Article
Licensed
Unlicensed Requires Authentication

DGM News

Published/Copyright: February 22, 2017
Become an author with De Gruyter Brill
Submit Manuscript Author Information
International Journal of Materials Research
From the journal International Journal of Materials Research Volume 108 Issue 3

Published Online: 2017-02-22
Published in Print: 2017-03-13

© 2017, Carl Hanser Verlag, München

Articles in the same Issue

  1. Contents
  2. Contents
  3. Original Contributions
  4. Effect of grain defects on the mechanical behavior of nickel-based single crystal superalloy
  5. Evolution of mechanical properties and microstructure of differently cryogenically treated hot die steel AISI–H13
  6. Microstructure and mechanical properties of nickel particle reinforced magnesium composite: impact of reinforcement introduction method
  7. Microstructure and mechanical properties of carbon nanotube-reinforced ZK61 magnesium alloy composites prepared by spark plasma sintering
  8. Solidification microstructures of Cu–Zr–Al–Y BMG produced by casting in a wedge-shaped copper mold
  9. Energy spectrum analysis of anodic oxidation film surface–interface on 7475 aluminum alloy after salt spray corrosion
  10. Fabrication of Ni/SiC composite powder by mechanical alloying and its effects on properties of copper matrix composites
  11. The sintering behavior and physical properties of Li2CO3-doped Bi0.5(Na0.8K0.2)0.5TiO3 lead-free ceramics
  12. The effect of heating rate on the microstructural breakdown required for thixoformability
  13. Nano-particles in powder injection molding of an aluminum matrix composite: Rheological behavior, production and properties
  14. Short Communications
  15. Preparation of vaterite CaCO3 microspheres by fast precipitation method
  16. Slag corrosion resistance of Al4SiC4
  17. DGM News
  18. DGM News
https://doi.org/10.3139/146.017034

Articles in the same Issue

  1. Contents
  2. Contents
  3. Original Contributions
  4. Effect of grain defects on the mechanical behavior of nickel-based single crystal superalloy
  5. Evolution of mechanical properties and microstructure of differently cryogenically treated hot die steel AISI–H13
  6. Microstructure and mechanical properties of nickel particle reinforced magnesium composite: impact of reinforcement introduction method
  7. Microstructure and mechanical properties of carbon nanotube-reinforced ZK61 magnesium alloy composites prepared by spark plasma sintering
  8. Solidification microstructures of Cu–Zr–Al–Y BMG produced by casting in a wedge-shaped copper mold
  9. Energy spectrum analysis of anodic oxidation film surface–interface on 7475 aluminum alloy after salt spray corrosion
  10. Fabrication of Ni/SiC composite powder by mechanical alloying and its effects on properties of copper matrix composites
  11. The sintering behavior and physical properties of Li2CO3-doped Bi0.5(Na0.8K0.2)0.5TiO3 lead-free ceramics
  12. The effect of heating rate on the microstructural breakdown required for thixoformability
  13. Nano-particles in powder injection molding of an aluminum matrix composite: Rheological behavior, production and properties
  14. Short Communications
  15. Preparation of vaterite CaCO3 microspheres by fast precipitation method
  16. Slag corrosion resistance of Al4SiC4
  17. DGM News
  18. DGM News
Downloaded on 14.4.2026 from https://www.degruyterbrill.com/document/doi/10.3139/146.017034/html
Scroll to top button