Heat Transfer during Steaming of Bread
-
Victoria K. Ananingsih
Abstract
Understanding of heat transfer during steaming is important to optimize the processing of steamed bread and to produce desired qualities in the final product. Physicochemical changes occur during steaming of the dough which might be impacted upon by the heat transfer system. In this study, a mathematical model was developed to describe the heat transfer system in the bread being steaming throughout the heating process. The Forward Euler method was employed for solving the three-dimensional partial differential equation set for heat transfer to produce temperature profiles at a number of individual locations in the steamed bread during its steaming. All the comparisons between the model-predicted values and the experimental results produced root mean square error values ranged from 1.391 to 3.545 and R2 values of all greater than 0.93. Therefore, it is confirmed that the model has a good performance and can be used to predict temperature profiles in the bread during steaming.
Acknowledgements
Financial supports from Singapore Ministry of Education through Academic Research Fund Tier 1 grant R-143-000-404-112 and the National University of Singapore (Suzhou) Research Institute under the grant number NUSRI2011-007 are acknowledged. The first author is grateful to the financial support from the Directorate General of Indonesian Higher Education in sponsoring her PhD study.
References
1. HuangS, BetkerS, QuailK, MossR. An optimized processing procedure by response surface methodology (RSM) for northern-style Chinese steamed bread. J Cereal Sci1993;18:89–102.10.1006/jcrs.1993.1037Suche in Google Scholar
2. CarvalhoMG, MartinsN. Mathematical modeling of heat and mass transfer in a forced convection baking oven. In: VolintineBG, editor. AIChE symposium series-heat transfer.San Diego, CA, 1992:205–11.Suche in Google Scholar
3. SimpsonR, AbakarovA. Thermal food processing optimization: single and multi-objective optimization case studies. In: AhmedJ, RahmanMS, editors. Handbookof food process design. Oxford: Wiley-Blackwell,2012:167–89.Suche in Google Scholar
4. PaulusKO. Cooking kinetics: models and knowledge. In: ZenthenP, editor. Thermal processing and quality of foods. London: Elsevier Applied Science, 1984:304–12.Suche in Google Scholar
5. SablaniSS, MarcotteM, BaikOD, CastaigneF. Modeling of simultaneous heat and water transport in the baking process. Lebensm Wiss Technol1998;31:201–9.10.1006/fstl.1997.0360Suche in Google Scholar
6. TherdthaiN, ZhouW, AdamczakT. Two-dimensional CFD modelling and simulation of an industrial continuous bread baking oven. J Food Eng2007;60:211–17.10.1016/S0260-8774(03)00043-8Suche in Google Scholar
7. WongSY, ZhouW, HuaJS. CFD modeling of an industrial continuous bread-baking process involving U-movement. J Food Eng2007;78:888–96.10.1016/j.jfoodeng.2005.11.033Suche in Google Scholar
8. ZhouW. Baking process: mathematical modeling and analysis. In: FaridMM, editor. Mathematical modeling of food processing. Boca Raton, FL: CRC Press, Taylor & Francis Group, 2010:357–372).Suche in Google Scholar
9. BaikOD, MarcotteM, SablaniSS, CastaigneF. Thermal and physical properties of bakery products. Crit Rev Food Sci Nutr2001;41:321–52.10.1080/20014091091832Suche in Google Scholar
10. MarcotteM. Heat and mass transfer during baking. In: YanniotisS, SundenB, editors. Heat transfer in food processing. Southampton and Boston, MA: WIT Press, 2007.Suche in Google Scholar
11. ZunigaR, Le-BailA. Assessment of thermal conductivity as a function of porosity in bread dough during proving. Food Bioproducts Process2009;87:17–22.10.1016/j.fbp.2008.04.002Suche in Google Scholar
12. HouGG, PopperL. Chinese steamed bread. In: PopperL, SchäferW, FreundW, editors. Future of flour: a compendium of flour improvement. Germany: Mühlenchemie, 2006.Suche in Google Scholar
