Startseite An electrochemical route to prepare planar 204Tl sources for the calibration of beta surface contamination monitors
Artikel
Lizenziert
Nicht lizenziert Erfordert eine Authentifizierung

An electrochemical route to prepare planar 204Tl sources for the calibration of beta surface contamination monitors

  • Shyamala S. Gandhi , Manoj Kumar , Rubel Chakravarty , J. Nuwad , J. Udhayakumar und Ashutosh Dash
Veröffentlicht/Copyright: 22. April 2013
Radiochimica Acta
Aus der Zeitschrift Band 101 Heft 7

Abstract

This paper describes the utility of the electrochemical technique for the preparation of a circular planar 204Tl source required for the calibration of beta surface contamination monitors. The electrolytic cell, the experimental set up used and the process of deposition are described. The factors that influence the electrodeposition of 204Tl onto the circular copper substrate were investigated and a careful control has been exercised to ensure an optimum deposition of the 204Tl activity onto the substrate. The morphology of the deposited layer was examined by SEM, AFM and EDS analyses. Sources containing ∼3.7 MBq (∼0.1 mCi) 204Tl on a copper sheet of 20 mm diameter working area were prepared and housed in a holder. Quality control tests on the leachability, distribution of activity and stability of the source were performed to ensure compliance with regulatory safety requirements.


* Correspondence address: Bhabha Atomic Research Centre, Radiopharmaceuticals Division, Trombay, Mumbai-400 085, Indien,

Published Online: 2013-04-22
Published in Print: 2013-07

© by Oldenbourg Wissenschaftsverlag, München, Germany

Heruntergeladen am 20.10.2025 von https://www.degruyterbrill.com/document/doi/10.1524/ract.2013.2039/html
Button zum nach oben scrollen