Frontmatter

Articles in the same Issue

1. Frontmatter
2. Original articles
3. Antistatic surface properties of plastics using donor-accepter molecular compounding antistatic agent
4. Rheological properties and crystallization behaviors of long chain branched polyethylene prepared by melt branching reaction
5. An investigation into the structure and morphology of polyamide 6/polyaniline hybrid fibers
6. Natural rubber/tetra-needle-like zinc oxide whisker composites: their preparation and characterization
7. Fabrication of short glass fiber reinforced phenol-formaldehyde-lignin and polyurethane-based composite foam: mechanical, friability, and shape memory studies
8. Effect of the particle diameter of the chemical foaming agent on the foaming process and the cellular structure of one-shot compression molded polyethylene foams
9. Recycling waste tire rubber by water jet pulverization: powder characteristics and reinforcing performance in natural rubber composites
10. Monitoring of the injection and holding phases by using a modular injection mold
11. Influence of mold temperature and process time on the degree of cure of epoxy-based materials for thermoset injection molding and prepreg compression molding
12. Calendering of non-isothermal Rabinowitsch fluid
13. Simulation of dynamic gas penetrations on fingering behaviors during gas-assisted injection molding