quality and Occurrence of Part Defects in Water-assisted Injection Molded Tubes
14. Model and Numerical Simulation for the Second Penetration in Water-assisted Injection Molding
15. Influence of Extrusion Conditions on the Rheological Behavior of Nuclear Bituminized Waste Products
16. Influence of Dicumyl Peroxide Content on Thermal and Mechanical Properties of Polylactide
17. Rapid Communications
18. Calculation of Average Residence Time in a Ko-kneader
19. PPS-News
20. PPS News