Effect of the Axial Spacing between Vanes and Blades on a Transonic Gas Turbine Performance and Blade Loading

Dongil Chang; Stavros Tavoularis

doi:10.1515/tjj-2012-0038

Article

Requires Authentication

Effect of the Axial Spacing between Vanes and Blades on a Transonic Gas Turbine Performance and Blade Loading

Dongil Chang
Dongil Chang
Department of Mechanical Engineering, University of Ottawa, Ottawa, Ontario, K1N 6N5 Canada

Search for this author in:

De Gruyter De Gruyter Brill | Google Scholar
and Stavros Tavoularis
Stavros Tavoularis

Email author

Search for this author in:

De Gruyter De Gruyter Brill | Google Scholar

Published/Copyright: March 13, 2013

Purchase Article

$42.00

Published by

Become an author with De Gruyter Brill

Author Information

From the journal Int. J. Turbo Jet-Engines Volume 30 Issue 1

Abstract

Unsteady numerical simulations have been conducted to investigate the effect of axial spacing between the stator vanes and the rotor blades on the performance of a transonic, single-stage, high-pressure, axial turbine. Three cases were considered, the normal case, which is based on the geometry of a commercial jet engine and has an axial spacing at 50% blade span equal to 42% of the vane axial chord, as well as two other cases with axial spacings equal to 31 and 52% vane axial chords, respectively. Present interest has focused on the effect of axial gap size on the instantaneous and time-averaged flows as well as on the blade loading and the turbine performance. Decreasing the gap size reduced the pressure and increased the Mach number in the core flows in the gap region. However, the flows near the two endwalls did not follow monotonic trends with the gap size change; instead, the Mach numbers for both the small gap and the large gap cases were lower than that for the normal case. This Mach number decrease was attributed to increased turbulence due to the increased wake strength for the small gap case and an increased wake width for the large gap case. In all considered cases, large pressure fluctuations were observed in the front region of the blade suction side. These pressure fluctuations were strongest for the smaller spacing. The turbine efficiencies of the cases with the larger and smaller spacings were essentially the same, but both were lower than that of the normal case. The stator loss for the smaller spacing case was lower than the one for the larger spacing case, whereas the opposite was true for the rotor loss.

Keywords: high-pressure turbine; axial spacing; CFD

Department of Mechanical Engineering, University of Ottawa, Ottawa, Ontario, K1N 6N5 Canada

Received: 2012-11-19

Accepted: 2013-01-06

Published Online: 2013-03-13

Published in Print: 2013-03-22

©[2013] by Walter de Gruyter Berlin Boston

You are currently not able to access this content.

Not sure if you should have access? Please log in using an institutional account to see if you have access to view or download this content.

Purchase Article

$42.00

You are currently not able to access this content.