Contents

Articles in the same Issue

1. Contents
2. Contents
3. Regular Contributed Articles
4. Swelling Properties and Environmental Responsiveness of a Superabsorbent Composite Microsphere Based on Starch-g-Poly(acrylic acid)/Organo-Mordenite
5. Study on Permeability of Porous Ultra-High Molecular Weight Polyethylene (UHMWPE)
6. Precise Fabrication of Fresnel Flash Lens Featured with V-Grooved Microstructures
7. Ion Etching Induced Surface Patterns of Blend Polymer (Poly Ethylene Glycol – Poly Methyl Methacrylate) Irradiated with Gamma Rays
8. Devulcanization of Scrap Tire Rubber with Supercritical CO₂: A Study of the Effects of Process Parameters on the Properties of Devulcanized Rubber
9. Forming of Thermoplastic Matrix Composites with Gas Pressure – the Influence of Blank Holder and Sheet Temperature on the Forming Pressure and Drawing Ratio
10. Time Dependence of Morphology and Mechanical Properties of Injection Molded Recycled PET
11. A Generalized 2D Output Model of Polymer Melt Flow in Single-Screw Extrusion
12. Flow Behavior of PP-Polymer Nanocomposites in Capillary and Injection Molding Dies
13. A Recollection with Respect to Flow Induced Crystallization in Polymer Melt Processing
14. Optical Properties of HDPE in Injection Molding and Injection Press Molding for IR System Lenses Part II: Mold Temperature and Surface Roughness Effects on Injection Molding
15. Modeling Temperature and Time Dependence of the Wetting of Tool Steel Surfaces by Polymer Melts
16. Modification Induced by Gamma Irradiation in Polystyrene/Poly(methyl methacrylate) Blends
17. Rapid Communications
18. Study on the Influence of Extrusion Temperature and Extrusion Die on the Properties of Self-Reinforced PP Sheets
19. PPS News
20. PPS News
21. Seikei Kakou Abstracts
22. Seikei-Kakou Abstracts