Article
Publicly Available
Frontmatter
Published/Copyright:
September 2, 2016
Published Online: 2016-9-2
Published in Print: 2016-9-1
© 2016 by De Gruyter
Articles in the same Issue
- Frontmatter
- Short Communication
- Microscale Interface Synthesis of Ni-B Amorphous Nanoparticles from NiSO4 by Sodium Borohydride Reduction in Microreactor
- Research Articles
- The Effect of Post-heat Treatment on the Microstructures of Single Crystal DD6 Superalloy
- Changes in the Material Properties of Steel 1.4762 Depending on the Temperature
- Formation of Ti5Si3 by Combustion Synthesis in a Self-Propagating Mode: Experimental Study and Numerical Simulation
- Effect of Processing Parameters on Plasma Jet and In-flight Particles Characters in Supersonic Plasma Spraying
- Crystallization Behavior and Growing Process of Rutile Crystals in Ti-Bearing Blast Furnace Slag
- Evaluation of Anticorrosion Performance of New Materials for Alternative Superheater Tubes in Biomass Power Plants
- Investigation on Burden Particle Softening and Melting Process under High Reduction Potential Condition
- Application of response surface methodology for optimization of parameters for microwave heating of rare earth carbonates
- Interfacial Evolution of Cement and Steel in CO2 Dissolved Solution Under High Temperature and High Pressure
- Study of Dissolution Process of Solid Cu in Liquid Al
- The Pin-Loaded Small One-Bar Specimen in Use to Determine Uniaxial and Multiaxial Creep Data
- Vertical Compensation Friction Stir Welding of 6061-T6 Aluminum Alloy
Articles in the same Issue
- Frontmatter
- Short Communication
- Microscale Interface Synthesis of Ni-B Amorphous Nanoparticles from NiSO4 by Sodium Borohydride Reduction in Microreactor
- Research Articles
- The Effect of Post-heat Treatment on the Microstructures of Single Crystal DD6 Superalloy
- Changes in the Material Properties of Steel 1.4762 Depending on the Temperature
- Formation of Ti5Si3 by Combustion Synthesis in a Self-Propagating Mode: Experimental Study and Numerical Simulation
- Effect of Processing Parameters on Plasma Jet and In-flight Particles Characters in Supersonic Plasma Spraying
- Crystallization Behavior and Growing Process of Rutile Crystals in Ti-Bearing Blast Furnace Slag
- Evaluation of Anticorrosion Performance of New Materials for Alternative Superheater Tubes in Biomass Power Plants
- Investigation on Burden Particle Softening and Melting Process under High Reduction Potential Condition
- Application of response surface methodology for optimization of parameters for microwave heating of rare earth carbonates
- Interfacial Evolution of Cement and Steel in CO2 Dissolved Solution Under High Temperature and High Pressure
- Study of Dissolution Process of Solid Cu in Liquid Al
- The Pin-Loaded Small One-Bar Specimen in Use to Determine Uniaxial and Multiaxial Creep Data
- Vertical Compensation Friction Stir Welding of 6061-T6 Aluminum Alloy