The effect of nano-SiO2 on magnetic and dielectric properties of Li–Zn ferrite
-
and
Abstract
Densification, grain growth, magnetic and dielectric properties of sintered Li–Zn ferrite (Li0.3Zn0.4Fe2.3O4) doped with nano silicon dioxide (10 nm) were investigated. The density and microstructural results revealed that increasing the nano-SiO2 content resulted in lower density and higher porosity at sintering temperatures below 1 000 °C, whereas at higher temperatures, this led to higher density and grain growth. In addition, nano-SiO2 content greater than 2 wt.% resulted in more reduction in porosity and had no effect on grain growth. Moreover, the highest density and the maximum induction (Bs = 380 mT) were obtained for the sample containing 2 wt.% nano-SiO2 and sintered at 1 100 °C for 1.5 h, in comparison with undoped samples. Furthermore, the variation of magneto-dielectric properties as a function of frequency were explained according to Koop's theory and electron hopping between the Fe+ 2 and Fe+ 3 ions.
References
[1] A.Goldman: Modern Ferrite Technology, Springer (2009).Search in Google Scholar
[2] P.Baba, G.M.Argentina, W.E.Courtney, G.F.Dionne, D.H.Temme: IEEE Trans. Magn.8 (1972) 83. 10.1109/TMAG.1972.1067269Search in Google Scholar
[3] N.Rezlescu, C.Doroftei, E.Rezlescu, P.D.Popa: Sens. Actuators B133 (2008) 420. 10.1016/j.snb.2008.02.047Search in Google Scholar
[4] M.Kavanlooee, B.Hashemi, H.Maleki-Ghaleh, J.Kavanlooee: J. Electron. Mater.41 (2012) 3082. 10.1007/s11664-012-2235-ySearch in Google Scholar
[5] M.Kavanloui, B.Hashemi: Mater. Des.32 (2011) 4257. 10.1016/j.matdes.2011.04.019Search in Google Scholar
[6] M.S.Ruiz, S.E.Jacobo: Physica B407 (2012) 3274. 10.1016/j.physb.2011.12.085Search in Google Scholar
[7] H.Shokrollahi, K.Janghorban: Mater. Sci. Eng. B141 (2007) 91. 10.1016/j.mseb.2007.06.005Search in Google Scholar
[8] Z.H.Khan, M. MahbuburRahman, S.S.Sikder, M.A.Hakim, D.K.Saha: J. Alloys Compd.548 (2013) 208. 10.1016/j.jallcom.2012.09.037Search in Google Scholar
[9] S.K.Nath, M.M.Rahman, S.Sikder, M.Hakim, S.M.Hoque: ARPN Int. J. Sci. Technol.3 (2013) 106.Search in Google Scholar
[10] M.M.Rahman, P.K.Halder, F.Ahmed, T.Hossain, M.Rahaman: J. Sci. Res.4 (2012) 297. 10.3329/jsr.v4i2.9407Search in Google Scholar
[11] X.Cui, J.Zhou, B.Li, Z.Tong: Mater. Manuf. Processes22 (2007) 251. 10.1080/10426910601134088Search in Google Scholar
[12] S.Pervin, M.M.Rahman, F.Ahmed, M.A.Hakim: Indian J. Phys.86 (2012) 1065. 10.1007/s12648-012-0179-ySearch in Google Scholar
[13] R.K.Kotnala, V.Verma, V.Pandey, V.P.S.Awana, R.P.Aloysius, P.C.Kothari: Solid State Commun.143 (2007) 527. 10.1016/j.ssc.2007.07.007Search in Google Scholar
[14] I.Maghsoudi, M.J.Hadianfard, H.Shokrollahi: J. Alloys Compd.481 (2009) 539. 10.1016/j.jallcom.2009.03.018Search in Google Scholar
[15] J.Mao, C.Hua, Y.Liu, M.J.Tu: Adv. Appl. Ceram.106 (2007) 171. 10.1179/174367607X169102Search in Google Scholar
[16] N.K.Prasad, A.Naulakha, N.Jha, S.S.Meena, D.Bahadur, O.Prakash, R.K.Mandal: Int. J. Mater. Res.104 (2013) 680. 10.3139/146.110909Search in Google Scholar
[17] K.W.Wagner: Ann. Phys. (Leipzig)40 (1913) 817. 10.1002/andp.19133450502Search in Google Scholar
[18] B.I.Bleaney: Electricity and Magnetism, Vol. 2, Oxford University Press (2013).Search in Google Scholar
[19] C.Koops: Phys. Rev.83 (1951) 121. 10.1103/PhysRev.83.121Search in Google Scholar
[20] A.K.Singh, T.Goel, R.Mendiratta, O.Thakur, C.Prakash: J. Appl. Phys.91 (2002) 6626. 10.1063/1.1421220Search in Google Scholar
[21] M.N.Ashiq, M. JavedIqbal, I.H.Gul: J. Magn. Magn. Mater.323 (2011) 259. 10.1016/j.jmmm.2010.08.054Search in Google Scholar
[22] M.Drofenik, A.Znidarsic, D.Makovec: J. Am. Ceram. Soc.81 (1998) 2841. 10.1111/j.1151-2916.1998.tb02704.xSearch in Google Scholar
[23] M.Maisnam, S.Phanjoubam: Solid State Commun.152 (2012) 320. 10.1016/j.ssc.2011.11.019Search in Google Scholar
[24] M.K.Das, M.M.Rahman, B.M.Sonia, F.Ahmed, M.A.Hossain, M.Rahaman, M.S.Bashar, T.Hossain, D.K.Saha, S.Akhter: Adv. Chem. Lett.1 (2013) 104. 10.1166/acl.2013.1022Search in Google Scholar
