Comparative study of corrosion resistance between four non-commercial high manganese steel models and 9% nickel steel in aqueous solution of H2SO4
-
Mauro Andres Cerra Florez
,
Jorge Luiz Cardoso
Abstract
The present study aims to establish a comparison of corrosion resistance between four (non-commercial) high manganese steel models in relation to 9% nickel steel in an aqueous solution of H2SO4. High manganese steels have emerged as an alternative material for the manufacture of equipment for the storage and transportation of liquefied petroleum gas due to their mechanical properties and mainly for the lower cost compared to 9% nickel steel. The electrochemical techniques used were open circuit potential, linear polarization and electrochemical impedance spectroscopy. The results obtained by these techniques have helped to understand the phenomena that produce a lower corrosion resistance of high manganese steels when compared to 9% nickel steel in aqueous solutions.
© 2020 by Walter de Gruyter Berlin/Boston
Articles in the same Issue
- CONTENTS
- Original Contributions
- Effects of hydroxyapatite content on mechanical properties and in-vitro corrosion behavior of ZK60/HA composites
- The effect of plastic deformation on mechanical properties of aluminium matrix composites reinforced with 2D crystals
- Production and characterization of Al6061/zirconium carbide surface composites
- Microstructure and mechanical properties of rolled Mg–Gd–Zn–Zr–Ag–Al–Li alloys
- Anodizing and its effects on mechanical properties and corrosion resistance of laser additive manufactured Ti-6Al-4V alloy
- Comparative study of corrosion resistance between four non-commercial high manganese steel models and 9% nickel steel in aqueous solution of H2SO4
- Optimization of the grain boundary character distribution of pure copper by low-strain thermomechanical processing
- Two-step annealing treatment for grain refinement of cold-worked AISI 316L stainless steel
- Crystal structure, microstructure, and magnetic properties of the Fe2CrSi nanostructured Heusler alloy elaborated by the mechanical alloying method
- Experimental study of parameters influencing the damping of particulate, fibre-reinforced, hybrid, and sandwich composites
- Displacement cascade evolution in tungsten with pre-existing helium and hydrogen clusters: a molecular dynamics study
- Notifications
- DGM
- Conferences
- Imprint
Articles in the same Issue
- CONTENTS
- Original Contributions
- Effects of hydroxyapatite content on mechanical properties and in-vitro corrosion behavior of ZK60/HA composites
- The effect of plastic deformation on mechanical properties of aluminium matrix composites reinforced with 2D crystals
- Production and characterization of Al6061/zirconium carbide surface composites
- Microstructure and mechanical properties of rolled Mg–Gd–Zn–Zr–Ag–Al–Li alloys
- Anodizing and its effects on mechanical properties and corrosion resistance of laser additive manufactured Ti-6Al-4V alloy
- Comparative study of corrosion resistance between four non-commercial high manganese steel models and 9% nickel steel in aqueous solution of H2SO4
- Optimization of the grain boundary character distribution of pure copper by low-strain thermomechanical processing
- Two-step annealing treatment for grain refinement of cold-worked AISI 316L stainless steel
- Crystal structure, microstructure, and magnetic properties of the Fe2CrSi nanostructured Heusler alloy elaborated by the mechanical alloying method
- Experimental study of parameters influencing the damping of particulate, fibre-reinforced, hybrid, and sandwich composites
- Displacement cascade evolution in tungsten with pre-existing helium and hydrogen clusters: a molecular dynamics study
- Notifications
- DGM
- Conferences
- Imprint
