A 156 GHz high-power doubler-embedded cross-coupled local oscillator in 55 nm CMOS technology
-
Shenghui Yang
Abstract
The driving power of the local oscillator (LO) determines whether the mixers can work in an optimal state. Implementing high-power LO sources is challenging for transceivers in the terahertz band beyond 100 GHz. In this paper, a cross-coupled oscillator based on Cascode amplifiers is proposed. Using the principle of current-reuse, a high-power doubler-embedded cross-coupled local oscillator is designed by combing a frequency doubler and a cross-coupled oscillator. The circuit is processed by 55-nm CMOS technology. With a supply voltage of 1.6 V, the output power reaches −1.3 dBm at 156 GHz, and the DC-to-RF efficiency is 2.1%. In addition, this local oscillator has been used in an up-conversion mixer.
Funding source: National Key Research and Development Program of China
Award Identifier / Grant number: 2016YFA0202200
Acknowledgments
This work was supported by the National Key Research and Development Program of China under Grant 2016YFA0202200.
-
Author contributions: All the authors have accepted responsibility for the entire content of this submitted manuscript and approved submission.
-
Research funding: None declared.
-
Conflict of interest statement: The authors declare no conflicts of interest regarding this article.
References
[1] D. Reiter, H. Li, B. Sene, et al., “A low-noise W-band receiver in a 28-nm CMOS technology,” IEEE Microw. Wireless Compon. Lett., vol. 32, no. 5, pp. 406–409, 2021. https://doi.org/10.1109/lmwc.2021.3125896.Suche in Google Scholar
[2] T. Heller, E. Cohen, and E. Socher, “A 102–129-GHz 39-dB gain 8.4-dB noise figure I/Q receiver frontend in 28-nm CMOS,” IEEE Trans. Microw. Theor. Tech., vol. 64, no. 5, pp. 1535–1543, 2016, https://doi.org/10.1109/tmtt.2016.2547390.Suche in Google Scholar
[3] F. Ellinger, D. Fritsche, G. Tretter, et al.., “Review of millimeter-wave integrated circuits with low power consumption for high speed wireless communications,” Frequenz, vol. 71, nos. 1–2, pp. 1–9, 2017, https://doi.org/10.1515/freq-2016-0119.Suche in Google Scholar
[4] Y. S. Lin, G. H. Li, and N. Van Hieu, “A 75–85 GHz down-conversion mixer with integrated M archand baluns in 90 nm CMOS with excellent matching and port-to-port isolation for automotive radars,” Microw. Opt. Technol. Lett., vol. 57, no. 1, pp. 73–81, 2015, https://doi.org/10.1002/mop.28774.Suche in Google Scholar
[5] D. Pan, Z. Duan, L. Huang, et al.., “Design of high-linearity 75–90 GHz CMOS down-conversion mixer for automotive radar,” Analog Integr. Circuits Signal Process., vol. 97, no. 2, pp. 313–322, 2018, https://doi.org/10.1007/s10470-018-1247-9.Suche in Google Scholar
[6] J. Kim and Y. Kwon, “Low conversion loss 94 GHz CMOS resistive mixer,” Electron. Lett., vol. 51, no. 18, pp. 1464–1466, 2015, https://doi.org/10.1049/el.2015.1035.Suche in Google Scholar
[7] K. S. Choi, D. W. Park, D. R. Utomo, et al.., “500 GHz CMOS heterodyne imager adopting fourth subharmonic passive mixer,” Microw. Opt. Technol. Lett., vol. 62, no. 2, pp. 683–687, 2020, https://doi.org/10.1002/mop.32099.Suche in Google Scholar
[8] C. Deng, H. Q. Yang, and M. Gong, “30–43 GHz cascode Sub-harmonic mixer in 0.13-μm CMOS technology,” IEICE Electron. Express, vol. 15, p. 20180793, 2018.10.1587/elex.15.20180793Suche in Google Scholar
[9] D. Parveg, M. Varonen, A. Safaripour, et al.., “An mm-wave CMOS I–Q subharmonic resistive mixer for wideband zero-IF receivers,” IEEE Microw. Wireless Compon. Lett., vol. 30, no. 5, pp. 520–523, 2020, https://doi.org/10.1109/lmwc.2020.2980973.Suche in Google Scholar
[10]] F. Zhu and G. Q. Luo, “A millimeter-wave fundamental and subharmonic hybrid CMOS mixer for dual-band applications,” Int. J. Microw. Wireless Technol., vol. 13, no. 5, pp. 424–429, 2021, https://doi.org/10.1017/s1759078720001270.Suche in Google Scholar
[11] X. Meng, B. Chi, and Z. Wang, “An 110 GHz CMOS colpitts VCO based on switched coupled-inductor,” Analog Integr. Circuits Signal Process., vol. 86, no. 1, pp. 115–120, 2016, https://doi.org/10.1007/s10470-015-0646-4.Suche in Google Scholar
[12] M. Azadmehr, I. Paprotny, and L. Marchetti, “100 years of colpitts oscillators: ontology review of common oscillator circuit topologies,” IEEE Circ. Syst. Mag., vol. 20, no. 4, pp. 8–27, 2020, https://doi.org/10.1109/mcas.2020.3027334.Suche in Google Scholar
[13] C. L. S. Hsieh and J. Y. C. Liu, “A low phase noise 210-GHz triple-push ring oscillator in 90-nm CMOS,” IEEE Trans. Microw. Theor. Tech., vol. 66, no. 4, pp. 1983–1997, 2018, https://doi.org/10.1109/tmtt.2018.2791408.Suche in Google Scholar
[14] S. Kim, D. Yoon, and J. S. A. Rieh, “270-GHz CMOS triple-push ring oscillator with a coupled-line matching network,” IEEE Trans. Terahertz Sci. Technol., vol. 9, no. 5, pp. 449–462, 2019, https://doi.org/10.1109/tthz.2019.2923556.Suche in Google Scholar