[25] Z.H.Khan, M.M.Rahman, S.S.Sikder, M.A.Hakim, S.Akhter, H.N.Das, B.Anjuman, Adv. Chem. Lett.1 (2013) 111. 10.1166/acl.2013.1016Search in Google Scholar
[26] P.D.Zade, A.P.Vanerkar, D.M.Dharmadhikari: Int. J. Mater. Res.99 (2008) 313. 10.3139/146.101641Search in Google Scholar
[27] M.L.Mane, V.N.Dhage, K.Ranganathan, S.M.Oak, K.M.Jadhav: Radiat. Eff. Defects Solids.166 (2011) 435. 10.1080/10420150.2011.559233Search in Google Scholar
[28] A.M.Shaikh, S.S.Bellad, B.K.Chougule: J. Magn. Magn. Mater.195 (1999) 384. 10.1016/S0304-8853(99)00138-9Search in Google Scholar
[29] M.M.Rahman, B.M.Sonia, M.K.Das, F.Ahmed, M.A.Hossain, D.Saha, S.Akhter: Int. J. Phys.1 (2013) 128.Search in Google Scholar
[30] B.Yuksel, S.Kirtay, T.O.Ozkan, E.Acikalin, H.Erkalfa: J. Magn. Magn. Mater.320 (2008) 714. 10.1016/j.jmmm.2007.08.033Search in Google Scholar
[31] B.D.Cullity: Introduction to Magnetic Materials, Addison-Wesley publishing company, MA, USA (1972).Search in Google Scholar
© 2014, Carl Hanser Verlag, München
Articles in the same Issue
- Contents
- Contents
- Original Contributions
- Thermodynamic description of the Ta–W–Zr system
- Interrelationships of defects, nitride modification and excess nitrogen in nitrided Fe-4.75 at.% Al alloy
- Effects of rotating magnetic and ultrasonic fields on the microstructure and mechanical properties of Al-8 wt.%Si alloy
- Microstructural control of Ti-46Al-7Nb-0.7Cr-0.2Ni-0.1Si alloy by heat treatment
- Structure and mechanical properties of Zn-(5–25) Al alloys
- Hot ductility behavior of near-alpha titanium alloy IMI834
- The effect of nano-SiO2 on magnetic and dielectric properties of Li–Zn ferrite
- Production of aluminum nano-composite reinforced by tungsten carbide particles via mechanical milling and subsequent hot pressing
- Short Communications
- Microstructure and texture evolution of Mg–Li alloy during rolling
- Microstructure and mechanical properties of Ti2AlC-reinforced TiAl composites
- Thermal fatigue behavior of cast superalloy Inconel 713LC
- Study of structural, morphological and optical properties of S and Cu co-doped SnO2 nanostructured thin films prepared by spray pyrolysis
- Synthesis and characterization of zirconium nitride coatings by cathodic arc sputtering technique
- Plasmon enhanced scattering and fluorescence in amorphous matrix
- Novel preparation of a porous composite insulating scaffold from forsterite and sodium carbonate media
- People
- Werner Mader, 65 years
- DGM News
- DGM News
Articles in the same Issue
- Contents
- Contents
- Original Contributions
- Thermodynamic description of the Ta–W–Zr system
- Interrelationships of defects, nitride modification and excess nitrogen in nitrided Fe-4.75 at.% Al alloy
- Effects of rotating magnetic and ultrasonic fields on the microstructure and mechanical properties of Al-8 wt.%Si alloy
- Microstructural control of Ti-46Al-7Nb-0.7Cr-0.2Ni-0.1Si alloy by heat treatment
- Structure and mechanical properties of Zn-(5–25) Al alloys
- Hot ductility behavior of near-alpha titanium alloy IMI834
- The effect of nano-SiO2 on magnetic and dielectric properties of Li–Zn ferrite
- Production of aluminum nano-composite reinforced by tungsten carbide particles via mechanical milling and subsequent hot pressing
- Short Communications
- Microstructure and texture evolution of Mg–Li alloy during rolling
- Microstructure and mechanical properties of Ti2AlC-reinforced TiAl composites
- Thermal fatigue behavior of cast superalloy Inconel 713LC
- Study of structural, morphological and optical properties of S and Cu co-doped SnO2 nanostructured thin films prepared by spray pyrolysis
- Synthesis and characterization of zirconium nitride coatings by cathodic arc sputtering technique
- Plasmon enhanced scattering and fluorescence in amorphous matrix
- Novel preparation of a porous composite insulating scaffold from forsterite and sodium carbonate media
- People
- Werner Mader, 65 years
- DGM News
- DGM News