13. FeyissaAH, GernaeyKV, Adler-NissenJ. Uncertainty and sensitivity analysis: mathematical model of coupled heat and mass transfer for a contact baking process. J Food Eng2011;109:281–90.10.1016/j.jfoodeng.2011.09.012Suche in Google Scholar
14. Sakin-YilmazerM, KemerliT, IslerogluH, OzdestanO, GuvenG, UrenA, et al. Baking kinetics of muffins in convection and steam assisted hybrid ovens. J Food Eng2013;119:483–9.10.1016/j.jfoodeng.2013.06.019Suche in Google Scholar
15. AOAC. In: CunniffP, editor. Official methods of analysis of AOAC international, 60th ed. Maryland: AOAC International, 1996.Suche in Google Scholar
16. HamdamiN, MonteauJ-Y, Le BailA. Moisture diffusivity and water activity of frozen part baked bread. Int J Food Sci Technol2003;41:33–44.10.1111/j.1365-2621.2005.00984.xSuche in Google Scholar
17. ZanoniB, PeriC, GianottiR. Determination of the thermal diffusivity of bread as a function of porosity. J Food Eng1995;26:497–510.10.1016/0260-8774(94)00073-ISuche in Google Scholar
18. UnklesbayN, UnklesbayK, NahaisiM, KrauseG. Thermal conductivity of white bread during convective heat processing. J Food Sci1981;47:249–53 & 259.10.1111/j.1365-2621.1982.tb11071.xSuche in Google Scholar
©2014 by De Gruyter
Artikel in diesem Heft
- Frontmatter
- Selected Papers from MAS2013 Workshop
- Special section “Selected Papers from the Workshop on Modeling and Simulation of Food Processing and Operations of the MAS 2013 Conference (Athens, September 25–27, 2013)”
- Safety and Security in Fresh Good Supply Chain
- Performance Analysis of the Water Supply System of a Dairy Company by Means of an Advanced Simulation Tool
- Optimal Design of an Olive Oil Mill by Means of the Simulation of a Petri Net Model
- Original Research Articles
- Moisture Sorption Isotherms, Isosteric Heat of Sorption and Glass Transition Temperature of Murtilla (Ugni molinae T.) Berry
- Salt and Acid-Induced Soft Tofu-Type Gels: Rheology, Structure and Fractal Analysis of Viscoelastic Properties as a Function of Coagulant Concentration
- Heat Transfer during Steaming of Bread
- Kinetics and Thermodynamics of Gum Extraction from Wild Sage Seed
- Formation and Stability of Vitamin E Enriched Nanoemulsions Stabilized by Octenyl Succinic Anhydride Modified Starch
- Investigation on a Soft Tubular Model Reactor Based on Bionics of Small Intestine – Residence Time Distribution
- Comparison of Physicochemical and Gel Characteristics of Hydroxypropylated Oat and Wheat Starches
- Environomical Analysis and Mathematical Modelling for Tomato Flakes Drying in a Modified Greenhouse Dryer under Active Mode
- Extraction Kinetics and Properties of Proanthocyanidins from Pomegranate Peel
- An Investigation of Energy Consumption, Solar Fraction and Hybrid Photovoltaic–Thermal Solar Dryer Parameters in Drying of Chamomile Flower
- The Adsorption of Undesirable Impurities from Sunflower Oil on the Granulated Sorbents Based on Kaolin Clay
- “Bare” or “Gloved” Hands: A Study on the Production of Safe Food
- Physicochemical Characterization of Arrowroot Starch (Maranta arundinacea Linn) and Glycerol/Arrowroot Starch Membranes
- Optimization of Gluten-Free Cake Prepared from Chestnut Flour and Transglutaminase: Response Surface Methodology Approach
- Estimation of Equilibrium Moisture Content of Pistachio Powder through the ANN and GA Approaches
- Modeling of Furfural and 5-Hydroxymethylfurfural Content of Fermented Lotus Root: Artificial Neural Networks and a Genetic Algorithm Approach
- Physicochemical Properties of Chilled Abalone as Influenced by Washing Pretreatment in Citric Acid Combined with High Pressure Processing
- Synergetic Effects of Pulsed Electric Field and Ozone Treatments on the Degradation of High Molecular Weight Chitosan
- Physical, Thermal and Water-Sorption Properties of Passion Fruit Seeds
