Study on photocatalytic activity based on different pH values of AgBr/Ag2CO3 heterojunction
-
Fengfeng Li
,
Mingxi Zhang
Abstract
In this work, we fabricate a highly efficient photocatalytic AgBr/Ag2CO3 heterojunction through the co-precipitation method. The obtained samples were characterized by means of X-ray diffraction, scanning electron microscopy, transmission electron microscopy, ultraviolet-visible diffuse reflectance spectra and X-ray photoelectron spectroscopy. The photocatalytic activities of obtained samples can be assessed by visible light (λ ≥ 400 nm) degradation of rhodamine B solution. X-ray diffraction revealed that the crystallinity of the AgBr/Ag2CO3heterojunction was significantly higher than pure AgBr and Ag2CO3. Moreover, the AgBr/ Ag2CO3 heterojunction prepared at pH = 6 has the best photocatalytic performance, it can raise the degradation degree of rhodamine B over 95% at 20 min. Finally, a possible photocatalytic mechanism is discussed.
© 2020 by Walter de Gruyter Berlin/Boston
Artikel in diesem Heft
- CONTENTS
- Original Contributions
- Preparation of silicon boride SiBx (x = 3, 4, 5, 6) powders by chemical oven self-propagating combustion synthesis
- Structural, electrical and magnetic properties of glucose-capped CdS nanoparticles
- Microstructure and texture of Ti-6Al-4V alloy deformed by rotary forging at elevated temperatures
- The influence of multi-pass friction stir processing on microstructure and sliding wear behavior of Cu/ZrO2 surface composite
- Mechanical bonding in cold roll-cladding of tri-layered brass/steel/brass composite
- Borocarbide coarsening and the effect of borocarbide particle size on Charpy V-notch impact properties of medium-carbon boron-containing steel
- Study on photocatalytic activity based on different pH values of AgBr/Ag2CO3 heterojunction
- Study of the crystallization kinetics of a Zr57Cu15.4Ni12.6Al10Nb5 amorphous alloy
- Highly efficient biocide silver-doped soda lime glass for application in water quality optical sensors
- The synergistic effect of 2-mercaptobenzotiazole and zinc nitrate as corrosion inhibitor on carbon steel in saline solution
- Short Communications
- Accelerated degradation rate of high-strength Mg-4Y-1Zn alloy by Cu addition for degradable bridge-plug applications
- Notifications
- DGM
- Conferences
- Imprint
Artikel in diesem Heft
- CONTENTS
- Original Contributions
- Preparation of silicon boride SiBx (x = 3, 4, 5, 6) powders by chemical oven self-propagating combustion synthesis
- Structural, electrical and magnetic properties of glucose-capped CdS nanoparticles
- Microstructure and texture of Ti-6Al-4V alloy deformed by rotary forging at elevated temperatures
- The influence of multi-pass friction stir processing on microstructure and sliding wear behavior of Cu/ZrO2 surface composite
- Mechanical bonding in cold roll-cladding of tri-layered brass/steel/brass composite
- Borocarbide coarsening and the effect of borocarbide particle size on Charpy V-notch impact properties of medium-carbon boron-containing steel
- Study on photocatalytic activity based on different pH values of AgBr/Ag2CO3 heterojunction
- Study of the crystallization kinetics of a Zr57Cu15.4Ni12.6Al10Nb5 amorphous alloy
- Highly efficient biocide silver-doped soda lime glass for application in water quality optical sensors
- The synergistic effect of 2-mercaptobenzotiazole and zinc nitrate as corrosion inhibitor on carbon steel in saline solution
- Short Communications
- Accelerated degradation rate of high-strength Mg-4Y-1Zn alloy by Cu addition for degradable bridge-plug applications
- Notifications
- DGM
- Conferences
- Imprint