[15] D. Kim and J. S. Rieh, “Comparison of two layout options for 110-GHz CMOS LC cross-coupled oscillators,” J. Electromagn. Eng. Sci., vol. 18, no. 2, pp. 141–143, 2018, https://doi.org/10.26866/jees.2018.18.2.141.Suche in Google Scholar
[16] A. Ferschischi, H. Ghaleb, M. Schulz, et al.., “Nonlinear analysis of cross-coupled super-regenerative oscillators,” IEEE Trans. Circ. Syst. I: Regul. Pap., vol. 68, no. 6, pp. 2368–2381, 2021, https://doi.org/10.1109/tcsi.2021.3070157.Suche in Google Scholar
[17] J. C. Huang, S. Wang, and T. Y. Tsai, “An 80–100 GHz VCO using auxiliary cross-coupled pair and push-push topology in 0.18-μm CMOS,” Microw. Opt. Technol. Lett., vol. 61, no. 1, pp. 235–238, 2019, https://doi.org/10.1002/mop.31520.Suche in Google Scholar
[18] X. Meng, B. Chi, and Z. Wang, “CMOS cross-coupled oscillator operating close to the transistor’s fmax,” IEEE Microw. Wireless Compon. Lett., vol. 27, no. 12, pp. 1131–1133, 2017, https://doi.org/10.1109/lmwc.2017.2752965.Suche in Google Scholar
[19] S. Yang, “Analysis of high frequency behaviors of the self-biased TIA stage and implementation of an up-conversion mixer in millimeter-wave/terahertz band,” IEICE Electron. Express, vol. 19, p. 20210562, 2022.10.1587/elex.19.20210562Suche in Google Scholar
[20] R. Kananizadeh and O. A. Momeni, “A 190-GHz VCO with 20.7% tuning range employing an active mode switching block in a 130 nm SiGe BiCMOS,” IEEE J. Solid State Circ., vol. 52, no. 8, pp. 2094–2104, 2017, https://doi.org/10.1109/jssc.2017.2689031.Suche in Google Scholar
[21] Y. Shu, H. J. Qian, and X. A. Luo, “A 169.6-GHz low phase noise and wideband hybrid mode-switching push–push oscillator,” IEEE Trans. Microw. Theor. Tech., vol. 67, no. 7, pp. 2769–2781, 2019, https://doi.org/10.1109/tmtt.2019.2913642.Suche in Google Scholar
[22] P. Y. Chiang, O. Momeni, and P. A. Heydari, “A 200-GHz inductively tuned VCO with-7-dBm output power in 130-nm SiGe BiCMOS,” IEEE Trans. Microw. Theor. Tech., vol. 61, no. 10, pp. 3666–3673, 2013, https://doi.org/10.1109/tmtt.2013.2279779.Suche in Google Scholar
[23] Y. Shu, H. J. Qian, and X. Luo, “A 173 GHz transformer-based push-push oscillator with 11.2% tuning range in 28nm CMOS,” in 2018 IEEE MTT-S International Wireless Symposium (IWS), Chengdu, China, IEEE, 2018, pp. 1–4.10.1109/IEEE-IWS.2018.8400867Suche in Google Scholar
[24] H. Koo, C. Y. Kim, and S. Hong, “Design and analysis of 239 GHz CMOS push-push transformer-based VCO with high efficiency and wide tuning range,” IEEE Trans. Circ. Syst. I: Regul. Pap., vol. 62, no. 7, pp. 1883–1893, 2015, https://doi.org/10.1109/tcsi.2015.2426957.Suche in Google Scholar
© 2022 Walter de Gruyter GmbH, Berlin/Boston
Artikel in diesem Heft
- Frontmatter
- Research Articles
- Coaxial resonant cavity for measuring complex permittivity of liquids
- Analysis of quad-band polarization- and incident-angle independent low profile metamaterial absorber
- Radiation pressure of a hybrid bianisotropic chiral structure
- Improving the automatic target recognition algorithm’s accuracy through an examination of the different time-frequency representations and data augmentation
- On the effect of array size on the radar cross section reduction bandwidth of checkerboard metasurfaces
- Analysis and synthesis of L- and T-shaped flexible compact microstrip antennas using regression-based machine learning approaches
- Novel implantable antenna with miniaturized footprint size for wideband biomedical telemetry applications
- Circular shape monopole antenna with modified ground plane proclaiming SWB characteristics
- Miniaturized wideband implantable slotted loop antenna for biotelemetry applications
- A 156 GHz high-power doubler-embedded cross-coupled local oscillator in 55 nm CMOS technology
Artikel in diesem Heft
- Frontmatter
- Research Articles
- Coaxial resonant cavity for measuring complex permittivity of liquids
- Analysis of quad-band polarization- and incident-angle independent low profile metamaterial absorber
- Radiation pressure of a hybrid bianisotropic chiral structure
- Improving the automatic target recognition algorithm’s accuracy through an examination of the different time-frequency representations and data augmentation
- On the effect of array size on the radar cross section reduction bandwidth of checkerboard metasurfaces
- Analysis and synthesis of L- and T-shaped flexible compact microstrip antennas using regression-based machine learning approaches
- Novel implantable antenna with miniaturized footprint size for wideband biomedical telemetry applications
- Circular shape monopole antenna with modified ground plane proclaiming SWB characteristics
- Miniaturized wideband implantable slotted loop antenna for biotelemetry applications
- A 156 GHz high-power doubler-embedded cross-coupled local oscillator in 55 nm CMOS technology