- Hydrolysis of Hazelnut Shells as a Carbon Source for Bioprocessing Applications and Fermentation
- Variations in Main Flavor Compounds of Freshly Distilled Brandy during the Second Distillation
- Characterization and Semiquantitative Analysis of Volatile Compounds in Six Varieties of Sugarcane Juice
- Influence of Citric Acid Pretreatment on Drying of Peach Slices
- Degradation Kinetics of Bioactive Compounds and Antioxidant Activity of Pomegranate Arils during the Drying Process
- Short Communications
- Effect of Sucrose Addition on Rheological and Thermal Properties of Rice Starch–Gum Mixtures
- Effect of Pulsed Electric Field on Freeze-Drying of Potato Tissue
Artikel in diesem Heft
- Frontmatter
- Selected Papers from MAS2013 Workshop
- Special section “Selected Papers from the Workshop on Modeling and Simulation of Food Processing and Operations of the MAS 2013 Conference (Athens, September 25–27, 2013)”
- Safety and Security in Fresh Good Supply Chain
- Performance Analysis of the Water Supply System of a Dairy Company by Means of an Advanced Simulation Tool
- Optimal Design of an Olive Oil Mill by Means of the Simulation of a Petri Net Model
- Original Research Articles
- Moisture Sorption Isotherms, Isosteric Heat of Sorption and Glass Transition Temperature of Murtilla (Ugni molinae T.) Berry
- Salt and Acid-Induced Soft Tofu-Type Gels: Rheology, Structure and Fractal Analysis of Viscoelastic Properties as a Function of Coagulant Concentration
- Heat Transfer during Steaming of Bread
- Kinetics and Thermodynamics of Gum Extraction from Wild Sage Seed
- Formation and Stability of Vitamin E Enriched Nanoemulsions Stabilized by Octenyl Succinic Anhydride Modified Starch
- Investigation on a Soft Tubular Model Reactor Based on Bionics of Small Intestine – Residence Time Distribution
- Comparison of Physicochemical and Gel Characteristics of Hydroxypropylated Oat and Wheat Starches
- Environomical Analysis and Mathematical Modelling for Tomato Flakes Drying in a Modified Greenhouse Dryer under Active Mode
- Extraction Kinetics and Properties of Proanthocyanidins from Pomegranate Peel
- An Investigation of Energy Consumption, Solar Fraction and Hybrid Photovoltaic–Thermal Solar Dryer Parameters in Drying of Chamomile Flower
- The Adsorption of Undesirable Impurities from Sunflower Oil on the Granulated Sorbents Based on Kaolin Clay
- “Bare” or “Gloved” Hands: A Study on the Production of Safe Food
- Physicochemical Characterization of Arrowroot Starch (Maranta arundinacea Linn) and Glycerol/Arrowroot Starch Membranes
- Optimization of Gluten-Free Cake Prepared from Chestnut Flour and Transglutaminase: Response Surface Methodology Approach
- Estimation of Equilibrium Moisture Content of Pistachio Powder through the ANN and GA Approaches
- Modeling of Furfural and 5-Hydroxymethylfurfural Content of Fermented Lotus Root: Artificial Neural Networks and a Genetic Algorithm Approach
- Physicochemical Properties of Chilled Abalone as Influenced by Washing Pretreatment in Citric Acid Combined with High Pressure Processing
- Synergetic Effects of Pulsed Electric Field and Ozone Treatments on the Degradation of High Molecular Weight Chitosan
- Physical, Thermal and Water-Sorption Properties of Passion Fruit Seeds
- Hydrolysis of Hazelnut Shells as a Carbon Source for Bioprocessing Applications and Fermentation
- Variations in Main Flavor Compounds of Freshly Distilled Brandy during the Second Distillation
- Characterization and Semiquantitative Analysis of Volatile Compounds in Six Varieties of Sugarcane Juice
- Influence of Citric Acid Pretreatment on Drying of Peach Slices
- Degradation Kinetics of Bioactive Compounds and Antioxidant Activity of Pomegranate Arils during the Drying Process
- Short Communications
- Effect of Sucrose Addition on Rheological and Thermal Properties of Rice Starch–Gum Mixtures
- Effect of Pulsed Electric Field on Freeze-Drying of Potato Tissue
