Skip to main content
Article
Licensed
Unlicensed Requires Authentication

Contents

Published/Copyright: August 12, 2013
Become an author with De Gruyter Brill
Submit Manuscript Author Information
Practical Metallography
From the journal Practical Metallography Volume 50 Issue 5

Published Online: 2013-08-12
Published in Print: 2013-05-15

© 2013, Carl Hanser Verlag, München

Articles in the same Issue

  1. Contents/Inhalt
  2. Contents
  3. Editorial
  4. Editorial
  5. Technical Contributions/Fachbeiträge
  6. TEM Sample Preparation of a Hard Metal by Semiautomatic Wedge Polishing
  7. Metallographic Analysis of the Dead Metal Zone In Metal Cutting With a Rounded-Edge Tool
  8. EBSD- und TEM-Investigations of the Deformation Induced Martensitic Transformation in the Austenitic Steel X6CrNiNb18–10 under Cyclic Loading
  9. Multiple Fractures of Used In-Service Disc Springs in a Stationary Gas Turbine Engine
  10. Meeting Diary/Veranstaltungskalender
  11. Meeting Diary
https://doi.org/10.3139/147.013052

Articles in the same Issue

  1. Contents/Inhalt
  2. Contents
  3. Editorial
  4. Editorial
  5. Technical Contributions/Fachbeiträge
  6. TEM Sample Preparation of a Hard Metal by Semiautomatic Wedge Polishing
  7. Metallographic Analysis of the Dead Metal Zone In Metal Cutting With a Rounded-Edge Tool
  8. EBSD- und TEM-Investigations of the Deformation Induced Martensitic Transformation in the Austenitic Steel X6CrNiNb18–10 under Cyclic Loading
  9. Multiple Fractures of Used In-Service Disc Springs in a Stationary Gas Turbine Engine
  10. Meeting Diary/Veranstaltungskalender
  11. Meeting Diary
Downloaded on 16.4.2026 from https://www.degruyterbrill.com/document/doi/10.3139/147.013052/html
Scroll to top button