Infrared spectroscopy and X-ray diffraction data of In – Se compounds
Abstract
The aim of the present work is to contribute to the identification of indium – selenium phases. Infrared absorption spectra were obtained from some indium – selenium compounds (In4Se3, InSe, In6Se7, α-In2Se3). X-ray diffractograms of the recently found phase In9Se11 and of InSe are also reported. Both kinds of data can be used for identification of the respective compounds.
It is confirmed that α-In2Se3 is stable at room temperature. The stability of the hexagonal InSe modification is also proved and its lattice parameters are recalculated.
References
[1] S.Marsillac, A.M.Combot-Marie, J.C.Bernede, A.Conan: Thin Solid Films209 (1996) 14.10.1016/S0040-6090(96)08799-8Search in Google Scholar
[2] C.Chang, A.Davidov, B.Stanbery, T.Andersen: Conf. Rec. IEEE Photovoltaic Spec. Conf., 25th (1996) 849.Search in Google Scholar
[3] G.Vassilev, P.Docheva, N.Nancheva, B.Arnaudov, I.Dermendjiev: Mater. Chem. and Phys.82 (2003) 905.10.1016/j.matchemphys.2003.08.005Search in Google Scholar
[4] G.P.Vassilev: Bulg. Chem. Communications29 (29) (1996/97) 715.Search in Google Scholar
[5] J.-C.Tedenac, G.P.Vassilev, B.Daouchi, J.Rachidi, G.Brun: Cryst. Res. Techn.32 (4) (1997) 605.10.1002/crat.2170320417Search in Google Scholar
[6] G.P.Vassilev, B.Daouchi, M.C.Record, J.-C.Tedenac: J. Alloys and Comp. (JALCOM)269 (1998) 107.10.1016/S0925-8388(98)00007-3Search in Google Scholar
[7] B.Daouchi, M.C.Record, J.-C.Tedenac, G.Vassilev: Z. Metallkd., 89 (1998) 612.Search in Google Scholar
[8] T.Massalski: ASM CD-ROM, Binary Phase Diagrams, Sec. edition, ASM International, Ohio, USA, 1996.Search in Google Scholar
[9] T.Gödecke, T.Haalboom, F.Sommer: J. Phase Equil.19 (1998) 572.Search in Google Scholar
[10] H.D.Lutz, M.Fischer, H.Baldus, R.Blachnik: J. Less-Com. Met.143 (1988) 83.10.1016/0022-5088(88)90033-1Search in Google Scholar
© 2007, Carl Hanser Verlag, München
Articles in the same Issue
- Contents
- Contents
- Editorial
- Editorial
- Basic
- Synthesis and oxidation of Zr3Al3C5 powders
- Standard Gibbs energy of formation of Zn17Y2 and Zn12Y determined by solution calorimetry and measurement of heat capacity from near zero Kelvin
- Phase equilibria in the Zn–Fe–S system at 450°C
- Formation of δ-Al2O3 hollow nanoparticles via a chemical vapor condensation process
- Low-cycle fatigue and damage of an uncoated and coated single crystal nickel-base superalloy SCB
- Fluidity of Mg–Al–Ca alloys in the high-pressure die casting process
- Applied
- Mechanical properties of rope-reinforced aluminium extrusions under quasistatic loading conditions
- Influence of interfaces on the mechanical properties of ultrahigh carbon steel multilayer laminates
- Thermomechanical processing of AA6061 billets for semi-solid forming
- Infrared spectroscopy and X-ray diffraction data of In – Se compounds
- Synthesis and characterization of MgAlON–BN composites
- Neutron diffraction residual stress analysis of steel engineering components: a study of the elastic and plastic anisotropy
- Notifications
- DGM News
Articles in the same Issue
- Contents
- Contents
- Editorial
- Editorial
- Basic
- Synthesis and oxidation of Zr3Al3C5 powders
- Standard Gibbs energy of formation of Zn17Y2 and Zn12Y determined by solution calorimetry and measurement of heat capacity from near zero Kelvin
- Phase equilibria in the Zn–Fe–S system at 450°C
- Formation of δ-Al2O3 hollow nanoparticles via a chemical vapor condensation process
- Low-cycle fatigue and damage of an uncoated and coated single crystal nickel-base superalloy SCB
- Fluidity of Mg–Al–Ca alloys in the high-pressure die casting process
- Applied
- Mechanical properties of rope-reinforced aluminium extrusions under quasistatic loading conditions
- Influence of interfaces on the mechanical properties of ultrahigh carbon steel multilayer laminates
- Thermomechanical processing of AA6061 billets for semi-solid forming
- Infrared spectroscopy and X-ray diffraction data of In – Se compounds
- Synthesis and characterization of MgAlON–BN composites
- Neutron diffraction residual stress analysis of steel engineering components: a study of the elastic and plastic anisotropy
- Notifications
- DGM News
